METHVEN Kaha 01-7003 Manuel utilisateur

Methven Australia Pty Ltd

ABN 15 104 813 390

Melbourne, Australia

www.methven.com

JUNE 2011 MA017003

Kaha Swivel Basin Mixer

01-7003

Use of this product in non-domestic applications voids warranty.

All pipe work must be thoroughly ﬂushed prior to the installation of the mixer.

NEFA inline ﬁlters must be installed on both hot and cold supplies.

Do not remove the ceramic cartridge from the mixer when installing.

Damage caused by hydrostatic testing is not covered by our warranty.

IMPORTANT

Please read all of the instructions before installation

Installation Guide

Illustration may not reﬂect actual product shape.

SPEC 001

Stream shaper

O-ring (remove if ﬁtting

base ring)

Mounting stud

Mounting gasket

Mounting plate

Mounting nut

Flexible inlet hose:

cold

hot

Outlet

Position studs

at right angle

to outlet

The maximum working pressure of the ceramic cartridge is 1000kPa. Do not

hydrostatic test the installation with this mixer installed. Damage to the ceramic

cartridge may occur, voiding our warranty.

“In situ” testing

CMY

01-0011 Kaha Basin Mixer.pdf 1 16/05/11 10:06 AM

We recommend that this product is installed by a licensed plumber.

THE METHVEN GUARANTEE

The warranty statement shall apply to all tapware & showers supplied by Methven

For more information visit www.methven.com

THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia

Technical Speciﬁcations Installation

Hose Requirements for mixers

The maximum working pressure of the ceramic cartridge is 1000kPa.

Do not hydrostatic test the installation with this mixer installed. Damage to

the ceramic cartridge may occur.

1. A single 35mm diameter hole is required in the mounting surface. The mounting

surface can be a maximum of 40mm thick.

2. Screw the threaded studs into the base of the mixer. Insert the O ring into

the groove in the bottom of the base ring and ﬁt the base ring to the bottom

of the mixer.

NOTE: Base ring use is optional and should be used when required to ensure a seal

is achieved between the tap and basin. If ﬁtting base ring please remove the o-ring

from the base of the tap body.

3. Insert the ﬂexible hoses through the hole in the mounting surface

(from the underside) and screw them into the base of the mixer.

4. Feed the threaded studs through the hole in the mounting surface.

5. Ensure the 2 threaded studs are located at the rear of the mixer at right angle

to the outlet.

Fit the mounting gasket and mounting plate onto the threaded rods.

6. Tighten the mounting nuts to secure the mixer in place.

7. Connect the ﬂexible hoses to the hot and cold supplies (hot on the left,

cold on the right). It is a condition of our warranty that the ﬁlter washers as

supplied be ﬁtted at this connection.

Inlet Connections: All ½" BSP

Operating Pressure: 150kPa - 500kPa

Operating Temperatures: Recommended hot water supply 50°C,

maximum 70°C. AS 3500 requires all hot

water supplies to any sanitary ﬁtting to be

tempered to 50°C.

R35mm Min

20mm

DO NOT CRUSH

HOSE OR SWAGED ENDS

CORRECT

INCORRECT

DO NOT STRETCH OR TWIST HOSES

CMY

01-0011 Kaha Basin Mixer.pdf 1 16/05/11 10:18 AM

Autres manuels METHVEN Produits de plomberie

METHVEN

METHVEN WAIPORI BASIN MIXER Manuel utilisateur

METHVEN

METHVEN Kiri 01-5054 Manuel utilisateur

METHVEN

METHVEN KIRI Manuel utilisateur

METHVEN

METHVEN AROHA Manuel utilisateur

METHVEN

METHVEN Maku SatinJet Slide Rail Shower Manuel utilisateur

METHVEN

METHVEN Aroha Manuel utilisateur

METHVEN

METHVEN KIRI MK2 Manuel utilisateur

METHVEN

METHVEN SATINJET Kaha Manuel utilisateur

METHVEN

METHVEN 01-2053 Manuel utilisateur

METHVEN

METHVEN MAKU Manuel utilisateur

METHVEN

METHVEN Promix Instructions de montage

METHVEN

METHVEN KAHA EKIT08/KH Manuel utilisateur

METHVEN

METHVEN KIRI SATINJET 13-7602 Manuel utilisateur

METHVEN

METHVEN AURAJET HANDSET Manuel utilisateur

METHVEN

METHVEN Kiri 3 Hole Wall Faucet Manuel utilisateur

METHVEN

METHVEN FLEXISPRAY Manuel utilisateur

METHVEN

METHVEN Kaha 01-7409 Manuel utilisateur

METHVEN

METHVEN Wai Instructions d'utilisation

METHVEN

METHVEN Maku 01-8567 Manuel utilisateur

METHVEN

METHVEN Deva DLT095 Manuel utilisateur

METHVEN

METHVEN 01-2138 Instructions d'utilisation et d'entretien

METHVEN

METHVEN MK2 Manuel utilisateur

METHVEN

METHVEN TUROA Manuel utilisateur

METHVEN

METHVEN Kiri K1MSK Instructions d'utilisation

Manuels Produits de plomberie populaires d'autres marques

Weka

Weka 506.2020.00E Mode d'emploi

Kohler

Kohler K-6228 Instructions de montage

UBERHAUS DESIGN

UBERHAUS DESIGN 75175017 Manuel utilisateur

American Standard

American Standard DetectLink 6072121 Manuel utilisateur

Uponor

Uponor Contec TS Manuel utilisateur

Pfister

Pfister Selia 49-SL Manuel utilisateur

Fortis

Fortis VITRINA 6068700 Manuel utilisateur

Fortis

Fortis MILANO 78211JS Manuel utilisateur

Kohler

Kohler K-12183 Instructions de montage

Maxxus

Maxxus MX-M206-01 Manuel utilisateur

Moen

Moen 5922 Series Manuel utilisateur

Viega

Viega Prevista Pure 8512 Manuel utilisateur

Kohler

Kohler Centerset K-15240 Instructions de montage

Viega

Viega Prevista Dry 8522.33 Manuel utilisateur

Sanela

Sanela Lema SLP 59RB Manuel utilisateur

Elkay

Elkay EDF15AC Manuel d'installation

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Manuel

baliv

baliv WT-140 Manuel utilisateur