3
Input : 2-#[light stays green for 3 seconds]
01 = 1 minute Time Delay 59 = 59 minute Time Delay
00 = Will turn Time Delay mode off
Example : *-*-1-5-9-#-Master Code-#-03-#
[ This will set the Time Delay period to 3 minutes]
Unsuccessful Change : 5‘Beeps’ [repeat steps 1 - 4]
The Master Code will override the Time Delay
HOW TO OPEN IN TIME DELAY MODE
1
Enter any valid code other than the Master Code
2
Once the code is entered the Time Delay will activate
3
During the Time Delay, codes will not be accepted. When you press any
key, the light will stay orange for 3 seconds
4
The lock will ‘Beep’ continuously & the green light will flash for the last 30
seconds of the Time Delay period
5
Once the continuous ‘Beeps’ stop, the lock will unlock for 5 seconds
6
Turn the handle to open safe
LOW BATTERY WARNING
[ Time to change your batter y]
When you enter your code, a green light & a red light will turn on for
approximately 5 seconds; you will also hear 10 ‘Beeps’. The safe will probably
not unlock when you get this response
When you enter your code, a green light will turn on for approximately 1
second. The safe will not unlock when you get this response
If your keypad has no response [no beeps; no lights]
CHANGING YOUR BATTERIES
1
Locate the battery cover on the bottom
edge of the keypad & remove the cover
by pulling on the tab
2
Carefully & gently remove the 9-V battery
from the compartment
CAUTION : Hold onto battery connector
to avoid pulling wires out of housing.
3
Carefully re-insert the new 9V battery, do not force the batter y into the
compartment
4
The lock will retain all current codes & settings
PG.7
|
MSL-500-P
ELECTRONIC LOCK INSTRUCTIONS
