Information for the installer LSTStyle Wall mounted - suitable with horizontal Precision emiers
MPILH
Installation Procedure:
1. ForTRVcutout positions and LST
locations to suit, contact the Merrio
sales office.
2. Fix endboxes to wall surface as
shown in FIG. ensuring that required
dimensions are adhered to.The centre
of the boom bracket corresponds to
the centre of the intermediate tabs
on the front panel.The boom of
the bracket should be in line with the
boom of the endboxes.
3. Slide boom grille onto endboxes and
fix using the M4 hex socket screws
and grille locking plates provided.
(If boom brackets are required, fix
immediately aer the boom grille is
fixed, see FIG. ).
4. Locate tabs on inside of front panel.
Slide into slots provided in endboxes.
Push the panel into its upright position
and lock in place using M8 nuts and
washers (see FIG. ).
5. Place top grille in position as shown
in FIG. . Lock in place by inserting
M4 hex socket screws through the
keyhole plates in the grille and into the
threaded hole in the endbox.
FIG.
FIG.
FIG.
FIG.
Emier
Height
Case
Height
143mm 350mm
215mm 420mm
288mm 490mm
360mm 560mm
433mm 630mm
505mm 700mm
578mm 770mm
650mm 840mm
723mm 910mm
795mm 980mm
THE REQUIRED CLEARANCE BETWEEN THETOP
OF THE EMITTER ANDTHETOP OFTHE ENDBOX
‘X’ DIMENSION AS ON PREVIOUS PAGE
