Meiji MSD-02 Manuel utilisateur
MEIJI SMOKE DETECTOR MSD-02
14
1134-CPR-101
EN 14604
Introduction
Design
I. Technical Parameters
Working Voltage: DC 9V
Quiescent Current: < 10uA
Alarming Current: < 20mA
Alarming Decibel: > 85dB/3m
LED Indicator: LED (Red)
Low Voltage Alarming : < 7.3V
Working Temperature: -10°C~+40°C
Working Humidity: < 95%RH
II. Dimension (mm)
TO TEST:
Note: if battery is installed in the wrong way, the detector will not work and
can damage the item.
If the detector operates smoothly, the Red LED will flash once in about 43S
1. Rotate the installation panel counter-clockwise to remove it.
2. Remove the insulated material to make sure the battery is installed
correctly.
3. Adjust the clips of the installation panel to the notches of the detector and
turn the smoke detector clockwise to lock it.
4. Press the test button and wait until the RED LED flashes. If installed
correctly, the smoke detector sounds. You may start using your smoke
alarm.
TO INSTALL:
1. Choose a good positon to install the smoke alarm on your ceiling.
2. Use the screw to fix the installation panel on the ceiling.
3. Turn the smoke detector clockwise in order to lock it to the installation
panel tightly.
Do not place this product in a humid, dusty and/or smoking environment
V. Low Voltage Alarm
When the battery is low, the smoke detector will alarm to signal the battery must
be replaced.
Table des matières
Autres manuels Meiji Capteur de sécurité
