Configuration Notes 289
Page 4 of 9
Running the Unit Manager Network Software
The Unit Manager Network (UMN) software is a configuration and management tool for Mediatrix devices. The UMN can be
downloaded from the Mediatrix Support Portal: https://support.mediatrix.com/DownloadPlus/Download.asp. It has a
default 3-units limit upon installation. This will suffice for most configurations.
It is recommended that the administrator uses the UMN to configure the Mediatrix devices. Please refer to the UMN Quick
Start guide for the installation of the software. Once the UMN software has been installed on your PC1, proceed with the
following steps.
Step 1: Start the UMN
Select from the Start Menu > Programs > Unit Manager Network 3.2 > Unit Manager Network.
Step 2: Login to the UMN
In the Administrator login window (Connect to Unit Manager), a User Name and Password are not required.
Click OK to proceed.
Step 3: Perform an Autodetect
On the left pane, right-click the Unit Manager level, then select Autodetect.
Set the IP Address Range to minimize the time it takes to auto-detect the unit. Click Start to begin Mediatrix
unit detection. When the unit is detected, the Result section lists the unit.
Select the unit and click OK. If no DHCP server is used in your subnet, you must connect one unit at a time
since they will start by using the default IP address 192.168.0.1 after a recovery reset. You will have to set a
different static IP address for every unit. Please see the Mediatrix 4104, 4108, 4116, and 4124 SIP Quick
Start Guide for more details on initial setup.
1If you are having trouble opening the UMN application, verify that the status of the “Unit Manager Network 3.2” service is started. See Page
5 to access Windows Services.
