Master Bilt R290 SERIES Manuel utilisateur

2/20 Rev. A 57-02694

Installation & Operations Manual for

R290 SERIES

MBGFP-HG Model

Bottom Mounted Swing Glass Door

Freezer Merchandisers With Lighted Sign

2/20 Rev. A 57-02694

TABLE OF CONTENTS

INTRODUCTION………………………………….……………………..…………………………………………………..…4

STORE CONDITIONS……………………….……………….……...………………………………………………...………4

WARNINGLABELS AND SAFETY INSTRUCTIONS……….….……...…………………………………………….........5

PRE-INSTALLATION INSTRUCTIONS......................................................................................................................7

Inspection for Shipping Damage…………………………………………...…………..……………….…………………….7

INSTALLATION INSTRUCTIONS…………………………………………………………….……………………………...7

GENERAL INSTRUCTIONS……………………………………………………………………………….……..……..……8

MECHANICAL…… ..…………………………………………………………………………………………………………..8

ELECTRICAL….…………...………………………………………………………………….……………………………..…9

LEG AND CASTER INSTALLATIONS ………………….…………………………………………………………..………9

DOORS………....…………....………………………….………………………………………………..…………….……...10

GRILL……………………….……………………….……………………………………………………………….…..….…11

DUAL CONDENSING UNITS……………………….…………………………………………………………….…..….…12

ELECTRONIC REFRIGERATION CONTROL…………………….……………………………………………..………..14

Programming………………………………………………….………………………………………………………14

List of Parameters……………………………….…………………………………………………………...……...15

Electrical connections………………….……………………………………………… .………………………….15

Probes connections………………………………………………………………………………………………….15

CHECK LIST………………………………………………………………………………………...…………………...……16

SERVICE INSTRUCTION……………………………………………………………………………………….……………17

TEMPERATURESENSOR, DEFROST HEATER AND FAN MOTOR REPLACEMENT………………….…….……18

PART LIST……………………………………….…………………………………………………………..…………...……19

ACCESSORIES ……………………………………………………………………………………………….…..………….19

SALE AND DISPOSAL………………………………………………………………………………..……………………..20

WIRING DIAGRAMS.………….…………………………………..…………….……………………...………………..21-22

2/20 Rev. A 57-02694

INTRODUCTION

This manual contains important instructions for installing, using, and servicing a flammable refrigerant glass door

freezer merchandiser case, GFP-HG. Failure to properly install, use, or service this product could cause damage to

cabinet, explosion, fire, injuries and even death. A parts list is included with this manual. Read all these documents

carefully before installing or servicing your equipment.

STORE CONDITIONS

The GFP-HG are designed to operate in the controlled environment of an air-conditioned store. The store

temperature should be at or below 75°F and a relative humidity of 55% or less. At higher temperature or humidity

conditions, the performance of these cases may be affected and the capacity diminished.

The GFP-HG should not be positioned where it is directly exposed to rays of sun or near a direct source of radiant

heat or airflow. This will adversely affect the case and will result in poor performance.

If this case is to be located against a wall, there should be at least 6” space between the wall and the back of the

case. This space will allow for the circulation of air behind the case, which will prevent condensation on the exterior

surfaces.

DANGER

Risk of fire or explosion. Flammable refrigerant used. Consult instruction

manual/repair manual/owner’s guide before attempting to install or service this

product. All safety precautions must be followed.

DANGER

Improper or faulty hook-up of electrical components on the refrigeration units can

result in severe injury or death.

NEVER use an extension cord to power these units. All electrical wiring hook-ups must be done in

accordance with all applicable local, regional or national standards.

NOTICE

Installation and service of the refrigeration and electrical components of the cabinet

must be performed by a refrigeration mechanic and/or a licensed electrician.

The portions of this manual covering refrigeration and electrical components contain technical instructions intended

only for persons qualified to perform refrigeration and electrical work.

This manual cannot cover every installation, use or service situation. If you need additional information, call or write

our customer service Department.

2/20 Rev. A 57-02694

WARNING LABELS AND SAFETY INSTRUCTIONS

DANGER

Risk of fire or explosion. Flammable refrigerant used. To be repaired only by trained

service personnel. Do not puncture refrigerant tubing.

CAUTION

Risk of fire or explosion. Flammable refrigerant used. Consult instruction

manual/repair manual/owner’s guide before attempting to install or service this

product. All safety precautions must be followed.

NOTICE

Installation and service of the refrigeration and electrical components of the cabinet

must be performed by a refrigeration mechanic and/or a licensed electrician

NOTICE TO EMPLOYERS

You must make sure that everyone who installs, uses or services your cabinet is

thoroughly familiar with all safety information and procedures.

Be sure you understand all safety messages and always follow recommended precautions and safe operating

practices.

Important safety information is presented in this section and throughout the manual. The following signal words are

used in the warnings and safety messages:

DANGER: Severe injury or death will occur if you ignore the message.

WARNING: Severe injury or death can occur if you ignore the message.

CAUTION: Minor injury or damage to your cabinet can occur if you ignore the message.

NOTICE: This is important installation, operation or service information. If you ignore the

message, you may damage your cabinet.

The warning and safety labels shown throughout this manual are placed on your Products cabinet at the

factory. Follow all warning label instructions. If any warning or safety labels become lost or damaged, call

your customer service department for replacements.

2/20 Rev. A 57-02694

This label is located on top of the electrical control label. This label is attached to the cabinet power cord

on models with a power cord.

CAUTION!

GROUND REQUIRED

FOR SAFE OPERATION

2/20 Rev. A 57-02694

PRE-INSTALLATION INSTRUCTIONS

INSPECTION FOR SHIPPING DAMAGE

You are responsible for filing all freight claims with the delivering truck line. Inspect all cartons and crates for damage

as soon as they arrive. If damage is noted to shipping crates or cartons or if a shortage is found, note this on the bill

of lading (all copies) prior to signing.

If damage is discovered when the cabinet is uncrated, immediately call the delivering truck line and follow up the call

with a written report indicating concealed damage to your shipment. Ask for an immediate inspection of your

concealed damage item. Crating material must be retained to show the inspector from the truck line.

INSTALLATION INSTRUCTIONS

CAUTION

Risk of fire or explosion due to puncture of refrigerant tubing; follow handling

instructions carefully. Flammable refrigerant used.

GENERAL INSTRUCTIONS

1. Be sure the equipment is properly installed by competent service people.

2. Keep the equipment clean and sanitary so it will meet your local sanitation codes. Clean the cabinet with a mild

detergent and water, then rinse.

3. Rotate your stock so that older stock does not accumulate. This is especially important for ice scream. A "First-

In, First-Out" rotation practice will keep the products in good salable condition.

4. Do not place product in the case when it is soft or partially thawed. Also, product should not be put in the case

for at least 6 hours after it is started.

5. Stock cases as quickly as possible, exposing only small quantities to store temperatures for short periods of

time.

6. When replacing burned out light bars, be sure that the electrical power to the lighting circuit is turned off.

NOTICE TO STORE OWNERS / MANAGERS

Moisture or liquid around or under the cabinet is a potential slip/fall hazard for persons walking by or

working in the general area of the cabinet. Any cabinet malfunction or housekeeping problem that creates a

slip/fall hazard around or under the cabinet should be corrected immediately.

If moisture or liquid is observed around or under the cabinet, an immediate investigation should be made by qualified

personnel to determine the source of the moisture or liquid. The investigation should determine if the cabinet is

malfunctioning or if there is a drainpipe leaking.

2/20 Rev. A 57-02694

MECHANICAL

CAUTION

Risk of fire or explosion due to puncture of refrigerant tubing; follow handling

instructions carefully. Flammable refrigerant used.

CAUTION

Installation and service of the refrigeration and electrical components of the cabinet

must be performed by a refrigeration mechanic and/or a licensed electrician.

Remove front grille and check refrigeration lines to see that they are free (not touching each other or compressor).

Refrigeration system processing tubes for a cabinet possessing flammable refrigerant is painted red. Spin condenser

fan blade to see that it is free. Insulate quick connects with pipe insulation to prevent condensation and/or ice

accumulating.

Remove cabinet from crate base and slide into location. Cabinet must be level from side to side and front to back for

correct draining of coil pan and for self-closing doors to operate correctly. Allow minimum of 4” between back of

cabinet and wall and between top of cabinet and ceiling for proper condensing unit air circulation.

To comply with Sanitation requirements the cabinet must be mounted on legs (6” high min.), casters, or the base

must be sealed to the floor with an N.S.F. listed silicone sealant. When sealing to the floor, leveling bolts can be uses

to assure the cabinet is level before applying silicone sealant.

2/20 Rev. A 57-02694

ELECTRICAL

WARNING

Before servicing electrical components in the case or the doors or door frames make sure all

power to case is off. Always use a qualified technician.

Check voltage and amps drawn on (TABLE 2) to determine proper line and fuse or circuit breaker size. Check power

supply for low voltage.

For example: If voltage reads “230” with no load, and it drops below “207” when the compressor tries to start, it is an

indication of too small supply wiring or too long to run.

It is recommended that a separate circuit be run for each cabinet to prevent another appliance blowing the fuse or

breaker, causing loss of product.

IMPORTANT

Models (3 door cabinet) are pre-wired internally with a 208-230V NEMA L14-20P plug and should only

be plugged into a NEMA L14-20P recepticle. See wiring diagrams for more details. The cabinet should

be grounded.

LEG / CASTER INSTALLATION

1. Screw legs / casters tightly into the rail

base mounting holes.

2/20 Rev. A 57-02694

DOORS

The cabinets have Anthony glass doors

that are equipped with a patented TorqueMaster

hinge system. The doors are easily adjusted using

a flathead screwdriver (Fig.3).

* The tension needs to be checked and set when

first install.

Figure 3

NOTICE

The doors on these cabinets are Anti-Fog Glass so it is important to follow the information below when

cleaning these doors. Failure to observe the details below in cleaning doors will void door supplier

warranty.

•Do not use sealants, gaskets, or other materials containing silicone that can contaminate the coating.

•Do not use tape, glue, stickers, attachments, or magic markers on the anti-fog coating.

•Do not use razor blades or any other mechanical device to remove foreign residue or objects directly from

the coated glass.

•Do not use abrasive cleaners or materials on the coated glass. Examples of these cleaners or materials

include Ajax, Brillo, Comet, Scotch Brite, Steel Wool, and Soft Scrub.

•Do not use cleaners or materials on the coated glass that hinder the anti-fog performance by leaving residue

or damaging the surface. Examples of these cleaners include: Armor All, Tilex, Bleach, Windex no-drip,

Windex Wipes, Pledge, or any product containing silicone oils or waxes.

•Recommended cleaners include: Isopropyl Alcohol, Greased Lighting, Formula 409 Grease & Grime,

Formula 409 Grease & Surface, Fantastic, Windex Vinegar, Windex Original, Now, Mean Green, or Mr.

Clean (degreasing cleaners).

•Recommended cleaning is with a soft dry or slightly damp towel, or with one of the degreasing cleaners listed

above.

Torque Adjustment

Leveling Adjustment

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Master Bilt Réfrigérateur

Master Bilt

Master Bilt J - Version GT-50 s Manuel utilisateur

Master Bilt

Master Bilt TAC-27 Manuel utilisateur

Master Bilt

Master Bilt BHC Series BHC-27 Manuel utilisateur

Master Bilt

Master Bilt BSD Series Manuel utilisateur

Master Bilt

Master Bilt ATMC-124DSS Manuel utilisateur

Master Bilt

Master Bilt BGR15 Manuel utilisateur

Master Bilt

Master Bilt LAE Controller BMG/TMG 48 s Manuel utilisateur

Master Bilt

Master Bilt SMB-330 Manuel utilisateur

Master Bilt

Master Bilt GT-30 Manuel utilisateur

Master Bilt

Master Bilt ATMC-122SS Manuel utilisateur

Master Bilt

Master Bilt SPT-28 Manuel utilisateur

Master Bilt

Master Bilt MPM-36 Manuel utilisateur

Master Bilt

Master Bilt SPT-28 Manuel utilisateur

Master Bilt

Master Bilt PPT-67 Manuel utilisateur

Master Bilt

Master Bilt Fusion BSD-24SFA Manuel utilisateur

Master Bilt

Master Bilt DC-10D Manuel utilisateur

Master Bilt

Master Bilt WCC-23SR Manuel utilisateur

Master Bilt

Master Bilt IHC-27 Manuel utilisateur

Master Bilt

Master Bilt TLG-27HD Manuel utilisateur

Master Bilt

Master Bilt WCR-23SR Manuel utilisateur

Master Bilt

Master Bilt IM-23-HGP Manuel utilisateur

Master Bilt

Master Bilt BGR-14 Manuel utilisateur

Master Bilt

Master Bilt TEL-2-30 Manuel utilisateur

Master Bilt

Master Bilt TAC-27HDSA Manuel utilisateur

Manuels Réfrigérateur populaires d'autres marques

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Manuel utilisateur

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Manuel utilisateur

Sharp

Sharp SJ-BA31IEXW2-EU Manuel utilisateur

CORBERO

CORBERO CC2300MCW Manuel utilisateur

KitchenAid

KitchenAid 2205264 Manuel utilisateur

Stengel

Stengel KU 1101 A++ Manuel utilisateur

NEFF

NEFF KI181 Series Manuel utilisateur

Hoshizaki

Hoshizaki Reach-In Manuel utilisateur

Amana

Amana ASD2524VES00 Manuel utilisateur

BOMANN

BOMANN KGC 213 Manuel utilisateur

Danby

Danby DAR044A1SLDD Instructions de montage

Samsung

Samsung RF323TE Manuel utilisateur

Beko

Beko CSA31022 Manuel utilisateur

IKEA

IKEA FROSTIG C 185 E Manuel utilisateur

Electrolux

Electrolux ER 6821 D Manuel utilisateur

True

True TS-28 Manuel utilisateur

Frigidaire

Frigidaire FSC23R5DW9 Manuel utilisateur

Beko

Beko LSP4579W Manuel utilisateur