Marshall Electronics VS-PTC-150 Fiche technique

Quick Setup Tech-note using VS-PTC-150 (Controller) with CV620 (Ca era)

1. Unpack CV620 (Camera) and VS-PTC-150 (Controller) and plug in po er sources.

2. Use RS-232 Cable packed in VS-PTC-150 (Controller) box and plug in VGA-style comm cable ith thumb

scre s to (Controller) and plug round 8-pin connector to CV620 (Camera).

3. Confirm (Controller) is set to CAM: 001 on LCD Screen, or 002, 003, 004 atching ADDRESS of Camera.

Also confirm both Controller and Camera are set to VISCA or PROTOCOL V.

4. Or use RS-422 ire harness on VS-PTC-150 (Controller) and CV620 (Camera) and plug 2 ires into each

end using one ire to connect from Controller (position #1 – Ta) to Camera (position #6 RXD IN -), then

connect other ire to connect from Controller (position #2 – Tb) to Camera (position #7 RXD IN +).

VS-PTC-150 Controller

CV620 Ca era

5. Confirm (Camera) is set to ADDRESS SELECTOR (Camera-ID) #1 position on back panel, or #2 ~ #7.

6. Make sure to match either VISCA or PELCO-D protocols, depending on hich is being used on Camera and

Controller. If using PELCO-D make sure to set menu to SYSTEM > Protocol > Protocol V for Visca or

SYSTEM > Protocol > Protocol PD for Pelco-D and/or System S itch on bottom of camera DIP#1 to ON for

RS-422 or OFF for RS-232.

7. Use the follo ing buttons on VS-PTC-150 (Controller) to control Camera functions:

A. Joystick: controls Pan-Tilt (directional) - Zoom (t ist knob clock ise-zoom in, t ist knob counter

clock ise-zoom out) and navigates OSD Menu

B. Function Keys: controls certain functions on camera

C. Basic Co and Keys

- hen camera is set to Manual Focus these keys ill fine adjust Focus

- operates Lens Zoom IN+/OUT-

D. Preset & Recall PAN-TILT-ZOOM Locations: ability to PRESET certain shots on camera

i.) Choose location ith Pan-Tilt-Zoom controls to desired shot

ii.) Push PRESET button, then Number (1~127) Preset, and Enter to Save (and Esc)

vi.) to Recall location - Push SHOT then number key of saved location, and Enter

E. Other Functions & Operation of Controller can be found in VS-PTC-150 (Controller) Manual or

CV620 (Camera) can be found in CV620 Manual.

Autres manuels pour VS-PTC-150

Table des matières

Autres manuels Marshall Electronics Contrôleurs

Marshall Electronics

Marshall Electronics VS-PTC-200 Manuel utilisateur

Marshall Electronics

Marshall Electronics VS-PTC-50 Manuel utilisateur

Marshall Electronics

Marshall Electronics VS?TKC?100 Manuel utilisateur

Marshall Electronics

Marshall Electronics VS-PTC-50 Manuel utilisateur

Marshall Electronics

Marshall Electronics VS-PTC-150 Manuel utilisateur

Marshall Electronics

Marshall Electronics VS-PTC-50 Manuel utilisateur

Marshall Electronics

Marshall Electronics VS?TKC?100 Manuel utilisateur

Manuels Contrôleurs populaires d'autres marques

Digiplex

Digiplex DGP-848 Mode d'emploi

YASKAWA

YASKAWA SGM series Manuel utilisateur

Sinope

Sinope Calypso RM3500ZB Manuel utilisateur

Isimet

Isimet DLA Series Style 2 Manuel d'installation

LSIS

LSIS sv-ip5a Manuel utilisateur

Rockwell Automation

Rockwell Automation 1769-L31 Manuel utilisateur

Airflow

Airflow Uno hab Manuel utilisateur

ABB

ABB ACS580-01 drives Manuel utilisateur

Panasonic

Panasonic GM1 Series Manuel utilisateur

Emerson

Emerson SW93 Manuel utilisateur

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuel utilisateur

Panasonic

Panasonic FP? Positioning Unit RTEX Manuel utilisateur

Samson

Samson Type 5824 Manuel de service

Alpha IP

Alpha IP MIOB 21001 Manuel utilisateur

Siemens

Siemens OpenAir GMA 1 Series Manuel utilisateur

Surecom

Surecom SR-629 Manuel utilisateur

Fishman

Fishman TriplePlay Manuel utilisateur

Regulus

Regulus SRS1 T Manuel utilisateur