
0 m
5
m
10
m
15
m
5
m
10
m
15
m
95⁰
2.1 m
2.1 m 4.8 m 8.6 m 15 m
up to 20 kg
Functional parts of the device
1. Detector case
2. Microphone hole
3. Light indicator of the
operation modes
4. PIR element lens
5. Bracket for detector
mounting
6. Tamper contact
7. Case back cover
8. Power button
Selecting the installation
location
Carefully select the installation location
of the MAKS PIR Combi detector, taking
into account the direction of the lens
and microphone and the presence of
obstacles that may limit the view of
the detector.
When installing the detector, make
sure that the area of intrusion detection
and break of glass is within the
maximum coverage of the detector
and the possible direction of intruder’s
movement is perpendicular
to the installation axis.
For the maximum
coverage, place the
detector at a height of
2.1 meters from floor level.
Installation and connection
1. Mount the bracket 5using the supplied screws and wall plugs.
2. Place the device on bracket 5and slide it down to fix it and lock the
tamper contact 6. Flashes on indicator 3will confirm that the tamper is
locked
Registration and setup
1. Place the detector at a distance of no more than 2 m from the MAKS
PRO security center. Registration is run at a minimal possible power to
avoid the influence of neighboring systems that can be being configured
nearby.
2. Start the MAKS SETUP application
3. Follow the application instructions to connect to the MAKS PRO and
start the registration of MAKS wireless devices
4. Turn on the MAKS PIR Combi, after 10-20 seconds it will be registered
5. Set up a new device in your mobile application
Switching on and off
Press button 8to switch on the device - the light indicator will be on. If the
device is registered in MAKS PRO, it switches to standby mode. If the device
has not been registered, it will go into sleep mode after 30 seconds.
To turn off the device, press and hold button 8 for 5 seconds.
Before installing the MAKS PIR Combi, register it in the MAKS PRO and
test the detector signal strength using the MAKS SETUP application.
The detector is supplied with two brackets to place the device on a flat
surface or in a corner of the room.
We recommend to install the device in the following order:
1. Selecting the installation location with the best signal
2. Mounting the bracket
3. Detector installation
Detector installation
The device should not be placed:
1. Outdoors or in areas with unacceptable humidity and temperature
2. In places with a high level of radio interference
3. Near objects that can cause radio signal attenuation or shielding (metal,
mirror, etc.)
4. In a place where the lens is exposed to the direct sunlight.
5. In front of objects with quickly changing temperature or in places with
fast air circulation.
6. Facing any moving objects with human body temperature
7. At a distance of less than 1 m from the security center
Battery replacement
1. Remove the device from the bracket by pushing it upwards.
2. Unscrew and remove the case back cover 7
3. Replace the battery and reassemble the device
Indication in communication test mode
Excellent connection - LED indicator flashes green
Satisfactory connection - LED indicator flashes yellow
Poor connection - LED indicator flashes red
No connection - LED indicator flashes red quickly
In test mode, the unit's radio transmitter operates at medium power.
5
2
7
4
7
68
1
3