Magliner LiftPlus Manuel utilisateur
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
1
Serial #: _________________________________
Date of Purchase: ________________________
LiftPlus®
Owner’s Manual
1. Read the Owners Manual thoroughly before first use.
2. Charge the LiftPlus for six hours before using it for the first time. If the LiftPlus battery
completely discharges, recharging will take 72 hours. See page 5 for battery and
charging information.
3. The lead screw requires regular lubrication for proper working condition. See page 13
for maintenance schedule.
Important Startup Instructions
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
2
Table of Contents
General Safety Instructions.......................................................................................................... 3
Startup Instructions ...................................................................................................................... 3
LiftPlus Unit .................................................................................................................................. 4
Charging the Battery .................................................................................................................... 5
Using the LiftPlus ......................................................................................................................... 6
Changing Attachments ................................................................................................................. 7
Moving with the LiftPlus ............................................................................................................... 7
Folding the Unit ............................................................................................................................ 8
Unfolding the Unit......................................................................................................................... 9
Using the Brakes.......................................................................................................................... 10
Adjusting the Brakes .................................................................................................................... 10-11
Replacing the Battery............................................................................... ................................... 12
Maintenance................................................................................................................................. 13-14
Troubleshooting Guide ................................................................................................................. 14
Operating Labels.......................................................................................................................... 15
Replacement Parts....................................................................................................................... 16
Warranty
Magliner products have a one (1) year warranty unless otherwise specied from the date of
purchase against defects in workmanship or material. Any part or component, except items covered
by warranties of other manufacturers, returned to the factory or service center freight prepaid
by the owner, found upon examination by Magline, Inc. to be defective or the result of improper
workmanship by the factory will be repaired or replaced without charge and returned to the owner
freight prepaid by Magline, Inc.
Alterations of Magliner products void any warranty or liability on the part of Magline, Inc.
Magline, Inc. does not guarantee product capacity if alterations are made.
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
3
Thank you for purchasing the Magliner LiftPlus®! If you have any questions regarding your new
Magliner product please call our customer service department at 1-800-MAGLINE (624-5463) or
(989) 512-1000. Please read this manual thoroughly to become familiar with the safe operation and
maintenance of your new LiftPlus system.
General Safety Instructions
• Inspect before each use for damaged and loose fasteners/connections.
• Inspect the unit for cracks, wear or damage. Replace damaged components immediately.
• Keep hands and feet away from all moving parts.
• Never stand or sit on the work bench.
• Do not use this product to lift or to transport people.
• Never use as a step ladder.
• Never use on a moving vehicle.
• Never operate when any of the housing components have been removed.
• Keep all loose items away from the lift screw, as they may become entangled during use.
• Never use or store in wet environments or get any of the unit wet. The unit may be used
indoors or outside, but always use caution to keep the unit from getting wet; dry as soon as
possible.
• Never exceed 350 lbs. capacity. Damage to the lift and personal injury could result.
• Never raise or lower the work bench unless the unit is unfolded and the folding latch is
locked.
• Use extreme care when raising or lowering in close proximity to other objects. Hands
and other items may get pinched or injured as the moving attachment passes non-moving
objects.
• Never place a load’s center of gravity over the vise or work bench nose; always keep the
load center of gravity centered on the work bench.
• Never tilt the unit back with a raised load.
• Always check that the brakes are working correctly before operating with a load.
• Never walk away from the unit when the folding latch is in an unlocked position.
• Always keep the power switch off when the unit is folded.
• Never go over a curb or any other multi-level transition with a raised load.
• Do not operate when the battery charger is plugged in.
• Never attempt to open the battery. If the battery is cracked or leaking, do not recharge it - it
must be replaced.
• Always use a Magliner battery charger to charge your battery.
1. Read the Owners Manual thoroughly before first use.
2. Charge the LiftPlus for six hours before using it for the first time. If the LiftPlus battery
completely discharges, recharging will take 72 hours. See page 5 for battery and
charging information.
3. The lead screw requires regular lubrication for proper working condition. See page 13
for maintenance schedule.
Startup Instructions
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
4
LiftPlus Unit
On/Off Switch
Electrical
Interface Panel
Brake Lever
Parking Brake
Latch
Column Handle
Up/Down
Switch
Quick
Change Latch
Lift Screw
Latch Release
Lever
Folding Latch
Handle
Battery
Compartment
Circuit Breaker
Column Channels
Storage Rollers
Casters
Column
Rear Rollers
Trolley
Side Plates
Front Rollers
Wheel and
Tire Assembly
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
5
Battery
The LiftPlus® must be charged for six hours before using it the rst time. If the LiftPlus battery
completely discharges, recharging will take 72 hours. When not in use, it is recommended to keep
the LiftPlus plugged in to maintain a maximum charge.
General Battery Warnings
• Do not connect accessories to the battery; this will cause premature battery failure.
• Unauthorized modication could create a hazardous condition and result in serious injury.
• Batteries contain sulfuric acid, which can burn eyes, skin, clothes, etc. Use caution! Always wear
gloves when working with batteries. If contact occurs, ush immediately with water and get
medical attention. Protect surfaces from battery damage by placing batteries on rubber or plastic
surfaces.
• To prevent electrical shock, do not touch non-insulated parts of the charger output connectors,
battery connectors or battery terminals. Do not use connectors that are cracked, corroded, or do
not make adequate electrical contact. Use of damaged or defective connectors could result in re
or electrical shock.
• Keep sparks, ame and smoking materials away from batteries.
• Batteries can supply a large amount of current. Do not wear jewelry or watches when working on
the batteries as an accidental shorting could occur and cause severe burning.
Battery Life
The LiftPlus is powered by one 12V battery.* The lift motor draws current from the battery based on
the amount of effort required to lift the load. A fully-charged battery will power 125 - 150 lift cycles
with a median load; however, extreme temperature ranges and extreme loads can have an effect on
the amount of power available during one charging cycle.
General Charging Warnings
• Use only the Magliner 15V charger designated for use with LiftPlus. Charge using a grounded
120V electrical outlet.
• Do not operate the unit when the battery charger is plugged in.
• Do not expose charger to rain or snow.
• To prevent risk of re, use the charger only in a dry, well ventilated room without ammable uids
or explosive gases.
• Make sure the cord is located such that it will not be a trip hazard or otherwise subject to
damage or stress.
• Do not operate a charger with a damaged cord or plug – replace immediately.
• To reduce risk of electrical shock, unplug the charging unit from the AC power supply source
before attempting any maintenance or cleaning.
• Always use battery chargers supplied by Magline, Inc. Other battery charging units could cause
damage to your batteries or personal injury.
• To avoid damage to battery charger connectors and cords, disconnect by grasping the plug
body and pulling it straight out of the outlet or receptacle. DO NOT pull on the cord. DO NOT
twist, rock, or pull the connector sideways.
• The metal tip on the end of the plug may be hot when it is rst unplugged.
*Battery has a warranty of six (6) months
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
6
Using the LiftPlus
NOTE: The LiftPlus must be unfolded and the folding latch locked before the quick change latch is
lifted or lowered. Failure to do so can damage the unit.
Loading the LiftPlus
1. Do not exceed the load capacity of 350 lbs. (120 lbs. on high-speed models).
2. Set the parking brake before loading (see page 10).
3. Be sure the load center of gravity is located as close as possible to the center or rear of the attachment.
Lift/Lower Operation
1. Move the power switch to the On position.
2. To lift the load, pull the lift actuation switch toward the back of the unit.
3. To lower the load, press the lift actuation switch toward the front of the unit.
Lift Overload
1. The overload protection circuit prevents lifting motion when it senses an excessive load. When the
circuit is triggered, a red light illuminates on the back of the LiftPlus.
2. To reset the overload circuit, lower the platform all the way to the bottom. The red light will turn off
when lifting function has been restored.
Circuit Breaker
1. When the circuit breaker trips, the button will pop-up and show a white face.
2. Reset the circuit breaker by pressing the button down until you hear a click. It will not reset for the rst
few seconds after tripping.
3. If the circuit breaker tips repeatedly, contact Magline.
TrippedNormal
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
7
Moving with the LiftPlus
Changing Attachments
1. Lift or lower the quick change latch to comfortable height.
2. Pull the detent pin out of the quick change latch (located at the bottom front of the latch).
3. Angle the attachment slightly upward from center. Position the lift attachment notches at the top of the
quick change latch. Carefully push the attachment down and toward the quick change latch so that the
attachment is ush with the front of the latch.
4. Push the detent pin so that it contains both faces of the attachment inside both faces of the quick
change latch. Push through fully so that the pin does not back out on its own.
5. Reverse these steps to remove the attachment from the quick change latch.
1. Always stay behind the unit when moving it. Use both hands on the handlebars.
2. Never turn the unit quickly - this can cause the load to slide off the lift attachment.
3. To use the unit in two-wheel mode, apply the brake and gently pull back on the handlebars. When you
are ready to proceed, release the brake. NOTE: Never initiate two-wheel mode with a raised load!
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
8
Folding the Unit
NOTE: Never walk away from the unit when the folding latch is in an unlocked position. Never
store the unit with the power switch left “on.” If the lift actuation switch is accidentally pressed while
the unit is folded, it can damage the unit.
Folding the Unit
1. Remove any load and the lift attachment from the unit.
2. Make sure that the bottom of the quick change latch is at least 12” above the ground.
3. Turn off the unit.
4. Set and lock the brakes.
5. Grasp the folding latch handle and rotate it slightly forward to remove some tension on the red latch.
Press the red latch release lever up with your thumb.
6. Allow the folding latch handle to spring upwards.
7. Pull up on the folding latch handle with one hand and grasp the column handle with the other hand to
guide the column down. The column will slowly fall into the folded position.
8. Push the column as far down as possible.
9. Push down on the folding latch handle until the folding latch reaches the bottom of its travel.
10. Rotate the folding latch handle downward into its locked position. There will be a loud click as the latch
release lever engages. Ensure the folding latch handle is properly locked before moving, operating or
loading. When properly locked, the folding latch handle cannot be lifted without releasing the red latch
release lever.
11. Tug the folding latch handle towards you to be sure that it is properly locked (see next page for photos).
Latch Release Lever
Folding
Latch Handle
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
9
NOTE: A folded unit can be stood up on end for storage, but before you unfold it, you must lay it at
on the ground.
Unfolding the Unit
1. Set and lock the brakes.
2. Grasp the folding latch handle and rotate it slightly forward to remove some tension on the red
latch. Press the red latch release lever up with your thumb.
3. Allow the folding latch handle to rotate toward you and then pull it slightly outward.
4. Squat down beside the unit and grasp the column handle.
5. Pull up on the column handle and rotate the column as far back as possible.
6. Push down on the folding latch handle until the folding latch reaches the bottom of its travel.
7. Rotate the folding latch handle downward into its locked position. There will be a loud click as the
latch release lever engages. Ensure the folding latch handle is properly locked before moving,
operating or loading. When properly locked, the folding latch handle cannot be lifted without
releasing the red latch release lever.
8. To ensure the unit is locked, pull upward on the folding latch handle (it should not move). Push
forward on the column handle; the column should not rotate forward at all.
Be sure that the folding latch is completely locked before moving away from the unit.
Unfolding the Unit
Locked Properly Not Locked Properly Not Locked Properly
1-800-MAGLINE (624-5463) www.magliner.com
LiftPlus®
10
Adjusting the Brakes
The brakes are adjusted at the factory, but should still be checked before every use. If the braking
power is insufcient, the brakes should be adjusted. Perform the adjustment on a dry, non-slippery
surface.
There are two forms of adjustment. One adjusts the brake cable tension and the other adjusts the
set of brake calipers. Adjusting the brake cable tension is usually sufcient. If you are unable to
achieve sufcient braking force by tightening the cable or if one wheel brakes more effectively than
the other, you may need to adjust the brake caliper.
Adjusting the Brake Cable Tension
1. Loosen the screw (1) that locks the brake cable mount using a 3/16” Allen wrench.
2. Adjust the tension in the cables by turning the brake adjustment screw (2) that protrudes from
the bottom of the brake cable mount using a 3/16” Allen wrench.
3. After adjusting the brake adjustment screw, retighten the locking screw.
4. To test the tension, squeeze the brake lever tightly, tilt the unit back about 35°, and push the unit
forward along the ground. The combined action should make the wheels skid on the ground.
5. If the wheels spin, the brakes are not adjusted correctly. If the cable is too tight, it may engage
the brakes when you are not pulling on the brake lever.
1
2
Brake Operation
1. To engage the brakes, squeeze the brake lever toward the handlebar.
2. To lock the brakes, squeeze the brake lever toward the handlebar and press the red parking brake latch
forward with your thumb.
3. To disengage the brakes, squeeze the brake lever to release the red latch.
Brakes
Autres manuels pour LiftPlus
3
Table des matières
