MA grandMA3 Manuel utilisateur
1
Hint:
The grandMA3 I/O Node can be connected with the power cable. Only the grandMA3 I/O Nodes DIN-Rail need to be
installed on the rail following DIN EN 60715 and the instructions below.
Important:
Install the grandMA3 I/O Node DIN-Rail horizontally so that the input terminal is located at the bottom.
Warning:
In order for the device to dissipate heat, comply with a minimum distance of 30 mm (approx. 2 inches) above and
beneath the grandMA3 I/O Node DIN-Rail.
1
Installation
1
1. Install the grandMA3 I/O Node DIN-Rail onto the rail.
Place the grandMA3 I/O Node DIN-Rail on the rail.
2
1
Snap into place
2. Build the I/O Node DIN-Rail into the switchboard.
3
1
Connections
Connect with electrical grid
-or-
4
1
Connect via PoE
Power
Connector MC 1.5/ 3-ST1-5.08
Rigid cables 0.75 mm² - 1.5 mm² (18-16 AWG)
Flexible cables 0.75 mm² - 1.5 mm² (18-16 AWG)
Wire end sleeves are permitted.
Wire stripping length 7 mm
Tightening torque 0.22 Nm - 0.25 Nm
5
1
MIDI & LTC
Connector FK-MC 0.5/ 3-ST-2.5
Rigid cables 0.14 mm² - 0.5 mm² (26-20 AWG)
Flexible cables 0.14 mm² - 0.5 mm² (26-20 AWG)
Wire end sleeves are permitted.
Wire stripping length 8 mm
DC Remote
Connector FK-MC 0.5/ 7-ST-2.5
Rigid cables 0.14 mm² - 0.5 mm² (26-20 AWG)
Flexible cables 0.14 mm² - 0.5 mm² (26-20 AWG)
Wire end sleeves are permitted.
Wire stripping length 8 mm
6
Autres manuels pour grandMA3
16
Autres manuels MA Mixeur musical
MA
MA grandMA2 Manuel utilisateur
MA
MA grandMA3 Guide d'installation
MA
MA grandMA3 Manuel utilisateur
MA
MA grandMA3 Manuel utilisateur
MA
MA grandMA3 Manuel utilisateur
MA
MA grandMA3 Manuel utilisateur
MA
MA grandMA3 Manuel utilisateur
MA
MA 2Port Node WM Guide d'installation
MA
MA grandMA3 Manuel utilisateur
MA
MA grandMA3 Guide d'installation
