M-LOCKS BV Tel: +31 (0)314 376 876
Vlijtstraat 40 ver. 1.0 2010 05 26 Fax: +31 (0)314 376 878
NL-7005 BN Doetinchem 3 www.m-locks.com
As TURNABLE ENTRY UNIT with M-LOCKS StraightBolt lock EM3520:
The diameter of the cable hole should be minimum 9 mm, maximum 12 mm. The hole must
be de-burred well to avoid damage to the cable. Cut the grooved shaft to the appropriate
length: Measure door thickness (from mounting surface of the Entry unit to the mounting
surface of the lock) and add 41 mm (1.6”).
Prepare the mounting and cable holes according to picture 1. Hold the bearing plate in a
way against the mounting surface that “UP ROTATE” is readable on top (picture 2). Affix the
plate with the two mounting adapter screws (M4) hand tied. Insert the spring first and then
the pin into the hole on the back cover (picture 3). Insert the grooved shaft all the way into
the entry housing (picture 4). Now push the cable into the groove until flat over the entire
length of the shaft. Route the cable and shaft through the spindle hole of the door, hold the
unit at the (approximately) 10:00 o’clock position, and slide it on the mounting adapters
(picture 5). Turn unit clockwise until it clicks into straight position at 12:00.
The Bravo entry unit will not be detachable once the lock is installed.
Connect one (1) battery to the battery clip. Only use 9V Duracell/ Procell Alkaline (or
Energizer) batteries.
This mounting instruction is part of VdS certification and has to be followed up precisely.
