3
1.2 Tools Required
The following tools are required for installation:
★
Large & small flat bladed screwdrivers and cross point screwdrivers
★
Hammer
★
Power drill
★
Wire cutters and wire stripper
★
Eye protection (recommended when using a power drill or hammer)
1.3 System Features
★
Simple and effective Eight-zone system with the new patented two-wire technology.
★
All system components (sensors, bellbox) are connected to the Control Unit via two-core
non-polarity flat wires. Wiring and installation of the system is extremely simple and
easy.
★
Control Unit has built-in infrared receiver, with status LEDs and zone indicators. Panic
and tamper attempts will be indicated by the status LEDs.
★
Maximum 8 remote keys can be accepted for full arm, part arm, disarm, panic and learn
key functions
★
“Full arm” and “Part arm” modes are pre-programmed for user convenience.
★
The tamper zone is indicated by both Tamper LED and Zone LED (for Zone 4 to 8).
★
All sensors, bellbox are 24 hour line-protected and fully supervised; any attempt to
interfere with the system will trigger the alarm and be identified by flashing LEDs and
zone indicator.
★
Two PIR motion detectors can be connected to one zone, therefore the system can be
expanded to have ten PIR’s plus many magnetic contacts. Also, easy connections are
provided for adding telephone dialer to the system.
★
Remote key reader is available for user convenience.
★
Optional two wire bellbox is available
★
Optional normal bellbox connection terminals are provided.
★
Optional voice dialer is available to increase the security level.
