The Remote Control
1. POWER: on and off
2. VOL: Volume adjustor Vol+/Vol-
3. MUTE : mute
4. SELECT: Mode switch
AB-100 Specifications
1. Output power: AB 100W+100W/4Ω
2. RCA jack: 4
3. input impedance: 470KΩ
4. Frequency response: 10Hz-60KHz
5. Power: AC 110V/60Hz
6. Size:L420mmxW390mmxH97mm
7. Weight: +(-)13KG
Trouble Shooting
In case of error, please check the follow items. Most errors occur due to malfunction or
misconnection. Should errors remain unsolved, please contact your local dealer or LxR
technical service.
Error Indicator Solution
No power 1.
Is the power cable connected?
1. Connect the power cable.
No sound
Is the signal cable and the
speaker cable well connected?
2.
Is the input mode correct?
Is the volume appropriate?
Speaker protection function
Connect the signal cable and
speaker cable.
Select the correct mode.
Adjust the volume to the
appropriate range.
Reset the speaker protection
connector (use a sharp tip to
press no. 7 on the panel)
No sound in one
channel
Is one side of the channel
misconnected?
Is one side of the speaker
misconnected?
Connect the signal cable.
Connect the speaker cable.
There’s a loud buzz
sound
Poor connection, not fasten
well, or poor quality of the
cable wire?
Fasten the signal cable tightly, or
replace it
to function
Is there a button stuck?
Is there no power?
Press the button again.
Replace battery.
L x R O r g i n a l A u d i o A m p l i f i e r T E L ：(02)2904-6299
New North R oa d No. 458, 1 st Floor , seve n new T a ip ei X i nzhu an g D i strict w w w .lx r.c om . tw
