INSTALLATION GUIDE
© Copyright Lumicor 2014 – All Rights Reserved. For more information, visit www.lumicor.com or call 1.888.LUMICOR. Lumilight™Installation Guide
Updated 10/24/14
STANDOFF
BEFORE INSTALLATION
To achieve acceptable light diffusion when using standoffs, Lumicor
recommends leaving at least ½" (12mm) of space between the
Lumilight and Lumicor panels. To ensure desired aesthetics, test the
panel spacing in end use conditions before installation.
LUMILIGHT WITHOUT SPACING
LUMILIGHT WITH SPACING
INSTRUCTIONS
1. Hold the panel against the substrate in the desired location and
mark the location of each hole on the substrate.
2. Remove panel and drill holes into the substrate where marked.
For concrete substrates, tap the concrete anchors into the
pilot holes.
3. Unscrew and remove the standoff caps.
4. When using long standoffs, remove brass insert from bottom of
standoff and put screw through the insert. For short standoffs,
insert screw into the larger opening in the standoff barrel and
through the smaller opening at the opposite end.
5. Screw into the concrete anchor or wood substrate. For hollow
walls, thread the toggle onto the screw and pinch the ends of
the toggle together as you guide it into the pilot hole. Once the
toggle opens on the other side of the wall, gently screw into
place. Do not over tighten.
6. Fit Lumilight panel onto the standoffs so it is able to slide along
the barrels.
7. Place the panel in position, insert standoff cap through hole and
turn until snug.
8. Turn on Lumilight and slide it down the standoff barrels until
desired diffusion is achieved.
9. Leave Lumilight in place, turn it off and secure it to standoffs in
desired location. Lumicor suggests using an acid-free silicone to
glue the Lumilight in place.
DIAGRAM 1
DIAGRAM 2
Lumicor Panel with
13/32" (10 mm) holes
