Lumiax MT2010 Manuel d'instructions
TRACKSO CONNECTION MANUAL FOR LUMIAX CHARGE CONTROLLER
Brand: LUMIAX
Type: Solar Charge Controller
Models: MT2010, MT2075, MT3075BT, MT3010, MT4010, MT4015, MT6020-Pro
CONNECTION DIAGRAM
The communication terminals (RS485) are located at the bottom side of the charge controller
Figure L1 –LUMIAX Charge Controller RS485 Port
Connection Steps
1. Create RJ11 wire as per pinout mentioned in photo L1.
2. The charger is equipped with a RS485 port with RJ11 sockets, the
RJ11 interface is defined as mentioned in Figure L1
3. The communication terminals is located at the bottom of the
section as shown in Figure L1
4. Connect the cables to the RS485 bus terminal blocks.
5. Please make the connections from the Terminal Block chip to
TrackSo IoT Gateway as mentioned in the Table –TL1
Table-TL1
Controller Pin No.
& Assignment
TrackSo Pin No.
& Assignment
3
A
3
D+
4
B
4
D-
Figure L2 –Lumiax RS485 chip connections with TrackSo IoT Gateway
DEFAULT CONFIGURATION IN TRACKSO IOT GATEWAY
Inverter ID: 1, 2, 3, 4 …. Continuous numbering starting with 1, (Range: 1 to 247)
Baud Rate: 9600 (Default) (Values: 9600, 19200, 38400)
Data Bits: 8 , Stop Bit: 1 , Parity: None
CONFIGURATION AT THE CONTROLLER END
Charge Controller is available at Id,1 and baud rate-9600bps and protocol –Modbus RTU by default.
NOTE: The above details are mentioned in the Installation & Operation Manual for Lumiax Solar Charge
Controller
Ce manuel convient aux modèles suivants
6
Table des matières
Autres manuels Lumiax Contrôleurs
Lumiax
Lumiax Smart-DC Series Manuel utilisateur
Lumiax
Lumiax Magicube Series Manuel utilisateur
Lumiax
Lumiax Smart CC Series Manuel utilisateur
Lumiax
Lumiax Shine series Manuel utilisateur
Lumiax
Lumiax Magic Series Manuel utilisateur
Lumiax
Lumiax Smart-DC Series Manuel utilisateur
Lumiax
Lumiax MPPT-DC Series Manuel utilisateur
Lumiax
Lumiax Smart Series Manuel utilisateur
Lumiax
Lumiax SMR1012-DCN5LIG Manuel utilisateur
Lumiax
Lumiax Shine -EU Series Manuel utilisateur
