DKC400 (U) Y SLIDING GATE OPERATOR USER’S MANUAL
3
1. Important safety information
Carefully read and follow all safety precaution and warnings before attempting to install and use
this operator, incorrect installation can lead to severe injury.
The gate operator should be installed by a qualified technician; otherwise, serious personal
injury or property damage may occur.
The auto-reverse function must be checked during installation to ensure that the gate can
auto-reverse in the event of obstruction.
This auto-reverse function should be regularly inspected and adjusted, if necessary.
When opening or closing the gate, do not attempt to walk or drive through the gate.
Children should not be allowed to play near or operate automatic gates.
The automatic gate operator must be grounded.
Install the gate operator on the inside of the property, DO NOT install it on the outside of
the property where the public has access to it.
Be careful when in close proximity to moving parts where hands or fingers could be
pinched.
Do not allow control devices to be placed so that a person can access them by reaching
through the gate.
In the event of power failure, an emergency release key allows you to operate the gate
manually.
The operator should be switched off before repairing it or opening its cover.
Please erase and reprogram the code after installing the operator.
2. Main features
The device is used to drive sliding gate.
For your safety, the DKC400 (U) Y will stop and reverse if it was obstructed on closing and
stop when it was obstructed on opening.
Supports up to 100 remote controls.
User programmable and user erasable remote codes.
Infrared terminal (N.C) is supplied to use.
Auto-close feature is available for this operator.
Pedestrian mode.
Manual key release design for emergency purposes.
3. Main technical parameters
Type DKC400Y DKC400UY
Power supply: AC 220V, 50Hz AC110V, 60Hz
Motor speed 1400 r/min 1680 r/min
Gate moving speed 14m/min (24 teeth)
11m/min (19 teeth)
17 m/min (24 teeth)
13m/min (19 teeth)
Output torque 14N·m
