PAGE 3
PACK 222 KUDOS5.DOC
Mar 97
17. Fit one of the long ribbon cables to the
KUDOS control PCB. Both the cables are
same, but the end are handed differently. Fit
the cable with the end that enables the cable
to point directly downwards. (If you connect
this the wrong way around the cable will be too
short.)
18. Fit the KUDOS control board to the facia with
three M3 screws removed previously. A nylon
insulating bush MUST be fitted under the top
screw to prevent a short-circuit to the adjacent
track. (New screws are included for use if
required, as is an additional insulating bush.)
19. Ensure all the buttons are functioning properly
and clicking audibly, then refit the facia
assembly to the MAJIK/WAKONDA using the two countersunk screws at the ends and the two screws
underneath which were removed earlier.
20. Re-fit the power-on LED connector to the
MAJIK / WAKONDA main PCB. Plug the ribbon
cable from the KUDOS control PCB into the
furthest connector (P6) on the KUDOS main
PCB. Plug the second long ribbon cable into
the other connector (P5) on the KUDOS main
PCB using the end which makes the cable
face forwards, and then plug the other end into
the connector (P8) on the MAJIK/WAKONDA
main PCB. (See photo 6) If the cables are
correctly fitted they will cross-over each other.
Incorrect connection will not cause any
damage, but the control panel will not operate.
21.Disable the sleep function of the
MAJIK/WAKONDA display by fitting a link
(CONN 421) to pins 3 on P11 connector. This
passes the “sleep” control over to the Kudos
board and MUST be fitted.
(See photo 7) Previous board revisions will be different, find the pins markedDISPLAY ON .
22.Re-fit the outer sleeve to the MAJIK/WAKONDA using the four screws
underneath which were removed previously.
23. Power the product up and check that all is working and fully
functioning. Remove the protective tape from the front window.
Installation is complete.
Please note:
The Kudos Sneaky is selected by using the following:
top row of buttons on the Majik front panel
ZONE on the large Linn hand set
WHERE on the KUDOS hand set (when available)
&TUNE%on the Majik hand set (steps up and down
through presets only)
The Tuner input on the Majik is not affected and can be used as an
auxiliary input, by selecting tuner. For further details refer to the
Owners Manual.
Happy listening!
Photo 5
Photo 6
Photo 7
P11 - PINS 3
TOP SCREW
P8
P6
P5
