The Keyfob will sleep within 30 seconds after the last key has been pressed. The next time you press a
key, the Keyfob must obtain system status from the Security Base. This status update may take 2 to 5
seconds to receive, and then the LED will show current LifeShield system status.
After you send a command to the Security Base, the Keyfob must obtain new system status. This will
again take 2 to 5 seconds, and then the LED will update to the new status.
To arm your LifeShield system using the Keyfob, press and hold one of Away or Stay for 2 seconds. Note
that you may only arm your system if current status is Ready to Arm.
If you have turned on Automatic Bypass in the System Settings (using one of the apps), then the Base will
arm the system even if one or more sensors are open (faulted). To disarm your LifeShield system, press
and hold the Off key for 2 seconds.
To use the panic mode, simultaneously press and hold the Away and * buttons.
The * button is for future features and is has no present function when pressed alone.
LED Status
The status LED will only operate while in use (i.e. while pressing keys and for 20 seconds thereafter).
[check on LED colors and insert here]
Batteries
Replace only with [CR2450] battery. The Keyfob will detect a low battery condition and report this via
messaging to the Security Base (and then to your phone if your account has trouble messages enabled).
Warning: the battery polarity must be observed. Improper handling of lithium batteries may result in heat
generation, explosion or fire, which may lead to personal injuries. Replace only with correct batteries.
Batteries must not be recharged, disassembled or disposed in fire. Disposal of used batteries must be in
accordance with the waste recovery and recycling regulations in your area. Keep away from small
children. If batteries are swallowed, immediately see a doctor. California only: The Perchlorate warning
only applies to Manganese Dioxide Lithium batteries sold or distributed in ONLY in California, USA.
Perchlorate Material – special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.
Transmitter and Receiver Specifications
345 MHz, Manchester encoded, 3700 bps
