LG WM2075 Manuel utilisateur

INSTALLATION INSTRUCTIONS

1. To preven in ernal damage during ranspor ,

4 locking bol s are ins alled. Before opera ing

he washer, remove he bol s and braces.

• If hey are no removed, i may cause severe

vibra ion, noise, and malfunc ion.

3. Take ou he 4 bol s and braces by wis ing

he braces sligh ly. Keep he 4 bol s, braces

and he wrench for fu ure use.

• Whenever he appliance is ranspor ed, he

shipping bol s and braces mus be replaced.

2. Unscrew he 4 bol s wi h he wrench supplied. 4. Close he holes wi h he caps supplied.

The appliance is fi ed wi h shipping bol s o preven in ernal damage during ranspor .

■Shipping bolts

Install or store unit where it will not be exposed to temperatures below freezing or

exposed to outside weather conditions.

Properly ground washer to conform with all governing codes and ordinances.

To reduce the risk of electric shock, do not install the washer in humid spaces.

The base opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.

In countries where there are areas which may be subject to infestation by cockroaches or other vermin, pay

particular attention to keeping the appliance and its surroundings in clean condition at all times.

Damage caused by cockroaches or other vermin will not be covered by the appliance warranty.

■Removing shipping bolts

cap

ENGLISH

INSTALLATION INSTRUCTIONS

■Installation clearances

The loca ion mus be large enough o fully open

he washer door.

■Washer dimensions

• Mos ins alla ions require a minimum 4 in.

(10 cm) clearance behind he washer.

■Minimum installation spacing for

recessed area installation.

The following dimensions shown are for he minimum

spacing allowed.

Addi ional spacing should be considered for

ins alla ion and servicing.

• Addi ional clearances migh be required for wall,

door and floor moldings.

• Addi ional spacing of 1 in. (2.5 cm) on all sides of

he washer is recommended o reduce noise

ransfer.

Companion appliance spacing should also be

considered.

■Level floor

• Allowable slope under en ire washer is 1°.

• To minimize noise and vibration, the washer

MUST be installed on a solidly constructed

floor.

• Carpe ing and sof ile surfaces are no

recommended.

• Never ins all he washer on a pla form or weakly

suppor ed s ruc ure.

NOTE: A firm, solid floor is even more critical to a

front-loading washer than to a top-loader.

If your floor is wood and/or frame

construction, you may need to reinforce it.

Front-loaders use substantially faster spin

speeds than top-loaders, causing greater

vibration. If the floor is not solid, your washer

will vibrate. You will hear and feel the

vibration throughout your house.

■Power outlet

• Mus be wi hin 60 in. (1.5 m) of ei her side of he

washer. Do no overload he ou le wi h more

han one appliance.

• Time-delay fuse or circui breaker is recommended.

NOTE: It is the personal responsibility and obligation

of the customer to have a proper outlet

installed by a qualified electrician.

[Front view]

[Side view]

27"

(68.6 cm)

3/4

(75.6 cm)

3811/16"

(98.3 cm)

13/16

(129.1 cm)

/4"

(75.6 cm)

(10 cm)

27"

(68.6 cm)

(2.5 cm)

INSTALLATION INSTRUCTIONS

ENGLISH

• Wa er supply pressure mus be be ween

4.5 and 145 PSI (30~1000 kPa).

• Do no cross hread when connec ing inle hose o

he valve.

• If he wa er supply pressure is more han 145 PSI,

a pressure reducing device should be ins alled.

• Two Sealing washers are supplied wi h he wa er

inle hoses o preven wa er leaks.

• Check for leakage of washing machine connec ions

by urning he ap comple ely on.

• Periodically check he condi ion of he hose and

replace he hose if necessary.

• Make sure ha here is no kink in he hose and ha

i is no crushed.

• Be sure ha he wo wa er inpu por s are connec ed

o he correc wa er fauce s. The connec or for ho

wa er is colored red.

■Connecting water supply hose

NOTE: Washing Machine is to be connected to the water mains using new hoses.

Old hoses should not be used.

■Electrical connection

• Do no use an ex ension cord or double adap er.

• If he supply cord is damaged, i mus be replaced by a qualified person in order o avoid a hazard.

• If he machine will no be used for an ex ended ime, unplug i and shu off he wa er supply.

• Connec he machine o a grounded ou le in accordance wi h curren wiring regula ions.

• The appliance mus be posi ioned so ha he plug is easily accessible.

Repairs to the washing machine must only be carried out by qualified personnel. Repairs carried out by

inexperienced persons may cause injury or serious malfunctioning. Contact your local service center.

Do not install your washing machine in a room where temperatures below freezing may occur.

Frozen hoses may burst under pressure. The reliability of the electronic control unit may be impaired

at temperatures below the freezing point.

If the appliance is delivered in the winter months and temperatures are below freezing,

store the washing machine at room temperature for a few hours before putting it into operation.

INSTALLATION INSTRUCTIONS

■Installation of drain hose

• The drain hose should no be placed higher han

96 in. from he bo om of he washer.

• Properly securing he drain hose will pro ec he

floor from damage due o wa er leakage.

• Place he end of he drain hose in he hole of he

floor drain sys em.

• When ins alling he drain hose a a sink, secure i

so i canno break away and cause flooding and

damage.

• Properly securing he drain hose will pro ec he

floor from damage due o wa er leakage.

This equipment is not designed for maritime use or for mobile installations such as in RV’s, aircraft, etc.

Turn off the faucet if the machine is to be left for an extended period of time (e.g. holiday).

When disposing of the appliance, cut off the power cable, and destroy the plug.

Disable the door lock to prevent young children being trapped inside.

Packaging material (e.g. Films, Styrofoam) can be dangerous for children. There is a risk of suffocation! Keep all

packaging from children.

INSTALLATION INSTRUCTIONS

ENGLISH

■Level adjustment

• Leveling he washing machine properly preven s

excessive noise and vibra ion.

Ins all he appliance on a solid and level floor surface,

preferably in a corner of he room.

• If he floor is uneven, adjus he adjus able fee as

required. (Do no inser pieces of wood, e c. under he

fee .)

NOTE: Extend the feet no more than necessary to level

the washer. The more the feet are extended, the

more the washer will vibrate.

• Make sure ha all four fee are s able and res ing on

he floor and hen check ha he appliance is perfec ly

level (Use a level).

• Af er he washer is level, igh en he lock nu s up

agains of he base of he washer. All lock nu s mus

be igh ened.

• I is cri ical o adjus he fee perfec ly. This mus be

done while he washer is spinning wi h a load. Use he

wrench (supplied) o adjus he fee un il here is no

vibra ion. Then igh en he lock nu s o preven fur her

adjus men .

NOTE: If there are vibration and noise during the spin

cycle, re-check the leveling of the washer, adjust

the feet as required, and tighten the lock nuts

securely to prevent changes in adjustment.

Run the washer with a test load to make certain

your washer is properly leveled. Put

approximately 6 pounds of laundry in the

machine. Then, press POWER, RINSE+SPIN, and

START/PAUSE, in that order. When the machine

spins at high speed, verify that it is stable. If not,

adjust the feet accordingly.

󳢬Diagonal Check

When pushing down the edges of the washing machine

top plate diagonally, the machine should not move up

and down at all. (Please, check both directions.)

If the machine rocks when pushing the machine top plate

diagonally, adjust the feet again.

Adjustable feet Adjustable feet

L ck nut

Adjustable feet

Table des matières

Autres manuels LG Rondelle

LG F81480W Manuel utilisateur

LG F1410SW Manuel utilisateur

LG WD-20900 Manuel utilisateur

LG WD15WGS6 Manuel utilisateur

LG TROMM FR2655NC1Z Manuel utilisateur

LG WF-T8582 Manuel utilisateur

LG WM3997H*A Manuel utilisateur

LG WD-12650TP Series Manuel utilisateur

LG WM8000H series Manuel utilisateur

LG F10U2T/QDN Manuel utilisateur

LG WF-S170V Manuel utilisateur

LG F4J8TS Series Manuel utilisateur

LG TROMM F4999NTNH Manuel utilisateur

LG WD-14311(6)RD Manuel utilisateur

LG Twin Wash System Manuel utilisateur

LG WM2487HRMA - 27in Washing Machine Front Load Manuel utilisateur

LG WD1387FDS Manuel utilisateur

LG WF-T906STG Manuel utilisateur

LG F2V3PYP3WE Manuel utilisateur

LG F4J3TN3WE Manuel utilisateur

LG T1588NEHTE Manuel utilisateur

LG FH0H3NDNL 2 Series Manuel utilisateur

LG WD100C Series Manuel utilisateur

LG WD3250HSA Manuel utilisateur

Manuels Rondelle populaires d'autres marques

Tricity Bendix

Tricity Bendix AW 1000 W Guide produit

Panasonic

Panasonic NA-F60L5WRB Manuel utilisateur

GE WSLP1500 Manuel

Electrolux

Electrolux EWF1284EDW Manuel utilisateur

Bosch

Bosch WAN2829BSN Manuel utilisateur

VESTEL

VESTEL CMH-XL 7510 TE Manuel utilisateur

AEG

AEG 74335 Manuel d'utilisation

Johnson

Johnson JWF721A Manuel utilisateur

Beko

Beko WTE7604XLW0 Manuel utilisateur

Danby

Danby DTT100A1WDB Instructions de montage

Amica

Amica WA 14 Ex Manuel utilisateur

Daewoo

Daewoo DWD-F1222 Manuel utilisateur

Bosch

Bosch WAS28461AU Manuel utilisateur

Miele

Miele PW 6080 Vario Manuel utilisateur

Finlux

Finlux FLX108CF220 Manuel utilisateur

Whirlpool

Whirlpool 3LBR5132AN0 Manuel utilisateur

Beko

Beko WKB 51231 PTMA Manuel utilisateur

Samsung

Samsung WF16J9800K Series Manuel utilisateur