Lexicon PCM 80 Manuel de référence

3 Oak Park Bedford, MA 01730

Tel (781) 280-0300, Fax (781) 280-0499

email: [email protected] SERVICE BULLETIN

PCM80 PCM81 PCM90 PCM91

Please contact LEXICON CUSTOMER SERVICE with any questions.

SBPCM8191_981221_00

Date: January 14, 1999

SUBJECT: Input connector combo-XLR-1/4"TRS jack - discontinued part. P/N 510-

10880,CONN,XLR/JACK,3FC,1/4"TRS,PCRA discontinued.

REFERENCE: ECO 981221-00

DISTRIBUTION: International Pro Product Distributor Service Centers, Customer Service, Repair

CORRECTIVE ACTION: Newly manufactured units will be built with replacement jack, P/N 510-

13799,CONN,XLR/JACK,3FC,1/4TRS,RA,LC at locations J1 and J2. Replace jack, P/N 510-

10880,CONN,XLR/JACK,3FC,1/4"TRS,PCRA at locations J1 and J2 with jack, P/N 510-

13799,CONN,XLR/JACK,3FC,1/4TRS,RA,LC as needed for repair of units manufactured with the

original part and for repair of units manufactured with the new part.

EQUIPMENT REQUIRED:

Clean, well-lighted anti-static workbench with grounded wrist-strap

#1 Phillips Screwdriver

Solder Rework Station

Solder WARNING

Qualified technical personnel should perform this modification. Damage caused by performing this

modification may void the manufacturer's warranty or standard repair policies.

CAUTION

Electrostatic Discharge (ESD) Precautions

The following practices minimize possible damage to ICs resulting from electrostatic discharge or improper insertion.

•Keep parts in original containers until ready for use.

•Avoid having plastic, vinyl or styrofoam in the work area.

•Wear a properly installed anti-static wrist-strap.

•Discharge personal static before handling devices.

•Remove and insert boards with care.

•When removing boards, handle only by non-conductive surfaces and never touch open-edge connectors except at a static-free workstation.*

•Minimize handling of ICs.

•Handle each IC by its body.

•Do not slide ICs or boards over any surface.

•Insert ICs with the proper orientation, and watch for bent pins on ICs.

•Use anti-static containers for handling and transport.

* To make a plastic-laminated workbench anti-static, wash with a solution of Lux liquid detergent, and allow to dry without rinsing.

INSTRUCTIONS:

Note: The profile of the new part is different from the original part. If there is any concern regarding

"cosmetic appearance" if only one connector requires replacement, replace both connectors.

SERVICE BULLETIN

PCM80 PCM81 PCM90 PCM91

Please contact LEXICON CUSTOMER SERVICE with any questions.

SBPCM8191_981221_00

Date: January 14, 1999

Installation of the new connector requires screw, P/N 641-11466,SCRW,TAP,#4X3/8,PNH,PH,BZ,TRI

(quantity - 4) as a substitution for screw, P/N 640-11284,SCRW,M3X8MM,FH,PH,BZ

1. Power down and disconnect power from the unit to be repaired.

2. Remove the top and bottom covers by removing the sixteen-(16) Screw,6-32X3 securing the top

and bottom covers.

3. Remove Scrw,M3x8mm,FH,PH - P/N 640-11284, Qty 2 from the rear panel at the location of the

jack(s) to be replaced.

4. Carefully de-solder jack(s) and remove.

5. Carefully install/solder new jack(s),P/N 510-13799,CONN,XLR/JACK,3FC,1/4TRS,RA,LC

6. Install screw, P/N 641-11466,SCRW,TAP,#4X3/8,PNH,PH,BZ,TRI (qty - 2/jack) at the rear panel

location of the jack.

7. Re-install the top and bottom covers and secure them with sixteen-(16) Screw,6-32X3.

Autres manuels pour PCM 80

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Lexicon Équipement d'enregistrement

Lexicon

Lexicon 300 V3.0 - GUIDE REV 1 Manuel utilisateur

Lexicon

Lexicon OMEGA Manuel utilisateur

Lexicon

Lexicon PCM 81 - REV Manuel utilisateur

Lexicon

Lexicon 960L - ADDENDUM LOGIC7 UPMIX ALGORITHM... Manuel utilisateur

Lexicon

Lexicon LXP-15 Manuel utilisateur

Lexicon

Lexicon MP 110 Manuel utilisateur

Lexicon

Lexicon 960L Manuel utilisateur

Lexicon

Lexicon Super Prime Time Manuel utilisateur

Lexicon

Lexicon 300 V3.0 - GUIDE REV 1 Manuel utilisateur

Lexicon

Lexicon 300 V3.0 - GUIDE REV 1 Manuel utilisateur

Lexicon

Lexicon PCM 91 Manuel utilisateur

Lexicon

Lexicon 200 Manuel utilisateur

Lexicon

Lexicon MX300 Manuel utilisateur

Lexicon

Lexicon LDD-1 Manuel utilisateur

Lexicon

Lexicon DC-2 Manuel utilisateur

Lexicon

Lexicon PCM 80 Manuel utilisateur

Lexicon

Lexicon LXP-15-II Manuel utilisateur

Lexicon

Lexicon Lambda Manuel utilisateur

Lexicon

Lexicon 300L - Manuel utilisateur

Lexicon

Lexicon 960L - REV 1 Manuel utilisateur

Lexicon

Lexicon 960L Manuel utilisateur

Lexicon

Lexicon PCM 91 Manuel utilisateur

Lexicon

Lexicon PCM 80 Manuel utilisateur

Lexicon

Lexicon MC-12 - REV 1 Manuel utilisateur

Manuels Équipement d'enregistrement populaires d'autres marques

KV2 Audio

KV2 Audio 500 Series Manuel utilisateur

Robotics Technologies

Robotics Technologies microBus-Cam II Manuel utilisateur

Seca

Seca 460 Manuel utilisateur

Cognex

Cognex MVS-8000 Series Manuel utilisateur

Mect

Mect MPNC006 Series Manuel utilisateur

Bad Caf

Bad Caf THE LEASH Manuel utilisateur

Strymon

Strymon NIGHTSKY Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manuel utilisateur

Tews Technologies

Tews Technologies TPMC465 Manuel utilisateur

Honeywell

Honeywell Excel 50 Manuel utilisateur

SeaLevel

SeaLevel COMM+8.LPCI Manuel utilisateur

Arturia

Arturia AUDIOFUSE STUDIO Manuel utilisateur

Rukra

Rukra RK-1240 Manuel utilisateur

Samson

Samson SCOM Manuel utilisateur

Dynacord

Dynacord DPS260 Manuel utilisateur

Nice

Nice Core Manuel utilisateur

Pyle Pro

Pyle Pro PSS8 Manuel utilisateur

RF-System

RF-System TinyGate Manuel d'utilisation et d'entretien