Leviton AEHTK Manuel utilisateur

Home Theater Interface Plate

Cat. No.

AEHTK

INSTALLATION INSTRUCTION

DI-000-AEHTK-00A

Left Front Right Front

Surround Left Surround Right

Surround Back Left

6.1/7.1 Surround Connections

Center

Subwoofer

Surround Back Right

7.1 Surround Connections

5.1 Surround Connections

This page to be printed as Blank

OVERVIEW

The Leviton Home Theater Wallplate provides a convenient

method of terminating in-wall speaker wires to installed speakers

and cables from ampliﬁer speaker outputs. The wallplate also

provides for the connection of up to two subwoofers and has two

QuickPorts that can be used for any of the full line of QuickPort

jacks.

INSTALLATION

TO PREWIRE:

1. Install a three-gang low-voltage ring at ampliﬁer location and

a single-gang low-voltage ring at each speaker location (if

speaker bracket requires it).

2. Run a minimum of 16/2 Class 3 speaker wire from Home

Theater Wallplate location to each satellite speaker.

Minimum Gauge Lengths are as follows:

WIRE LENGTH RECOMMENDED SIZE

Up to 50 feet (15 m) 18-gauge

50-150 feet (15-45 m) 16-gauge

Over 150 feet (45 m) 14-gauge

NOTE: The smaller the wire gauge number is, the thicker the

wire is.

3. Run a RG6 quad shielded coax cable from the Home Theater

Wallplate location to each subwoofer location.

TO TRIM-OUT:

1. Connect each speaker cable to the screw terminal connector

on the back of the Home Theater Wallplate that corresponds

to the speaker’s location in the room.

2. Terminate the end of the coax cable at the Home Theater

Wallplate with a Leviton RCA compression connector (p/n

40985-CR*) and plug it into one of the RCA connectors in the

wallplate.

3. At subwoofer location, use a single port QuickPort wallplate

(p/n 40701-BW) and a compression RCA QuickPort Jack

(p/n 40782-REW) to complete connection for subwoofer.

4. Connect ampliﬁer speaker outputs to corresponding spring

post connectors on the Home Theater Wallplate by stripping

approximately one inch of insulation from the speaker wire.

Push in on the spring post until the holes in the post line up

and insert bare portion of wire through the hole and release

spring post. Spring pressure will maintain contact on the

speaker wire.

NOTE: It is not necessary to use all of the connections on the

wallplate. If the system is a 5.1 surround style system, then

only those connections on the wallplate for left front, center,

right front, surround left and surround right, are used.

NOTE: For a 6.1 surround system, the connection labeled

“Surround Back Left” is added for the rear center speaker. To

connect a 7.1 surround system, use all of the spring post

connectors.

5. If the source ampliﬁer has an LFE (Low Frequency Effects)

connection, use an RCA cable to connect it to the RCA jack in

the Home Theater Wallplate the subwoofer is connected to.

Otherwise, use the subwoofer output (refer to the owners

manual for the ampliﬁer being used) for this connection.

6. Use an RCA patch cord to connect the subwoofer to the wall

plate at the subwoofer location.

WIRING DIAGRAM EXAMPLE

Left Front Right Front

Surround Left Surround Right

Surround Back Left

6.1/7.1 Surround Connections

Center

Subwoofer

Surround Back Right

7.1 Surround Connections

5.1 Surround Connections

Left Front Center Right Front

Surround Left Surround Right

5.1 Surround Amplifier

Front View

WIRING DIAGRAM EXAMPLE

Rear View

Left Front

Right Front

Center

Surround

Left

Surround

Right

Surround

Back

Left

Surround

Back

Right

Left Front

Right Front

Surround

Left

Surround

Right

Surround

Back

Left

Center

Surround

Back

Right

This page to be printed as Blank

For additional information, contact Leviton’s Techline at

1-800-824-3005 or visit Leviton’s website at www.leviton.com

LIMITED 5 YEAR WARRANTY AND EXCLUSIONS

Leviton warrants to the original consumer purchaser and not for the beneﬁt of anyone

else that this product at the time of its sale by Leviton is free of defects in materials

and workmanship under normal and proper use for ﬁve years from the purchase date.

Leviton’s only obligation is to correct such defects by repair or replacement, at its

option, if within such ﬁve year period the product is returned prepaid, with proof of

purchase date, and a description of the problem to Leviton Manufacturing Co., Inc.,

Att: Quality Assurance Department, 59-25 Little Neck Parkway, Little Neck, New

York 11362-2591. This warranty excludes and there is disclaimed liability for labor for

removal of this product or reinstallation. This warranty is void if this product is installed

improperly or in an improper environment, overloaded, misused, opened, abused,

or altered in any manner, or is not used under normal operating conditions or not in

accordance with any labels or instructions. There are no other or implied warranties

of any kind, including merchantability and ﬁtness for a particular purpose, but

if any implied warranty is required by the applicable jurisdiction, the duration of any

such implied warranty, including merchantability and ﬁtness for a particular purpose,

is limited to ﬁve years. Leviton is not liable for incidental, indirect, special, or

consequential damages, including without limitation, damage to, or loss of use

of, any equipment, lost sales or proﬁts or delay or failure to perform this warranty

obligation. The remedies provided herein are the exclusive remedies under this

warranty, whether based on contract, tort or otherwise.

DI-000-AEHTK-00A

This page is NOT to be printed in the booklet

DOCUMENTATION

LEVITON INSTRUCTION SHEET/MANUAL

SPECIFICATIONS

KKC 04/05/06

Helvetica

DI-000-AEHTK-00A

Black

N/A

Final fold size:

50 lb. offset

Overall size:

8.0" x 6.0" printer spread-8 pages

4.0" x 6.0" folded size (saddle)s

Paper size:

4.0"

6.0"

FINAL SIZE

Cat. No.

OVERALL SIZE

8.0"

6.0"

Table des matières

Autres manuels Leviton Accessoires

Leviton

Leviton OSSMT-GD Manuel utilisateur

Leviton

Leviton ODS0D-TD Instructions d'installation

Leviton

Leviton 0SFHU-I4W Manuel utilisateur

Leviton

Leviton decora LEVODS15TDW Manuel utilisateur

Leviton

Leviton OSW12-M0W Manuel utilisateur

Leviton

Leviton 1x6 Passive Audio Module Manuel utilisateur

Leviton

Leviton OSC05-U0W Manuel utilisateur

Leviton

Leviton decora smart DW15R Manuel utilisateur

Leviton

Leviton QuickPlate 5EA20-1 Manuel utilisateur

Leviton

Leviton DOD05 Manuel utilisateur

Leviton

Leviton OSC05-M0W Manuel utilisateur

Leviton

Leviton Lev-Lok M56AA Manuel utilisateur

Leviton

Leviton OSSMD-FT Manuel utilisateur

Leviton

Leviton LDC Series Manuel utilisateur

Leviton

Leviton 31A00-8 Manuel utilisateur

Leviton

Leviton OFDUZ Manuel utilisateur

Leviton

Leviton OSW12-M Manuel utilisateur

Leviton

Leviton Decora ODS0D-TDx Manuel utilisateur

Leviton

Leviton OSM3D-DDW Manuel utilisateur

Leviton

Leviton Decora ODS15-IDx Manuel utilisateur

Leviton

Leviton OSC05-M Manuel utilisateur

Leviton

Leviton Decora ODS10-IDx Manuel utilisateur

Leviton

Leviton ACP15-CB Manuel utilisateur

Leviton

Leviton OSSMT-MDx Manuel utilisateur

Manuels Accessoires populaires d'autres marques

Hillco

Hillco 2810 Manuel utilisateur

Siemens

Siemens QSA2700D Manuel de l'opérateur

Contours

Contours ZY024 Manuel utilisateur

Saivod

Saivod VS621 Manuel utilisateur

Virtuox

Virtuox VirtuCLEAN 2.0 Manuel utilisateur

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuel utilisateur

Z-Wave

Z-Wave HSD-200Z Manuel utilisateur

turck

turck FMX-IM-2UPLI63FX Manuel utilisateur

Decagon Devices

Decagon Devices 10HS Manuel utilisateur

UPPAbaby

UPPAbaby Cup Holder Manuel utilisateur

Elko

Elko SmartSensor Leakage Wireless Manuel utilisateur

Grizzly

Grizzly H8371 Manuel utilisateur

Panasonic

Panasonic HG-T Series Manuel utilisateur

IFM Electronic

IFM Electronic Efector 250 Series Guide de référence

DigiDesign

DigiDesign 888/24 I/O Manuel utilisateur

PROZIS

PROZIS QUAY Manuel utilisateur

patagonia

patagonia PSI Vest Manuel utilisateur

SFC Energy

SFC Energy EFOY GO! Manuel utilisateur