LevelOne WAP-0002 Manuel utilisateur

LevelOne

WAP-0002

22Mbps Wireless Access Point

User’s Manual

Version: 1.0

Manufacturer's Disclaimer Statement

The information in this document is subject to change without notice and does not

represent a commitment on the part of the vendor. No warranty or representation,

either expressed or implied, is made with respect to the quality, accuracy or fitness for

any particular purpose of this document. The manufacturer reserves the right to

make changes to the content of this document and/or the products associated with it at

any time without obligation to notify any person or organization of such changes. In

no event will the manufacturer be liable for direct, indirect, special, incidental or

consequential damages arising out of the use or inability to use this product or

documentation, even if advised of the possibility of such damages. This document

contains materials protected by copyright. All rights are reserved. No part of this

manual may be reproduced or transmitted in any form, by any means or for any

purpose without expressed written consent of its authors. Product names appearing

in this document are mentioned for identification purchases only. All trademarks,

product names or brand names appearing in this document are registered property of

their respective owners.

FCC STATEMENT

This product has been tested and complies with the specifications for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used according to the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which is found by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

lReorient or relocate the receiving antenna

lIncrease the separation between the equipment or devices

lConnect the equipment to an outlet other than the receiver’s

lConsult a dealer or an experienced radio/TV technician for assistance

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator

and your body.

Table of Contents

TABLE OF CONTENTS.............................................................................................3

INTRODUCTION........................................................................................................4

PRODUCT FEATURES.................................................................................................... 4

SYSTEM REQUIREMENTS............................................................................................. 5

GETTING STARTED..................................................................................................6

GETTING TO KNOWTHE LEVELONE WAP-0002........................................................ 6

WIRELESSACCESSPOINT’SPORTs..................................................................6

WIRELESSACCESS POINT’SLEDs....................................................................6

CONNECTINGTHE WIRELESSACCESS POINT .............................................................. 6

CONFIGURING YOUR LEVELONE WAP-0002 ...................................................8

CONFIGURATION MENU ...................................................................................... 9

Status Page...........................................................................................................11

Basic Setting.........................................................................................................12

IP Setting..............................................................................................................14

Advanced Setting..................................................................................................16

Security.................................................................................................................19

Tools .....................................................................................................................22

USING AP 22M UTILITYFOR MANAGEMENT................................................24

INSTALLINGAP 22M UTILITY...................................................................................24

MANAGE ANDCONFIGUREAPWITHAP 22M UTILITY..............................................28

Link Information..................................................................................................29

AP Setting.............................................................................................................30

IP Setting..............................................................................................................32

WEP Setting .........................................................................................................33

APPENDIX A: TROUBLESHOOTING..................................................................34

APPENDIX B: NETWORKING BASIS..................................................................40

APPENDIX C: GLOSSARY.....................................................................................54

APPENDIX D: TECHNICAL SPECIFICATION ..................................................59

INTRODUCTION

The LevelOne WAP-0002 Wireless Access Point deliversenhanced IEEE 802.1b

high performance for up to 22Mbps, which is double of that offered by most of the

Access Points in the current market.

The 22Mbps high date rate is made possible by utilizing advanced TI technology,

which incorporates the new PBCC for modulation method. Unlike the ordinary CCK

modulation, not only the new PBCC modulation method offers double data rate for up

to 22Mbps, but also it gives 20% more distance coverage.

The LevelOne WAP-0002 is fully compatible with other 11Mbps wireless devices.

The easy-to-use web based configuration utility is independent of operation systems,

and can be accessed through most of the web browsers that are Javascript enabled.

The enhanced functions offered by the Wireless Access Point, e.g., DHCP server and

4 different operation modes, allow the users to share resources and information, e.g.,

files and printers, and enjoy the freedom of networking wirelessly.

The LevelOne WAP-0002 is an ideal wireless device for SOHO and small office,

which can also be integrated to large networks as well. Please take a moment to read

through this manual and get acquaintedwith our 22mpbs Wireless Access Point.

Product Features

¦Fully compatible with IEEE 802.11b standard for wireless and 802.3 for LAN

connection.

¦Interoperatable with existing IEEE 802.11b standard devices.

¦Supports new data modulation PBCC technology from Text Instrument, which

allows high data with double speed of right up to 22Mbps.

¦20% more transmitting and receiving coverage supported by PBCC modulation.

¦Supports auto data rate fallback under noisy environment or longer distance.

¦Enhanced security on WEP encryption from 64, 128 to a maximum of 256 bits.

¦Built-in DHCP server

¦4 AP operating modes available to fulfill your needs:

1. AP

2. AP Client

3. AP Bridge (Point-to-Point and Multi-Point)

4. Repeater

¦Easy setup andinstallation with web-based configuration utility.

¦AP management utility running on PC to make it easy to manage and configure

all the AP in the same network.

System Requirements

¦Windows 95, 98, 98SE, Millennium, NT, 2000 and XP computers

¦Internet Explorer 5.5 or higher

¦One CD-ROM drive

¦At least one RJ-45 Ethernet network adapter installed

GETTING STARTED

Getting To Know The LevelOne WAP-0002

WIRELESS ACCESS POINT’S PORTs

ØPower Receptor

ØReset Button

ØMDII RJ-45 Ethernet Port

-Straight-Through cable is required to connect with router or switch.

-Cross-Over cable is required to connect to computer directly

WIRELESS ACCESS POINT’S LEDs

ØPower LED

ON when the unit is powered up

ØLAN LED

ON indicates LAN connection; blink indicates LAN activity

ØWLAN LED

ON indicates WLAN connection; blink indicates wireless activity

Connecting The Wireless Access Point

Internet

ADSL/Cable Modem

SOHO Router

Wireless Station

Mobile PDA

22Mbps

Access Point

Wireless

Network

In order to setup an Infrastructure of a wireless networksuch as the example shown

above, you will need the following:

1. A broadbandInternet connection.

2. ADSL or Cable modem provided by your ISP as part of the broadband connection

installation.

3. A Router that connects to the ADSL/Cable modem for internet connection sharing.

4. An Access Point to connect with the Router to form a wireless infrastructure

network.

5. Wireless clients equippedwith wireless networking devices such as wireless PC

Card for wireless connection.

CONFIGURING YOUR LevelOne WAP-0002

The web-based configuration menu provides user friendly graphic design for easy

configuration. Please go through the following check list before you consider using

the configuration menu.

1. You will need a JavaScript enabled web browser such as Internet Explorer v5.5

or higher and Netscape v4.0 or higher.

2. The Ethernet network adapter must be working properly. Please refer to

Troubleshooting section for details.

3. If you are connecting the Access Point through a router or a local area network,

which has DHCP server enabled, you will not need to assign a static IP address

to the computer that you are using to configurethe Access Point. Please go to

check item no. 6

4. If you are not connecting the Access Point through a router or a local area

network, which has DHCP server enabled, you will need to assign a static IP

address to the computer that you are using to configure the Access Point.

5. The IP address assigned to the computer that you are using to configure the

Access Point must be in the same IP address range as Access Point’s. Please

refer to Networking Basis section to learn more about assigning IP address.

6. The power jack must be properly inserted to make sure that the Access Point is

powered.

The Default Settings of the 22Mbps Access Point:

IP Address 192.168.1.1

User Name admin

Password admin

ESSID wireless

Channel 6

WEP disabled

CONFIGURATION MENU

You can access the configuration menu anytime by opening up an web browser

window, and type in the IP address of the Access Point. The default IP address of the

Access Point is shown below.

!Note: The IP address shown above is the default IP address for the Access Point.

Use this IP address when connecting to a network consisting of Access Points set to

default settings. If the IP address of the Access Point is being changed to comply

with the network, then type in the IP address in the Address field of the web browser,

instead of the default IP address.

!Note: The default username is “admin”and the default password is also “admin”.

Open web browser

window

Type in IP address

Press “Enter”or

“Go”

Type in “user name”

Type in “password”

Click “OK”

The configuration menu will appear. You can configure and get information about

the Access Point by going through each tab. Here Status page is displayed.

Table des matières

Autres manuels LevelOne Point d'accès sans fil

LevelOne

LevelOne WAP-0005 Manuel utilisateur

LevelOne

LevelOne WAP-1001 Manuel utilisateur

LevelOne

LevelOne WAB-7400 Manuel utilisateur

LevelOne

LevelOne WAB-5120 Manuel utilisateur

LevelOne

LevelOne WAP-8021 Manuel utilisateur

LevelOne

LevelOne WAP-6202 Manuel utilisateur

LevelOne

LevelOne WAP-6003 Manuel utilisateur

LevelOne

LevelOne WAP-6102 Manuel utilisateur

LevelOne

LevelOne WAP-6101 Manuel utilisateur

LevelOne

LevelOne OAN-4058 Manuel utilisateur

LevelOne

LevelOne WAB-1000 Manuel utilisateur

LevelOne

LevelOne WAB-3003 Manuel utilisateur

LevelOne

LevelOne WAP-3000 Manuel utilisateur

LevelOne

LevelOne WAP-6121 Manuel utilisateur

LevelOne

LevelOne PLI-3411 Manuel utilisateur

LevelOne

LevelOne EAP-300 Manuel utilisateur

LevelOne

LevelOne WAB-5010 Manuel utilisateur

LevelOne

LevelOne WAP-6110 Manuel utilisateur

LevelOne

LevelOne WAP-6110 Manuel utilisateur

LevelOne

LevelOne WAP-6117 Manuel utilisateur

LevelOne

LevelOne WAP-6013 Manuel utilisateur

LevelOne

LevelOne WAP-6121 Manuel utilisateur

LevelOne

LevelOne WBR-2400TX Manuel utilisateur

LevelOne

LevelOne WAP-8221 Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Ubiquiti

Ubiquiti NanoStation NSM2 Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

TP-Link

TP-Link AP9650 V1 Manuel utilisateur