Tamper
GPO1
GPO2
GND
B/RX
A/TX
GND
DC+
CP
D1 Clock
D0 Data
GND
G-LED
R-LED
BZ CTRL
K-LED
Tamper output
General purpose I/O
General purpose I/O
Ground
RS485 - / OSDP
RS485 + / OSDP
Power supply
Power supply 9 - 30 VDC
Card Present
Wiegand Data1/Clock/Data, ABA 2
Wiegand Data0/Clock/Data, ABA 2
Ground
External Green LED control
External Red LED control
External Buzzer control
External keypad LED control
PIN Description
Description
Wiegand
Wiegand
x
-
-
-
-
-
x
x
-
x
x
-
x
x
x
x
Terminal description
RS485/
OSDP
RS485/
OSDP
Clock/
Data
Clock/
Data
-
-
-
-
x
x
x
x
-
-
-
-
-
-
-
-
-
-
-
-
x
x
x
x
x
-
-
-
-
-
-
-
P2
P1
PIN
K-LED
BZ CTRL
R-LED
G-LED
GND
D0 Data
D1 Clock
CP
Tamper
GPO1
GPO2
GND
B/RX
A/TX
GND
DC+
P1
P2
Tamper
GPO1
GPO2
GND
B/RX
A/TX
GND
DC+
P1 P2
CP
D1 Clock
D0 Data
GND
G-LED
R-LED
BZ CTRL
K-LED
Quick Installation Guide
Lenel Readers - 5000 Series Standard 13,56MHz
Lenel Readers - 5000 Series Standard 13,56MHz/125kHz
Quick Installation Guide
Lenel Readers - 5000 Series
Slimline 13,56MHz
Please note that this is only a quick installation guide.
Information regarding recommendations, measurements and accessories are
available in the full version of the Lenel Readers - 5000 Series installation guide.
1 Current draw does not include heater consumption.
2 LED settings; LED Bar = Low, Back Light = Low
Please consult table in full installation manual for more information on heater
consumption settings and how the LED-settings will aect current draw.
Power consumption:
Notes
1. Maximum wiegand cable length is 150 meters and requires a high quality
shielded cable with minimum AWG18 dimension (=0.8231mm2) in an environment
free from electrical noise. A cable with smaller dimension or an installation
environment with electrical disturbances will reduce the maximum cable length.
2. Wiegand & Clock/Data requires dedicated wires for external control of Green
LED, Red LED, Buzzer and Keypad backlight.
3. When utilizing the GPI/O’s, each respective GPO1 or GPO2 must be connected
to each respective pin and also to GND. The general purpose input/output will only
be activated if so applied in the reader configuration.
4. RS 485/OSDP requires twisted pair cable.
Model Current draw (idle1) Current draw (peak1,2)
12V 24V 12V 24V
Standard 13.56MHz 50 mA 40 mA 147 mA 99 mA
Combi 13.56MHz/125kHz 90 mA 60 mA 187 mA 119 mA
Slimline 13.56MHz 50 mA 40 mA 164 mA 108 mA
