Lec+ R50263W Manuel utilisateur
LEC R50263W
User Manual
LEC Customer Care
Please keep this handbook in a safe place.
Please fill in the model number and serial number in the spaces provided
below as they will assist us should you need to call.
0844 815 3737
When you dial this number you will hear a recorded message and be given a
number of options. This indicates that your call has been accepted and is
being held in a queue. Calls are answered in strict rotation as our Customer
Care Representatives become available.
Enter appliance numbers here for future reference:
These numbers can be found on your appliances.
Outside the UK and Northern Ireland, refer to your local supplier.
Stoney Lane, Prescot, Merseyside, L35 2XW
Mo del No
Serial No
Specification of the appliance
Voltage:220V-240V
Frequency:50Hz
Refrigerant:R600a
Rated Current:0.6A
Lamp Power: 10W
Insulation Blowing Agent:Cyclopentane
Description of the Appliance
1
2
3
4
5
1. Freezer Box – 2 Star Rating
2. Thermostat Control, Interior Light
3. Interior Glass Shelf x 1
4. Salad Crisper Box with Glass Shelf
5. Door Storage – Specific Areas for Bottles &
Dairy Products
(Picture shown for indicative purposes only, model supplied may
differ).
CONTENTS:
Section 1. Installation
Section 2. Safety Advice
Section 3. Operating the Appliance
Section 4. Maintenance
Section 5. Warning
Section 1. Installation
IMPORTANT! This appliance must be left to stand in
an upright position for at least 4 hours before being
switched on for the first time.
Remove all packaging and securing tape from the
appliance.
Wash the interior of the appliance with luke warm
water containing a small amount of bicarbonate
soda (5ml to 0.5 litres of water).
Position the appliance in a dry atmosphere and
out of direct sunlight.
Do not position next to a cooker or other
sources of heat, i.e. radiator.
If positioned next to another fridge or freezer, leave a
minimum gap of 2cm between the appliances in
order to avoid condensation.
A clearance of 50mm should be left above the
appliance. If this cannot be achieved you should
ensure a clearance of 25mm is maintained on each
side of the appliance.
Please ensure that there is a small ‘air-gap’ between
the condenser on the rear of the appliance and the
rear wall.
Do not place or store heavy items on the top of this
appliance.
Ensure that the appliance is positioned on a firm flat
floor.
This appliance must be level. Adjust the level by
screwing the adjustable feet up or down (use your
fingers or a suitable spanner).
Ensure that the appliance is upright and both feet
are in firm contact with the floor so that the cabinet
is stable.
Connect the plug to an adjacent 13amp socket
outlet and ensure that the appliance is not standing
on the supply cable.
Section 2. Safety Advice
Please read this booklet thoroughly before
installing and switching on the appliance. The
manufacturer accepts no responsibility for incorrect
installation and usage.
If this appliance is to replace an old refrigerator
with a lock, as a safety measure break or
remove the lock and/or door before disposal.
Your old appliances contain insulation gases
and refrigerant that must be disposed of correctly.
Please ensure that the refrigerant circuit is not
damaged before the appliance is taken away for
correct disposal in line with current legislation. If
there is any doubt contact your Local Authority for
instructions.
This appliance may contain the refrigerant
isobutene (R600a). This is a natural gas with a high
level of environmental compatibility; however,
caution is required as isobutene is a flammable gas.
It is essential to ensure that refrigerant tubes are not
damaged during transportation and the installation of
the appliance.
In the event that the refrigerant circuit is damaged,
avoid naked flames or sources of ignition and
ventilate the room in which the appliance is situated.
Do not damage the refrigerant circuit.
Do not allow children to play with the appliance.
Children must never play in or around the appliance.
If using an adaptor, this must be used in
accordance with the manufacturers instructions and
ensure that the electrical circuit is not overloaded as
this could cause overheating.
Do not twist or bend the cables, and keep
them away from hot surfaces.
Do not plug ın or unplug this appliance with
wet hands.
Following installation make sure that the power
cable is not trapped underneath the appliance.
If the power supply cord is damaged, it must
be replaced by the manufacturer, it’s service agent
or similarly qualified persons in order to avoid a
hazard.
Section 3. Operating the Appliance
3.1. Switching on the Appliance
Allow the appliance to stand for a minimum of 4
hours after installation. Plug in the appliance and
switch on at the mains supply.
Set the thermostat control to the required setting as
detailed in the Temperature Control section (3.2.).
Leave the appliance for approximately 4 hours for the
correct temperature to be reached.
Place the appliance close to the wall with a distance
not exceeding 75mm
3.2. Temperature Control
The temperature selector knob is located on the right
hand side of the inner cabinet (see Description of the
Appliance on page 4). Please note that a larder fridge
does not have an ice-box and will operate at a slightly
higher temperature than a fridge with an ice-box.
Setting “0”: Unit Off
Setting “1”: Unit On – Warmest Temperature
Setting “3” to ”4”: Normal Operation
(adequate for most situations)
Setting “5”: Coldest Temperature
Important!
During high ambient temperatures e.g. on hot summer
days, it may be necessary to set the thermostat to the
coldest setting (position 5). This may cause the
compressor to run continuously in order to maintain a low
temperature in the cabinet.
3.3. Storing & Freezing Food in the Freezer-Box
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels Lec+ Réfrigérateur
Lec+
Lec+ BC6097K Manuel utilisateur
Lec+
Lec+ TL6015W Manuel utilisateur
Lec+
Lec+ L5017W Manuel utilisateur
Lec+
Lec+ T5576W Manuel utilisateur
Lec+
Lec+ TF6096W Manuel utilisateur
Lec+
Lec+ PE 507 Manuel utilisateur
Lec+
Lec+ TF50152W Manuel utilisateur
Lec+
Lec+ IST 47 Manuel utilisateur
Lec+
Lec+ TNF55187W Manuel utilisateur
Lec+
Lec+ CL 157 Manuel utilisateur
Lec+
Lec+ R6014W/S Manuel utilisateur
Lec+
Lec+ R5006W Manuel utilisateur
Lec+
Lec+ PE 907 Manuel utilisateur
Lec+
Lec+ TS55184W Manuel utilisateur
Lec+
Lec+ L1414Z Manuel utilisateur
Lec+
Lec+ TS50152W Manuel utilisateur
Lec+
Lec+ L5511W Manuel utilisateur
Lec+
Lec+ TU55142W Manuel utilisateur
Lec+
Lec+ RST6057I Manuel utilisateur
Lec+
Lec+ 444443640 Manuel utilisateur
