3 Optional: Route a cable (H05RN-F, 2 x 0.5) for the immobiliser in the vehicle
and connect it to the specific vehicle installation (control module or sim-
ilar).
ðThe unit is now ready to be connected.
Connecting the Supply Unit
To connect the device, proceed as follows:
4 Pierce the housing seal at the intended location with a
pointed tool.
5 Feed the connection cable (H07RN-F, 3 x 2.5) through
the hole.
6 Connect the wires of the connection cable to the cor-
responding screw terminals.
ðThe device is connected.
Optional: Connecting the Immobiliser
NOTE
The MelfBox has a potential-free switching contact (normally open
contact) to create an immobiliser.
The design of the immobiliser depends on the vehicle. Inquire
from your vehicle manufacturer.
To connect the immobiliser, proceed as follows:
CAUTION!Install a suitable fuse in the vehicle (up to 1A).
7 Insert the immobiliser cable (H05RN-F, 2 x 0.5) through
the second hole of the housing seal.
8 Insert the wires of the immobiliser cable into the push-
in terminals (max. current: 1A).
ðThe immobiliser is connected.
9LEAB Automotive GmbH Thorshammer 6 24866 Busdorf
LEAB Automotive GmbH 6 Installation
