3
EN
Dear customer,
Thank you for choosing a LAUFEN bathtub with whirl system.
Each bathtub with whirl system has been individually tested and must meet strict technical requirements, guaranteeing the quality of the
materials used and the functioning of all the components.
In this user manual, you will find instructions, tips and suggestions which will help you to get the most out of your bathtub with whirl sys-
tem. It is recommended that you read this manual carefully. If you require any further information, please contact your LAUFEN distribu-
tor.
General comments
For the installation of your bathtub with whirl system, please follow the mounting instructions which were provided separately to this
user manual. The water massage system must be supplied with sufficient ventilation. If the bathtub is installed with a panel, a gap of at
least 10mm must be left between the panel and the floor. This gap may not be blocked with towels, bath mats or similar since it guar-
antees perfect ventilation.
Safety
While installing the bathtub, a series of simple steps must be followed in order to prevent possible accidents. The installation must be
carried out by qualified technicians. Please follow the instructions included in the installation manual that has also been provided with
the bathtub. The bathtub must be connected to a voltage of 230V AC at 50Hz. The appliance must be supplied through a residual
current device (RCD), having a rated residual operating current that does not exceed 30mA. Additionally, the electrical installation
should be equipped with an electrical switch to ensure all-pole disconnection from the power supply. An equipotential connection must
be made between the metallic elements of the bath, in accordance with the corresponding regulations of each country.
Warning
• Let out the water after each bath.
• People with limited mobility should take extra care when using the bathtub with whirl system.
• Small children should not be allowed to use the whirlpool unless they are properly supervised.
• Use only diluted essences, perfumes and bath salts. Employ only products that are specifically approved for bathtubs with whirl
systems.
• Regular disinfection guarantees hygienic bathing:
- First disinfection: a first disinfection is to be run before using the whirlpool bath for the first time.
- Recommended regular disinfection cycle: after using the bath 3 times, run the disinfection procedure (regular germ killing).
- After a long period of non-use: after about 3 weeks of non-use of the whirlpool bath, it should likewise be disinfected before reuse.
• Parts containing live components, except parts supplied with safety extra-low voltage not exceeding 12V, must be inaccessible to a
person in the bath.
• Parts incorporating electrical components, except remote control devices, must be located or fixed so that they cannot fall into the
bath.
• The RCD of the electrical installation has to be tested according to guidance of testing and resetting.
• Please make sure that all manuals delivered with the bathtub will be available to subsequent owners and users.
• The bathtub has to be set up or repaired only by installers who can demonstrate to the appropriate authorities awareness and com-
petence in the application of National Regulatory requirements for safety, i. e. electrical and water supply/disposal.
• The use of a whirlpool bath can lower the blood pressure and stimulate circulation. Persons with circulatory problems should there-
fore firstly ask their family doctor, who can give tips as to the best way of using the bath.
• Do not stare directly at operating lamp. May be harmful to the eyes.
General Information
