Larson Electronics EPLC2-EMG-HB-150LED-RT Manuel utilisateur

EPLC2-EMG-HB-150LED-RT

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

- EPLC2-EMG-HB-150LED-RT-

Instruction Manual

Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this

instruction sheet. Read carefully before operating. Retain these instructions for future reference.

WARNING:

This fixture is not factory sealed.

This fixture is designed to be used in a explosion proof environment.

Ensure periodic inspections to be sure that the fixture is still fully functional.

To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and maintained by a

qualified electrician only in accordance with all applicable electrical codes.

Be certain electrical power is OFF before and during installation and maintenance.

Luminaire must be connected to a wiring system with an equipment-grounding conductor.

Make sure the supply voltage is the same as the rated luminaire voltage.

The technical data indicated on the LED luminares are to be observed.

Changes of the design and modifications to the LED luminare are not permitted.

Observe the national electrical safety rules and regulations during installation.

Installing the EPLC2-EMG-HB-150LED-RT.

This EPLC2-EMG-HB-150LED-RTcomes preconfigured with a backup battery and two run configurations. The light can

be wired to accommodate Incoming Power while not emitting any visible light until the incoming power is stopped. IE:

Emergency Only Mode. However, the light also can be wired to provide visible light with or without incoming power. This

ensures that the light will operate in all conditions. IE: Backup Supported Mode

1. Emergency Only Mode Instructions –Wire the “Neutral”, “Hot”, and “Ground”wires normally. Leave the “Switch”

wire unconnected and terminated.

2. Backup Supported Mode –Wire the “Neutral”, “Hot”, and “Ground”wires normally. Wire the “Switch”wire in with

the “Hot”wire.

*For detailed instruction or clarification please call Larson Electronics at 1-800-369-6671.

EPLC2-EMG-HB-150LED-RT

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

OPERATION

During normal operation, AC power is supplied to the AC ballast/driver through the backup micro inverter and the inverter

charges the battery. Connecting the inverter connector wires (red and white) enables the emergency circuit and supplies

power to the control/monitor circuit. The backup micro inverter detects AC input line voltage (120/277) and automatically

sets the output voltage during emergency mode.

When AC power fails, the backup micro inverter automatically switches to emergency mode, keeping the load illuminated

for a minimum of 90 minutes. When AC power is restored, the backup micro inverter returns to charging mode. The

backup micro inverter consists of a low-battery voltage disconnect which is reset when AC power is restored. The unit can

also detect an abnormal load condition (open or shorted load) during emergency mode operation and will protect the

inverter from damage.

MAINTENANCE

Although no routine maintenance is required to keep the backup micro inverter functional, it should be checked

periodically to ensure that it is working .The following schedule is recommended:

1. Visually inspect the charging indicator light monthly. It should be illuminated.

2. Test the emergency operation of the fixture at 30-day intervals for a minimum of 30 seconds. The lam p

should operate at full illumination.

3. Conduct a 90-minute discharge test once a year. The lamp should operate at full illumination f or at

least 90 minutes.

!!!! REFER ANY SERVICING INDICATED BY THESE CHECKS TO QUALIFIED PERSONNEL !!!!

REPLACEMENT PARTS

The EPLC2-EMG-HB-150LED-RTis designed to provide years of reliable lighting performance. Should the need

for replacement parts arise, please contact Larson Electronics at the contact information below.

Should further information not covered by these instructions be required, please contact Larson Electronics at

1-800-369-6671 or sales@larsonelectronics.com for further assistance.

Please visit LarsonElectronics.com for Warranty and Return information.

Table des matières

Autres manuels Larson Electronics Équipement d'éclairage

Larson Electronics

Larson Electronics LEDLB-12ET-IR-M Manuel utilisateur

Larson Electronics

Larson Electronics EPL-FL26-LED Series Manuel utilisateur

Larson Electronics

Larson Electronics EPL-PM-150LED Manuel

Larson Electronics

Larson Electronics EPLC2-HB-150LED-RT-CM Manuel utilisateur

Larson Electronics

Larson Electronics EPL-16C-150LED-RT Manuel utilisateur

Larson Electronics

Larson Electronics EXP-EMG-EXT-LE6-3L Manuel utilisateur

Larson Electronics

Larson Electronics TPM-2XWP60E-25C Manuel utilisateur

Larson Electronics

Larson Electronics PTB-1-50FT Manuel utilisateur

Larson Electronics

Larson Electronics IND-HVAC-DTW-XX-SP0108-120W Manuel utilisateur

Larson Electronics

Larson Electronics EPL-FL1524-100 Manuel utilisateur

Larson Electronics

Larson Electronics LED10W-1X4LT Manuel utilisateur

Larson Electronics

Larson Electronics IND-LP-SS-24-2X2-2L-UVC Manuel utilisateur

Larson Electronics

Larson Electronics LM-25-3S-EW-THM-12VDC Manuel utilisateur

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-JB2-25-BCE Manuel utilisateur

Larson Electronics

Larson Electronics EPL-LED-150W-RT-SS-HC Manuel utilisateur

Larson Electronics

Larson Electronics LEDP5W-60XC-1227 Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-EB Manuel utilisateur

Larson Electronics

Larson Electronics HAL-16C-185LED-CPR-100 Manuel utilisateur

Larson Electronics

Larson Electronics WAL-ML-2XM-3G Manuel utilisateur

Larson Electronics

Larson Electronics EPL-TL-1X10W-C-PA-XFSW Manuel utilisateur

Larson Electronics

Larson Electronics GSLEDIP6-C1D2 Manuel utilisateur

Larson Electronics

Larson Electronics HAL-RSL Series Manuel utilisateur

Larson Electronics

Larson Electronics WAL-HL-2000W-240V Manuel utilisateur

Larson Electronics

Larson Electronics EPL-16BS-1X150LED-25 Manuel

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur