Larson Electronics EXP-LED-FX2R-2M Mode d’emploi

I. Installation & Operation - EXP-LED-FX2R-2M

I. Operation

Momentary Mode:

Lightly press the top body switch for

momentary operation. Release the switch to

turn the light off.

Constant-On Mode:

Press the top body switch until it clicks and

then release for constant-on mode. Press

and release the top body switch again to turn

the light off.

Floodlight Mode:

Press the bottom body switch until it clicks

and then release for oodlight mode. Press

and release the bottom body switch again to

turn the light off.

Dual-Light Mode:

Dual-Light allows the user to turn on both the

ashlight and the oodlight, at the same time.

Press the top body switch until it clicks and

then release for constant-on mode ashlight

Mode. Next press and release the bottom

switch to activate the oodlight. Both the

ashlight and the oodlight are now running.

Press and release both the top and bottom

body switches to turn the lights off.

On/Off Button for

Flashlight

On/Off Button for

Floodlight

Charging

Station

Belt Clip with

Magnet

II. Rechargeable Battery Replacement

I. Battery Replacement

1. Loosen the locking screw located on the

side of the lens cap. CAUTION: Do NOT

attempt to completely remove the locking

screw. Doing so is not necessary and may

damage the threads. The screw simply needs

to be loosened enough to allow the lens bezel

to unscrew.

2. Unscrew the lens bezel from the housing in

a counter-clockwise direction.

3. Loosen each of the two Charger Contact

Pins located below the Floodlight Lens.

These two Screws should be loosened until

approximately 1/8” of thread is visible.

CAUTION: Do NOT attempt to completely

remove either of these two screws.

Doing so is not necessary and will potentially

damage the light’s ability to charge.

The two screws simply need to be loosened

enough (approximately 1/8”) to allow the

reector / circuit assembly to be removed.

4. Turn the light upside down and carefully

shake the light in order to remove the reector

/ circuit assembly. Allow the reector / circuit

assembly to slide into your hand. CAUTION:

Do NOT touch the reector surface with your

nger. Doing so may damage the reector

surface.

5. Next, allow the rechargeable battery pack

to slide out of the light paying close attention

to the battery pack’s orientation within the

handle.

6. Using only the approved replacement

rechargeable battery pack, slide the new

battery pack into the handle of the light using

the directional arrow marked on the side of the

pack to be a guide to proper battery orientation.

7. Align the reector / circuit assembly so that

the switches on the assembly are aligned with

the switches on the housing. Carefully insert

the assembly back into the ashlight housing

until it is fully seated in the housing. CAUTION:

Be careful to not touch the reector surface with

your nger. Doing so may damage the reector

surface.

8. Tighten both of the Charger Contact Screws

until they are fully seated. CAUTION: Do NOT

over-tighten these two screws. Doing so may

damage the threads and impair the light’s ability

to properly charge.

9. Replace the lens bezel by screwing it onto

the housing in a clockwise direction.

10. Tighten locking screw. CAUTION: Do NOT

over-tighten. Doing so may damage the threads

and impact the light’s Intrinsic Safety.

II. Warnings and Safety Ratings

I. Warnings

Use only the approved non-rechargeable

batteries listed below.

Do NOT attempt to use rechargeable AA

batteries with this light.

To prevent ignition of hazardous atmosphere,

do not open the lens bezel in the hazardous

environment. This task must ONLY be

performed in an area known to be non-

hazardous.

To prevent ignition of a hazardous atmosphere,

the AA batteries must only be exchanged in an

area known to be non-hazardous.

To reduce the risk of explosion, do not

mix new non-rechargeable batteries with

used non-rechargeable batteries, or mix

non-rechargeable batteries from different

manufacturers.

Substitution of components may impair

intrinsic safety.

For personal safety, always conrm the

rating of any known hazardous or potentially

hazardous location where the light is to be

used.

DoNOT attemptto useany typeofrechargeable

AA batteries with this light.

To prevent ignition of a hazardous atmosphere,

do NOT remove the lens bezel in the hazardous

environment. This task must ONLY be done in

an area known to be non-hazardous.

II. Ratings

Listed for United States, Canada, Europe

Class I, Division 1 & 2, Groups A,B,C,D

Class II, Division 1 & 2, Groups E,F,G

Class I, Zone 0, AEx ia IIC T3 Ga

Zone 20 Group IIIC T165°C

ATEX II 1 G Ex ia IIC T3 Ga

IECEx Ex ia I Ma

Ex ia op is IIC T3 Ga

MSHA Rated

T3 Temperature Rating

2 Meter Drop Rating

Autres manuels Larson Electronics Lampe de poche

Larson Electronics

Larson Electronics LE-2206-LED Manuel utilisateur

Larson Electronics

Larson Electronics EXP-TP-RL-1XFX5R Manuel utilisateur

Larson Electronics

Larson Electronics HUL-LED25WRE-CPR-NC Manuel utilisateur

Larson Electronics

Larson Electronics EXP-LED-RL-FX5R-199 Manuel utilisateur

Larson Electronics

Larson Electronics EXP-LED-RL-FX5R Manuel utilisateur

Larson Electronics

Larson Electronics NSR-9850 Manuel utilisateur

Larson Electronics

Larson Electronics EXP-LED-HL-MSHA Manuel utilisateur

Larson Electronics

Larson Electronics EXP-LED-FX2-2M Mode d’emploi

Larson Electronics

Larson Electronics ATX-20-S Manuel utilisateur

Larson Electronics

Larson Electronics HIDH-3550 Manuel utilisateur

Larson Electronics

Larson Electronics EXPRL-91 Manuel utilisateur

Larson Electronics

Larson Electronics ATX-20-SE Manuel utilisateur

Larson Electronics

Larson Electronics LE-2317C Manuel utilisateur

Larson Electronics

Larson Electronics EXPFL-31 Manuel utilisateur

Larson Electronics

Larson Electronics EPL-UV-20W-G2 Manuel utilisateur

Larson Electronics

Larson Electronics EXP-LED-F4W-R2 Manuel utilisateur

Larson Electronics

Larson Electronics AEX-20-LED-SA Manuel utilisateur

Larson Electronics

Larson Electronics SLEDB-110V-M Manuel utilisateur

Larson Electronics

Larson Electronics LE-224 Manuel utilisateur

Larson Electronics

Larson Electronics FL-LED-STR-51 Manuel utilisateur

Larson Electronics

Larson Electronics EXP-LED-51 Manuel utilisateur

Larson Electronics

Larson Electronics ASX-25 Manuel utilisateur

Larson Electronics

Larson Electronics RL-11-LED Manuel utilisateur

Larson Electronics

Larson Electronics ATX-20-SA Manuel utilisateur

Manuels Lampe de poche populaires d'autres marques

StreamLight

StreamLight PROPOLYMER 2AA Manuel utilisateur

StreamLight

StreamLight Stinger Manuel utilisateur

Silverline

Silverline 994024 Manuel utilisateur

Gama Sonic

Gama Sonic 23i60065 Manuel utilisateur

Olympia

Olympia RG580 CREE XM-L2 Manuel utilisateur

EUFAB

EUFAB 13495 Manuel utilisateur

OLIGHT

OLIGHT S35 BATON Manuel utilisateur

Kopp

Kopp Emergency Sensor Light Manuel utilisateur

YLP

YLP PROFESSIONAL Series Manuel utilisateur

Light motion

Light motion GoBe Manuel utilisateur

MOB

MOB MO8622 Manuel utilisateur

EuroLite

EuroLite KKS-3 Manuel utilisateur

Carson

Carson 500907010 Manuel utilisateur

Duracell

Duracell 550 Manuel utilisateur

Mactronic

Mactronic Black Eye 1300 Manuel utilisateur

Eurotops

Eurotops 29780 Manuel utilisateur

MOB

MOB MO8690 Manuel utilisateur

Pelican

Pelican L1 1930 LED Manuel utilisateur