EPF-RME Series
Phone: 877-348-9680
Fax: (903) 498-3364 www.larsonelectronics.com
1 of 2
EPF-RME Series Explosion Proof Exhaust Fan
C1D1&2 - C2D1&2 - Roof Mounted
Instruction Manual
WARNING:
TO AVOIDTHE RISKOF FIRE,EXPLOSION OR ELECTRIC SHOCK, THIS PRODUCT SHOULD BE INSTALLED,
INSPECTEDAND MAINTAINEDBY A QUALIFIED ELECTRICIANONLY, IN ACCORDANCEWITHALL
APPLICABLEELECTRICAL CODES.
TO AVOIDELECTRIC SHOCK:
•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
•PRODUCT MUST BE CONNECTED TO A WIRING SYSTEM WITH AN EQUIPMENT-GROUNDING
CONDUCTOR.
TO AVOID EXPLOSION:
•MAKE SURE THE SUPPLY VOLTAGE IS WITHIN THE VOLTAGE RATING.
•ENSURE THE MARKED T RATING IS LESS THAN THE IGNITION TEMPERATURE OF THE HAZARDOUS
ATMOSPHERE.
•DO NOT OPERATE IN AMBIENT TEMPERATURES ABOVE THOSE INDICATED ON THE PRODUCT
NAMEPLATE.
•DO NOT OPERATE IF THE LENS, CORD, SEALS, HOUSING, RECEPTACLES, ETC. IS CRACKED OR
DAMAGED. IF SO, DISCONTINUE USE AND CONTACT MANUFACTURER FOR REPLACEMENT PARTS.
•ALL FASTENERS SHOULD BE PROPERLY SEATED.
GENERAL INSTRUCTIONS
This fan is completely assembled, tested and ready for installation when shipped from the factory. Itisfor general
ventilation use only. Do not useto exhaust dirt, dust, grease,or lint-laden air.
Vibration or jarring in transit may cause loosening of bolts, nuts,and set-screws or misalignment of the propeller.
Check these items before installing the fans.
Mount fan only for upward discharge (up to vertical). Downward discharge requires addition of a propeller retainer for
completely safe operation.
Propeller blades must be cleaned periodically toprevent accumulated dirt from causing unbalance.
LUBRICATION:- Motors are equipped with pre-lubricated ball bearings. The original supply of grease is kept free from
dirt, grit or outside contamination bythe bearing seals and, under normal operating conditions, does not require
replenishment for the life of the bearing.
WARNING: Westrongly recommend that onlya licensed electrician install this product.
