Larson Electronics EXP-DNMS-N4X-AT-HV Manuel utilisateur

EXP-DNMS-N4X-AT-HV

Larson Electronics, LLCPhone: (800) 369-6671 Fax: (903) 498-3364www.larsonelectronics.com

1of 3

EXP-DNMS-N4X-AT-HV

ExplosionProof MotionSensor InstructionManual

Thank you for your purchase of the EXP-DNMS-N4X-AT-HV Motion Sensor, the following instructions are intended for

this part number only.

Installation

This unit is easily wall mountedvia integral mounting bracket, which can be adjusted-90° to +30° vertically after

installation. The explosion proof housing provides two 1/2" or 3/4" hub openings locatedon either side of thehousing for

running electrical conductors in a feed through configuration. A bushing seal at each conductor opening prevents

damage to wiring insulation.

This unit is designed to operate on voltages of 120V, 208V, 220V, or 277V AC. Voltage is chosen when ordering. This

motion sensor is suitable for use in environments where combustible dusts and particulates may be present. 1/2" or 3/4"

NPT tapped conduit openings are provided on either of the unit in feed through versions while dead end versions have a

single conduit hub, providing easy and secure connection to main power line supplies.

The EXP-DNMS-N4X-AT-HV operates like a standard on/off light switch. The circuit is normally openwhen no motion is

present. Once motion is detected, the internal switch changes to a closed circuit, allowing voltage to pass through the

sensor and power the device(s) at theother end.

The sensor is an active motion detector; it emits high-frequency electro-magnetic waves (5.8GHz) and receives their

echo. The sensor detects the change in echo from even the slightest movement in its detection zone. A microprocessor

then triggers the“switch light ON” command. Detection is possible through doors, panes of glass or thin walls.

IMPORTANT: persons or objects movingtowards the sensor are detected best.

NOTE: the highfrequency of the output ofthis sensor is <10Mw – that is just one 100th of the transmission

power of a mobile phone or the output ofa microwave oven.

EXP-DNMS-N4X-AT-HV

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 3

MOTION SENSOR

Operating voltage

Rated load

HF system 5.8GHz±75MHz, ISM wave band

Transmitting power <0.5mW

Power consumption ≤0.5W(standby)

Detection zone Max.(D x H): 16m x 15m

Detection sensitivity 25% / 50% / 75% / 100%

Hold time 5s / 30s / 90s / 3min / 20min / 30min

Daylight sensor 5Lux/15Lux/30Lux/50Lux/100Lux/Disable

Mounting height 15m Max.

Motion detection 0.5~3m/s

Detection angle 150°(wall installation)

360°(ceiling installation)

Operating temperature -20℃~60℃

IP rating IP20

Setting

ON ON

ON ON ON

ON ON

ON ON ON

III

1 2

100%

75%

50%

25%

III

3 4 5

30s

90s

3min

20min

30min

6 7 8

Disable

50lux

15lux

5lux

30lux

III

Detection area can be reduced by selecting the combination on the

DIP switches to fit precisely each application.

Refers to the time period the lamp remains at 100% illumination after

no motion detected.

The sensor can be set to only allow the lamp to illuminate below a

defined ambient brightness threshold.

When set to Disable mode, the daylight sensor will switch on the lamp

when motion is detected regardless of ambient light level.

30lux, 50lux,100lux,:twilight operation, 5lux, 15lux: darkness operation only.

By selecting the combination on the DIP switch, sensor data can be precisely set for each specific application.

100lux

ON ON

When set to Disable, the microwave sensor function is inactive, lights turns on or off

by switch.

When set to Sensor, the microwave sensor function is active.

Detection area

Hold time

Daylight sensor

Mode

Specified when ordering, check product label.

EXP-DNMS-N4X-AT-HV

Larson Electronics, LLCPhone: (800) 369-6671 Fax: (903) 498-3364www.larsonelectronics.com

3of 3

Certifications - Compliance

- Class I, Divisions 1 & 2, Groups B, C, D

- Class I, Zones 1 & 2, Groups IIB+H2, IIA

- Class II, Divisions 1&2, Groups E,F,G

- Class III, Divisions 1&2

- Ex db IIC Gb

- Ex tb IIC Gb Db IP66

- NEMA 3,4,4X,7 (B,C,D), 9 (E,F,G)

Malfunction

Cause

Remedy

The load will not work - wrong light control setting selected

- load faulty

- mains switch OFF

- adjust setting

- change load

- switch ON

The load is always working - continuous movement in the

detection zone

- check zone setting

Load works without and identifiable

movement

- sensor is not mounted for detecting

movement reliably

- movement occurred, but not

identified by the sensor (movement

behind a wall, movement of small

object in immediate vicinity etc.)

- securely mount enclosure

- check zone setting

The load will not work despite

movement

-rapid movements are being

suppressed to minimize

malfunctioning or the detection zone

you have set is too small

-check zone setting

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER

INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY PHONE AT

1-800-369-6671 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURNINFORMATION.

Autres manuels Larson Electronics Accessoires

Larson Electronics

Larson Electronics SLEDB-110V-30C-XMS Manuel utilisateur

Larson Electronics

Larson Electronics EXP-MS-30W-N4X Manuel utilisateur

Larson Electronics

Larson Electronics EPLTS-T8 Manuel utilisateur

Larson Electronics

Larson Electronics EXP-MS-30W-N4X-SFC Manuel utilisateur

Larson Electronics

Larson Electronics EXP-AKC-MS-N4X-AT-LV-12V Manuel utilisateur

Larson Electronics

Larson Electronics ATEX-EXP-DNS-400W-M20-HV Manuel utilisateur

Larson Electronics

Larson Electronics MDSEN-IR-277V-R2 Manuel utilisateur

Larson Electronics

Larson Electronics SLEDB-277V-30C-XMS Manuel utilisateur

Larson Electronics

Larson Electronics EXP-MS-N4X-AT-LV Manuel utilisateur

Larson Electronics

Larson Electronics EXP-MS-N4X-AT-HV Manuel utilisateur

Larson Electronics

Larson Electronics XLE-PA-IP20-CS.50-50A-3PH-250V-3P4W-B Manuel utilisateur

Larson Electronics

Larson Electronics EXP-MS-N4X-AT-HV-V6 Manuel utilisateur

Larson Electronics

Larson Electronics IND-HL-HDB-FUVC-EX-1L-120V-15C Manuel utilisateur

Larson Electronics

Larson Electronics EXP-MS-N4X-AT-HV-V5 Manuel utilisateur

Larson Electronics

Larson Electronics IND-TBL-BX-R13-UVC-120V Manuel utilisateur

Manuels Accessoires populaires d'autres marques

Hillco

Hillco 2810 Manuel utilisateur

Siemens

Siemens QSA2700D Manuel de l'opérateur

Contours

Contours ZY024 Manuel utilisateur

Saivod

Saivod VS621 Manuel utilisateur

Virtuox

Virtuox VirtuCLEAN 2.0 Manuel utilisateur

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuel utilisateur

Z-Wave

Z-Wave HSD-200Z Manuel utilisateur

turck

turck FMX-IM-2UPLI63FX Manuel utilisateur

Decagon Devices

Decagon Devices 10HS Manuel utilisateur

UPPAbaby

UPPAbaby Cup Holder Manuel utilisateur

Elko

Elko SmartSensor Leakage Wireless Manuel utilisateur

Grizzly

Grizzly H8371 Manuel utilisateur

Panasonic

Panasonic HG-T Series Manuel utilisateur

IFM Electronic

IFM Electronic Efector 250 Series Guide de référence

DigiDesign

DigiDesign 888/24 I/O Manuel utilisateur

PROZIS

PROZIS QUAY Manuel utilisateur

patagonia

patagonia PSI Vest Manuel utilisateur

SFC Energy

SFC Energy EFOY GO! Manuel utilisateur