Hardened Media Converter
4
Functional Description
yMeets NEMA TS1/TS2 Environmental requirements: temperature, shock, and
vibration for traffic control equipment.
yMeets IEC61000-6-2 EMC Generic Standard Immunity for industrial environment.
ySupport 802.3ab/802.3z/802.3x. Auto-negotiation and Auto MDI/MDIX.
y1000Base-SX/LX: Multi mode, Single mode, or WDM Single mode SC type.
yOne DIP switch for configuring link-fault-pass-through, fiber auto negotiation,
and port link down alarm.
yAlarms for power and port link failure by relay output. Relay contact rating with
current 1.5A @ 24VDC, 0.5A @ 120VAC.
yOperating voltage and Max. current consumption: 0.76A @ 12VDC, 0.38A @
24VDC, 0.19A @ 48VDC. Power consumption: 9.12W Max.
yPower Supply: Redundant DC Terminal Block power inputs or 12VDC DC JACK
with 100-240VAC external power supply.
yField Wiring Terminal: Use Copper Conductors Only, 60/75℃, 12-24 AWG
torque value 7 lb-in.
y-40 to 75 (℃℃-40℉to 167℉) operating temperature range. Tested for
functional operation @ -40 to℃85 (℃-40℉to 185℉). UL1604 Industrial
Control Equipment certified Maximum Surrounding Air Temperature @ 74℃
(165℉).
ySupports DIN-Rail, Panel, or Rack Mounting installation.
yUL1604 Class I, Division 2 Classified for use in hazardous locations (applicable
to versions with terminal block power option).
yThis equipment is suitable for use in Class I, Division 2, Groups A, B, C and D
OR non-hazardous locations only.
yWARNING – EXPLOSION HAZARD – Do not disconnect equipment unless
power has been removed or the area is known to be non-hazardous.
yWARNING – EXPLOSION HAZARD – Substitution of components may impair
suitability for Class I, Division 2.
Assembly, Startup, and Dismantling
yAssembly: Place the media converter on the DIN rail from above using the slot.
Push the front of the media converter toward the mounting surface until it
audibly snaps into place.
yStartup: Connect the supply voltage to start up the media converter via the
terminal block (or DC JACK).
yDismantling: Pull out the lower edge and then remove the media converter from
the DIN rail.
