KRAFTWERK 32039 Manuel utilisateur

www.KRAFTWERKtools.com

Rechargeable 10 W COB LED

power work and spotlight

Art. 32039

Instruction Manual

lamp.

11.1 V

2200 mAh

Li-ion

-10 0C - 40 0C

3 h

IP65

3 h

1000 Lumen

6 h

500 Lumen

IK07

6000 K

Temp

color

PRODUCT DESCRIPTION

SPECIFICATIONS

COB LED light intensity: 500 Lumen (50% brightness) / 1000 Lumen (full brightness)

Light Source: 10 W COB LED

Working time: 6 h (50% brightness) / 3 h (full brightness)

Charging time: Approx. 3 h

Input power supply: 100-240 V~ 50/60 Hz

Transformer: 15.0 V 1.0 A

IP level: IP65

IK level: IK07

1. ON/OFF switch

2. 10 W COB LED

3. Charger socket

4. Battery capacity indicator

5. U bracket

6. AC main charger 100-240 V~ 50/60 Hz (Art. 32039AL)

USING INSTRUCTIONS

The ON/OFF switch is located on the back of the lamp:

●Press the ON/OFF switch once: 50% brightness

●Press the ON/OFF switch a second time: full brightness

●Press the ON/OFF switch a third time: OFF

CHARGING PROCESS

To charge the lamp, remove the rubber cap from the hollow plug socket on the rear of the lamp and

insert the round plug of the AC/DC power supply. Then connect the AC/DC power supply to a mains

socket.

The battery should only be charged with the charger supplied by the manufacturer. To avoid damage,

please do not use any other chargers.

When not in use, the charger must be unplugged from the outlet.

Keep the lamp in a dry place away from direct sunlight. The lamp must be protected against high

humidity and water.

WARNING!

Avoid looking directly into the beam, as it will dazzle.

Don't use the lamp near open flames.

Do not disassemble.

Lamp gets hot after long use! Cool down the lamp before touch it.

If lamp will be stored for one month or more, please fully charge it prior to storage.

Don't leave battery flats, otherwise it could be over discharged and may NOT be able to be reused.

The battery cannot be replaced.

The battery must be removed from the appliance before it is scrapped.

The appliance must be disconnected from the supply mains when removing the battery.

The battery is to be disposed safety.

NOTE: Before disposing of damaged goods, check with your state Environmental Protection

Agency to find out about special restrictions on the disposal of the lamp and batteries or return

them to a certified service center for recycling.

WARRANTY

We do not take responsibility for any damage caused by misuse or any use that is not in compliance with

the safety standards described herein.

CUSTOMER SERVICES

Contact your local importer of your specialized dealer to obtain address of our service department.

You find our partners under www.KRAFTWERKtools.com

From date of purchase receipt

2 YEARS GUARANTEE

on material- or production-defects

ART. 32025-3

OPTIONAL:

Max. 1648 mm

Min. 684 mm

Table des matières

Autres manuels KRAFTWERK Mettre en lumière

KRAFTWERK

KRAFTWERK HEXA Manuel utilisateur

Manuels Mettre en lumière populaires d'autres marques

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Manuel utilisateur

LIVARNO home

LIVARNO home 375304 2101 Instructions originales

Cameo

Cameo CLQS40WW Manuel utilisateur

Leviton

Leviton Ellipsoid 5/50 Manuel utilisateur

Monacor

Monacor img Stage Line PARL-56PDX/CR Manuel utilisateur

Vector

Vector SL3AKV Manuel utilisateur

Quantum

Quantum Q262 Manuel d'exploitation

Philips

Philips Vari-lite VL3015LT Manuel utilisateur

EUROSPOT

EUROSPOT C51 Manuel utilisateur

DTS

DTS MINI BRICK ARC Manuel utilisateur

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Manuel

ACME

ACME LED-MS350B Manuel utilisateur

EuroLite

EuroLite Akku flat light 1 Manuel utilisateur

Commercial Electric

Commercial Electric SPTM-1401 Manuel utilisateur

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Manuel utilisateur

Teknik

Teknik FLEXI Manuel utilisateur

Craftsman

Craftsman CMXLSB10 Manuel utilisateur

EuroLite

EuroLite LED SLS-144 UV Floor Spot Manuel utilisateur