Installation Instructions
Before using your wine cooler:
• Remove the exterior and interior packing
• Before connecting the appliance to the power outlet, let it stand upright for approximately 2 hours.
This will reduce the possibility of malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a oor that is strong enough to support the appliance when it is fully loaded.
• To level your appliance, adjust the front legs at the bottom of the appliance.
To install the door handle:
For shipment, the door handle has been stored inside of the unit binding to the wood shelves. To install the
handle, the door gasket should be gently pulled back where it covers the screw holes for the handle, then the
handle should be attached by screwing into place with the two screws which are packed in the box with this
Instruction Manual and other spare parts.
To reverse the door swing:
As you received your wine cooler, the door swings open at the left. If you wish to reverse the swing so that
the door opens from the right, it is most important to have at least one other person to help. It is very dan-
gerous to try to reverse the door swing by yourself, without anybody’s help the door might fall and the glass
might be broken, which is terribly dangerous.
For the model KNWC01BK: Now, unscrew the upper door hinge while the second person hold the door.
Remove the upper hinge and carefully lift the door off the bottom hinge. Unscrew the bottom hinge and
install it on the left side of the unit. Flip the door around so that the handle is on the right side and slip the
door over the bottom hinge. Reattach the door by screwing the top hinge into the holes provided on the
upper left surface of the unit. Make adjustments as necessary to be sure the door is aligned properly.
For the model KNWC02BK:Put the door off the upper hinge. Unscrew the upper hinge and install it on the
left side of the unit. Flip the door around so that the handle is on the right side and slip the door over the
upper hinge. Reattach the door by screwing the lower hinge into the holes provided on the lower left
surface of the unit. Make adjustments as necessary to be sure the door is aligned properly.
KNWC01BK_MAN_EN_B08_v02.indd 7KNWC01BK_MAN_EN_B08_v02.indd 7 5-9-2022 13:08:495-9-2022 13:08:49
