Kodak MULTILOADER 700 Manuel de référence

SERVICEBULLETIN

Eastman Kodak Company, Health Imaging, Imaging Service Center, Rochester, New York 14650

KODAK Multiloader

SERVICE BULLETIN NO. 240 MAY 1996

3053 KODAK MULTILOADER 700 / MULTILOADER 700 Plus

Adjusting the CASSETTE OPENER

This procedure is a replacement for the procedure in the Service Manual for the Kodak MULTILOADER 700,

Publication No. SM3053.

Important

Check that the OPENER SHOVEL is the correct length. If the OPENER SHOVEL was replaced or the length was

changed, do “LENGTH ADJUSTMENT”, adjustment 3.18.1, in SM3053, 4/1990.

-2-

Figure 1

[1] Manually insert a CASSETTE and place in the centered position. Check that the CASSETTE is tight against

the STOP at the CASSETTE END SWITCH.

[2] Rotate the CASSETTE OPENER BRACKET fully up to the position in the illustration.

[3] Check that the 2 EXIT DOOR BRACKET CAMS are parallel and in the same position as shown in Figure 1on

the EXIT DOOR BRACKET.

H070_0150DC

CASSETTE

STOP

CASSETTE

END SWITCH

CASSETTE

ROLLERS

PRESSURE

BOLTS

CASSETTE

OPENER

BRACKET

2 EXIT DOOR

BRACKET CAMS

H070_0150DCA

-3-

Figure 2

Caution

The WASHERS prevent the PRESSURE BOLTS from pressing excessively on the CASSETTE and causing the

MOTOR to stall.

[4] Manually move the CASSETTE OPENER BRACKET down and toward the PROCESSOR until you see the

E-RING lift from each WASHER.

Note

If the CASSETTE lifts from the BELT, adjust the CASSETTE SUPPORT. See the SERVICE MANUAL.

H070_0151DC

E-RING

H070_0151DCA

SHAFT

SWITCHING

BELT

BOLTS

PRESSURE

CASSETTE

ROLLERS

WASHERS

-4-

Figure 3 [5] Move the CASSETTE OPENER BRACKET to

the horizontal position.

Important

For Step 6 to Step 11, see Figure 4.

[6] Now move the CASSETTE OPENER BRACKET down until

• the PRESSURE BOLTS press onto the CASSETTE LID

• the pressure on the PRESSURE BOLTS is released

• the PRESSURE BOLTS touch the CASSETTE LID again without pressure

[7] Check that the CASSETTE rests tightly at the STOP and the PRESSURE BOLTS rest on the CASSETTE LID.

[8] Use a 2mm Allen WRENCH to check the clearance between the edge of the OPENER SHOVEL and the

CASSETTE LATCH.

[9] If the clearance is not correct, loosen the 2 SCREWS of the CASSETTE OPENER BRACKET and move the

OPENER SHOVEL to a distance of 2 mm (0.08 in.) from the CASSETTE LATCH.

[10] Tighten the 2 SCREWS of the CASSETTE OPENER BRACKET.

[11] Check the clearance again.

H070_0152AC

H070_0152ACA

BRACKET

OPENER

CASSETTE

-5-

Figure 4

2 mm (0.08 in.)

H070_0153EC

STOP

LID

CASSETTE

LATCH

CASSETTE

BOLT

PRESSURE

SHOVEL

OPENER

BRACKET

OPENER

CASSETTE

2 SCREWS

H070_0153ECA

-6-

Figure 5

[12] Move the CASSETTE OPENER BRACKET up fully and toward the front of the MULTILOADER.

[13] Remove the CASSETTE.

[14] Check the alignment of the edges of the ENTRANCE DOOR CAM and the BALL BEARING. If necessary:

• Loosen the 2 SETSCREWS.

• Adjust the 2 ENTRANCE DOOR CAMS.

• Tighten the 2 SETSCREWS.

• Check again.

H070_0154DC

ENTRANCE DOOR CAM

BALL BEARING

2 SETSCREWS

H070_0154DCA

Autres manuels pour MULTILOADER 700

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Kodak Équipement médical

Kodak

Kodak DirectView CR 825 Guide de démarrage rapide

Kodak

Kodak HEALTH SCIENCES X-Omat M43 Manuel utilisateur

Kodak

Kodak 2200 Manuel utilisateur

Kodak

Kodak 8000C Manuel utilisateur

Kodak

Kodak X-Omat 3000 RA Manuel utilisateur

Kodak

Kodak CR 7400 Manuel utilisateur

Kodak

Kodak 8000C Manuel utilisateur

Kodak

Kodak X-Omat M43 PROCESSOR Guide de configuration

Kodak

Kodak DirectView CR 825 Mode d’emploi

Kodak

Kodak RVG 6500 IPS System Guide de dépannage

Kodak

Kodak RVG 6500 Manuel utilisateur

Kodak

Kodak DirectView CR 825 Manuel utilisateur

Kodak

Kodak DirectView CR 825 Guide de configuration

Kodak

Kodak DirectView CR 800 System Manuel utilisateur

Kodak

Kodak Miniloader 2000 Manuel utilisateur

Kodak

Kodak CR 360 Manuel utilisateur

Kodak

Kodak DirectView CR 825 Instructions d'utilisation

Kodak

Kodak RVG 6100 Manuel utilisateur

Kodak

Kodak X-Omat M43 PROCESSOR Manuel utilisateur

Kodak

Kodak RVG Manuel utilisateur

Kodak

Kodak X-Omatic MULTILOADER 300 Manuel utilisateur

Kodak

Kodak 2200 Manuel utilisateur

Kodak

Kodak 104 Manuel utilisateur

Kodak

Kodak Point-of-Care CR 120 System Manuel utilisateur

Manuels Équipement médical populaires d'autres marques

TekTone

TekTone Tek-CARE160 Manuel utilisateur

NeuroMetrix

NeuroMetrix Quell 2.0 Manuel utilisateur

AMT

AMT XLR8 Manuel utilisateur

Medipost-Nutristoma

Medipost-Nutristoma MD300K2 Manuel utilisateur

EDAN

EDAN SONOTRAX Pro Manuel utilisateur

Restorative Therapies

Restorative Therapies RT300 Manuel utilisateur

Gendex

Gendex Expert DC Manuel utilisateur

Dexcowin

Dexcowin ADX4000W Manuel utilisateur

Libelium

Libelium MySignals Manuel utilisateur

Acelity

Acelity V.A.C.ULTA 4 Manuel utilisateur

Caputron

Caputron ActivaDose II tDCS Manuel utilisateur

FujiFilm

FujiFilm Sonart Manuel du propriétaire

Plinth 2000

Plinth 2000 93CDT Manuel utilisateur

GE SENOGRAPHE 800T Manuel utilisateur

GE Definium 5000 Manuel utilisateur

Kanmed

Kanmed GE-1380 Manuel utilisateur

Huntleigh

Huntleigh FD1 Manuel utilisateur

Stryker

Stryker SPR Plus Manuel utilisateur