Knightsbridge GU10SPIKE Mode d’emploi

09/2013_V1

INSTALLATION & MAINTENANCE MANUAL

GU10SPIKE. GU10SPIKEBK. GU10SPIKEL

230V

50Hz

dim

GU10 IP65 GARDEN SPIKE

GU10SPIKE_INSTRUCTIONS_Layout 1 15/10/2013 10:51 Page 1

GENERAL INSTRUCTIONS:

These instructions should be read carefully and retained after installation for further

reference and maintenance.

SAFETY

• Before installation/maintenance, ensure that the mains supply to the luminaire is

switched off and the circuit fuses are removed or circuit breakers switched off.

• Installation of this luminaire should only be carried out by a qualified electrician to

the current IEE Wiring and Building Regulations.

• Check that the total load on the circuit including when this luminaire is fitted does

not exceed the rating of the circuit cable, fuse or circuit breaker

• This product is IP65 rated and suitable for external applications. Not suitable for

hazardous or coastal areas

• This product is Class l rated and must be earthed

• 230V 50Hz

• GU10 35W MAX or GU10 LED

• Please recycle this unit.

• The pre-installed cable supplied is for above-ground use only. Should the cable

need to be routed within walls or underground, a suitable conduit or plastic trunking

should be used

•

Should the protective glass be cracked or damaged it should be replaced immediately

• This fitting must not be used without the protective glass installed

INSTALLATION

• Choose a position for the luminaire ensuring that the ground is suitable to firmly hold

the spike and luminaire in position. Check that the ground is not liable to flooding

and the spike does not infringe with any underground pipes or cables when pushed

into the ground.

• Route the cable from the luminaire to a suitable outdoor socket or an IP65 rated

(or higher) weatherproof junction box avoiding positions where the cable could

cause a hazard or be at risk of being cut, trapped or damaged.

• Connect the cable into the junction box or fit a suitable plug for the outdoor socket

ensuring correct polarity is observed:

Brown-LIVE.

Blue-Neutral.

Green/Yellow-Earth

LAMP INSTALLATION & REPLACEMENT

• ALWAYS SWITCH OFF THE MAINS SUPPLY AND ALLOW THE LUMINAIRE AND

LAMP TO COOL BEFORE HANDLING

• Unscrew the bezel by turning anticlockwise

• Place the lamp (GU10 35W MAX) into the lampholder and turn clockwise 45 degrees

to lock into the lampholder

• To remove the lamp turn anticlockwise 45 degrees and pull out of the lampholder

• Replace the bezel ensuring the gasket is not damaged, is intact and the bezel is

tight so as to form a weatherproof seal.

• Test for correct operation

CLEANING

• Clean with a soft dry cloth only, do not use other materials or solutions which may

damage the fitting.

OPTIONAL EXTRA

A 600mm ground spike (EXT2) is available as an optional extra replacing the

standard spike to extend the height of the luminaire

92mm

63mm

60mm

95mm

GU10SPIKE/GU10SPIKEBK GU10SPIKEL

SPIKE

120mm 33mm

BODY BODYBEZEL BEZEL

33mm

120MM

GU10SPIKE_INSTRUCTIONS_Layout 1 15/10/2013 10:51 Page 3

Ce manuel convient aux modèles suivants

Autres manuels Knightsbridge Équipement d'éclairage

Knightsbridge

Knightsbridge BT9EMS Mode d’emploi

Knightsbridge

Knightsbridge RWL Series Mode d’emploi

Knightsbridge

Knightsbridge LWALL1A Mode d’emploi

Knightsbridge

Knightsbridge KIT16 Mode d’emploi

Knightsbridge

Knightsbridge BLED5BW Mode d’emploi

Knightsbridge

Knightsbridge SN3P Mode d’emploi

Knightsbridge

Knightsbridge LED Series Mode d’emploi

Knightsbridge

Knightsbridge BL12ALEDEM Mode d’emploi

Knightsbridge

Knightsbridge SPIKEGUBK Mode d’emploi

Knightsbridge

Knightsbridge KIT4B Mode d’emploi

Knightsbridge

Knightsbridge GDL2 Mode d’emploi

Knightsbridge

Knightsbridge TNXQUADSTW Mode d’emploi

Knightsbridge

Knightsbridge SHE P Series Mode d’emploi

Knightsbridge

Knightsbridge TNXQUADEMW Mode d’emploi

Knightsbridge

Knightsbridge SHE S Series Mode d’emploi

Knightsbridge

Knightsbridge TNXQUADW Mode d’emploi

Knightsbridge

Knightsbridge 12DC36 Mode d’emploi

Knightsbridge

Knightsbridge BF1430EMS Mode d’emploi

Knightsbridge

Knightsbridge UCLCT4 Mode d’emploi

Knightsbridge

Knightsbridge LEDFIPCCT Mode d’emploi

Knightsbridge

Knightsbridge HBN Series Mode d’emploi

Knightsbridge

Knightsbridge LEDBATW Series Mode d’emploi

Knightsbridge

Knightsbridge OS009 Mode d’emploi

Knightsbridge

Knightsbridge BL12LEDS Mode d’emploi

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur