Kleenmaid CH300CW Guide d'installation
COOKTOP
collection
Instructions for Use
and Warranty Details
Domino
Vitroceramic Hob
CH300CW
CH300CX
2
PRODUCT LABEL
This cooktop has been designed and constructed in accordance with the following
codes and specifications:
AS/NZS 3350-1 General Requirements for Domestic electrical appliances
AS/NSZ 3350-2-6 Particular Requirements for Domestic electrical cooking appliances
AS/NSZ 1044 Electromagnetic Compatibility Requirements.
ongratulations on the purchase of your new
Kleenmaid appliance. This appliance has been
designed and manufactured to give you years
of reliable performance. For best results,
carefully read the instructions on how to install
your new appliance. Correct installation will avoid delays and
unnecessary service calls.
Once installation is complete, read this booklet and get to
know the controls and the features of your new appliance.
We reserve the right to alter the specifications with no
influence on the operation of the appliance. This instruction
manual cannot be reason for a claim.
3
IMPORTANT PRECAUTIONS AND RECOMMENDATIONS
■When unpacking the appliance make sure that it is not damaged. If you
have any doubts, do not use the appliance but consult your supplier or an
engineer.
■The packing materials (plastic bags, expanded polystyrene, nails, bands etc.)
must not be left within easy reach of children, because they are a possible
source of danger.
■The packaging material is recyclable and is marked with the recycling
symbol .
■Do not try to alter the technical properties of the appliance, because this
could be dangerous.
■The manufacturer cannot be considered responsible for damage caused by
improper, incorrect or irresponsible use of the appliance.
■Before disposing of any unwanted appliances it is recommended that all
potentially hazardous parts be made non hazardous.
■Electrical connection must be carried out by a specialist familiar with the laws
and official regulations governing such installation in your State and follow-
ing the manufacturer's instructions.
■During and after use of the cooktop, certain parts will become very hot. Do
not touch hot parts.
■Keep children away from the cooking hob when it is in use.
■After use, ensure that the knob is in the off position.
■Some appliances are supplied with a protective film on steel and aluminium
parts. This film must be removed before using the hob.
■Do not carry out maintenance operations on the appliance without having
previously disconnected it from the electric power supply.
TIPS FOR THE USER
■During and after use of the cooktop, certain parts will become very hot. Do
not touch hot parts.
■Keep children away from the cooking hob when it is in use.
■Before any cleaning or maintenance, switch off the electricity to the cooktop.
IMPORTANT PRECAUTIONS AND RECOMMENDATIONS FOR
USE OF ELECTRICAL APPLIANCES
Use of any electrical appliance implies the necessity to follow a series of fundamental
rules. In particular:
■The appliance is not intended for use by young children or infirm persons
without supervision
■Young children should be supervised to ensure that they do not play with
the appliance
4
INSTALLATION
TECHNICAL INFORMATION
FOR THE INSTALLER
Before installing the cooktop, remove
the protective film.
This cooktop can be built into a
working surface 30 to 40 mm thick
and 600 mm deep.
In order to install the ceramic griddle
into the kitchen fixture, a hole with
the dimensions shown in fig. 1 has
to be made, keeping in considera-
tion the following:
✓within the fixture, between the
bottom side of the ceramic griddle
and the upper surface of any
other appliance or internal shelf
there must be a clearance of at
least 30 mm;
✓the ceramic hob must be kept no
less than 50 mm away from any
side wall;
✓the rear wall must be at least 50
mm from the ceramic griddle and
must withstand a temperature of
150°C.
✓there must be a distance of at least
650 mm between the hob and
any wall cupboard or extractor
hood positioned immediately
above (see fig. 2)
✓the coatings of the walls of the
unit or appliances near the
cooktop must be heat resistant.
✓Do not install the appliance near
inflammable materials (eg.
curtains).
650 mm
50 mm min
50 mm min
500 mm
450 mm
490
510
270
288
+ 0
– 2
+ 0
– 2
50
Figure 1
Figure 2
5
FASTENING THE APPLIANCE
Each ceramic griddle is supplied with
a set of tabs and screws to be fastened
onto the units.
✓Cut the unit (as shown in figure 1).
✓Stretch gasket “D” over the edge of
the hole made, being careful to
overlay the junction edges.
✓Turn the ceramic griddle over and
put tabs “A” into the mountings, only
tighten screws “B” a few turns (fig.
4).
Make sure that the tabs are mounted
correctly as shown in the figures.
Turn the tabs so that the cooktop
can be put into the hole.
✓Put the cooktop into the hole cut
into the unit and position it correctly.
✓Put tabs “A”; into place, tooth “C” of
the tabs should go into the hole (fig.
4).
✓Tighten screws “B” until the cooktop
is completely secured.
✓Using a sharp tool cut off the part
of gasket “D” which protrudes from
the cooktop.
A
A
AA
Figure 3
Figure 4
20 mm min.
40 mm max.
B
D
A
C
6
ELECTRICAL SECTION
ELECTRICAL REQUIREMENTS
■The appliance must be connected to the mains checking that the voltage
corresponds to the value given in the rating plate and that the electrical
cable sections can withstand the load specified on the plate.
■The wires in the power cable are coloured in accordance with the following
code:
Green/Yellow = Earth, Blue = Neutral, Brown = Active.
If the colours of the wires in the power cable to the appliance do not
correspond with the coloured markings identifying the terminals in the
junction terminal, proceed as follows:
1.The wire which is coloured green and yellow must be connected to the
terminal marked E (Earth) or coloured Green.
2.The wire which is coloured blue must be connected to the terminal marked
N (Nuetral) or coloured Black.
3.The wire which is coloured brown must be connected to the terminal
marked L (Live) or A (Active) or coloured Red.
■The appliance must be connected directly to the mains placing a two pole
switch with minimum opening between the contacts of 3 mm between the
appliance and the mains.
■The power supply cable must not touch the hot parts and must be
positioned so that it does not exceed 50°C above ambient.
■Once the appliance has been installed, the switch or socket must always be
accessible.
■
If the supply cord is damaged it must be replaced by the manufacturer or it’s
Service Agent or a similarly qualified person in order to avoid a hazard.
N.B. The connection of the appliance to earth is mandatory.
If the installation requires alterations to the domestic electrical system call a qualified
electrician.
He should also check that the socket cable section is suitable for the power drawn
by the appliance.
Replacing the power cord must be done by a qualified electrician in
accordance with the instructions supplied by the manufacturer and in
compliance with established electrical regulations.
7
230 V
PE
N
L1(L )2
A
F
Before carrying out any work on
the electrical section of the appli-
ance, it must be disconnected
from the mains.
Connection to a good earth
wiring system is absolutely
essential.
The manufacturer accepts no
responsibility for any inconve-
nience caused by failure to com-
ply with this rule.
Figure 5
Figure 6
Figure 7
REPAIRS
Replacing the supply cable
Turn the cooktop over and unhook the
terminal board cover by inserting a
screwdriver into the two hooks “A”.
Open the cable gland by unscrewing
screw “F”, unscrew the terminal screws
and remove the cable.
The new supply cable, of suitable type
and section, is connected to the termi-
nal board following the diagrams
shown below.
SECTION OF THE SUPPLY
CABLE
Use H05RR-F cables
230-240 V ~ 50/60 Hz
section: 3 x 1,5 mm2
8
Figure 8
P2
P3
95
4
7
P1
3
2
1
P2
P3
95
4
7
P1
3
2
1
12 43
12 4
3
P1
P2
F1 F2
S2 S1 S3
N
L
M
1131091
T
ELECTRIC DIAGRAM KEY
F1/2 Switches
S1 Line pilot lamp
S2/3 Residual heat pilot lamp
P1 Radiant heater 1700W-230V
P2 Radiant heater 1200W-230V
MTerminal block
TEarth connection
ELECTRIC DIAGRAM
9
VITROCERAMIC HOB
Figure 9
FEATURES
- Electrical insulation Class I.
GENERAL FEATURES
1. 3 circuits hotplate Ø 180 - 1700 W
2. 3 circuits hotplate Ø 145 - 1200 W
CONTROL PANEL DESCRIPTION
3. Hotplate 1 control knob
4. Hotplate 2 control knob
5. Residual heat indicator (Hotplate 1)
6. Residual heat indicator (Hotplate 2)
7. Power indicator light
SCHOTT
4
6 7 5
3
1
2
10
How to use your Ceramic Hob
HOW TO USE THE COOKER
TOP
The main characteristic of this pyroceram
cooker top is that it permits rapid vertical
transmission of the heat from the heating
elements below to the saucepans on top.
The heat does not spread horizontally,
therefore the glass stays cold only a few
centimetres from the hob.
The cooking plates are shown by dark
disks on the ceramic surface.
Check that the hob is clean and then
switch on by turning the control knob
(fig. 10).
When the top is working, the pilot light
will be on.
When the hob temperature is above
60°C, the corresponding indicator light
will come on to indicate that the hob is
hot.
This light will stay on even after the hob
has been switched off to indicate that the
hob is still hot.
The residual heat persists for some time
after the hob has been switched off.
During this time avoid touching the hob
and take particular care if there are chil-
dren nearby.
The light will go out automatically when
the hob temperature drops below 60°C.
2
1
0
6
5
4
3
Figure 10
3 circuit radiant hotplate
The heating element consists of 3 elec-
trical resistances which can operate
together or separately according to the
setting of the 7-position switch. It reach-
es the required temperature very quick-
ly.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Kleenmaid Plaque
Kleenmaid
Kleenmaid CH600SW Manuel utilisateur
Kleenmaid
Kleenmaid KCCCT6010 Guide d'installation
Kleenmaid
Kleenmaid ICK63 Manuel utilisateur
Kleenmaid
Kleenmaid CH 600 CE Mode d’emploi
Kleenmaid
Kleenmaid CH600X Fiche technique
Kleenmaid
Kleenmaid IB60 Manuel d'installation et d'exploitation
Kleenmaid
Kleenmaid CH 600 CM Manuel utilisateur
Kleenmaid
Kleenmaid CH80X Manuel d'utilisation
Kleenmaid
Kleenmaid CH700X Fiche technique
