5. Make sure the silicone
ring on the underside
of the lid is at and not
distorted. Over-tightening
the washer on the spigot/
tap can cause the silicone
ring to distort.
6. Carefully place the
lid on the mouth of the
dispenser by holding the
seal towards the lid. The
seal needs to sit at on the
mouth of the glass and not
fall inside the dispenser.
7. Place a downward
pressure on the lid as you
turn the screw band, this
will ensure a tight seal.
Tighten securely by hand.
8. Make sure the spigot/
tap is turned to the closed
position, central on the
lid and facing the correct
direction.
A helpful video showing this process is available on www.kilnerjar.co.uk
O
O
O
P
P
P
