BioSync
- 5 - P/N: 02303-001 - Rev. E
3.0 CNV-1000 Hardware Connection
3.1 Connecting a Single BioSync Reader to a CNV-1000
Important Note: As the CNV-1000 converters have the same default static IP address
(192.168.1.100), if you are setting up multiple CNV-1000s, you should connect them
to the network one-at-a-time. Configure the first CNV-1000 with its new IP address
before you connect a second CNV-1000 module to the network.
The CNV-1000 converter is connected to the PC via a local area network (into a net-
work hub or switch) or directly from the host PC (using a cross-over cable). It uses an
external 12VDC power supply and does not require any drivers to be installed.
This converter is connected to the PC via local area network (into a network hub or
switch) or directly from the host PC (using a cross-over cable). It uses an external
12VDC power-supply and does not require any drivers to be installed.
1. Apply 12VDC power to the CNV-1000.
2. Connect the host PC to the CNV-1000 using a cross-over cable or via a
hub/switch using a patch cable.
- Ethernet connection using a cross-over cable from the host PC
3. Connect the first BioSync to the CNV-1000 using the RS-485 connections.
