KEPCO PC 12 Manuel utilisateur
©2018, KEPCO, INC 1
Data subject to change without notice 228-0818 REV 1
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000FAX (718) 767-1102
http://www.kepcopower.com email: hq@kepcopower.com
INSTRUCTION MANUAL
KEPCO An ISO 9001 Company.
PC 12
MATING CONNECTOR
(UNWIRED)
KEPCO MODEL PC 12 MATING CONNECTOR
(UNWIRED)
I — Description
The Kepco Model PC 12 is a 50 terminal connector, equipped with
cable shell, cable clamp and locking screws. The PC 12 is
designed to provide the correct termination for Kepco equipment
with 50-pin, dual, edge-printed circuit rear connectors.
II — Installation (See Figure 1)
1. Disassemble the connector insert and the connector shell
by removing the two mounting screws (A, B).
2. Instructions for wiring the PC 12 for model-specific appli-
cations (e.g., voltage control, current limiting, etc.) are
found in the applicable Operator’s manual listed in Table
1. Wire the connector terminals and insert the plastic
“key” into the correct position (see Figure 1).
3. Reassemble the connector insert and the connector shell
(see Figure 1).
FIGURE 1. INSTALLATION OF PC 12 MATING CONNECTOR
TABLE 1. KEY POSITIONS AND ASSOCIATED OPERATOR MANUALS FOR PC 12
MODEL GROUP
OPERATOR MANUAL KEY
POSITION DOWNLOAD FROM KEPCO WEB SITE
ATE 1/4 Rack 28-30 www.kepcopower.com/support/opmanls.htm#ate
ATE 1/2 Rack 30-32 www.kepcopower.com/support/opmanls.htm#ate
ATE 3/4 Rack 30-32 www.kepcopower.com/support/opmanls.htm#ate
ATE FULL Rack 30-32 www.kepcopower.com/support/opmanls.htm#ate
BOP 100W, 200W, 400W 34-36 www.kepcopower.com/support/opmanls.htm#bop
2228-0818 REV 1 110918
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000FAX (718) 767-1102
http://www.kepcopower.com email: hq@kepcopower.com
III — Mechanical Outline Drawing
See Figure 2 for mechanical outline dimensions.
FIGURE 2. MECHANICAL OUTLINE DRAWING, MODEL PC 12
Table des matières
Autres manuels KEPCO Câbles et connecteurs
