Kee safety Easi-Dec Anchor-Fix Manuel utilisateur
AF010
Issue 01
SAFETY AT THE HIGHEST LEVEL
Anchor-Fix.
Assembly Instructions
Easi-Dec Access Systems Ltd.,
Merlin House,
Blaydon Road,
Sandy
SG19 1RZ
Tel: +44 ( 0 ) 1767 691812
Fax: +44 ( 0 ) 1767 691802
Internet: www.easi-dec.com
Copyright © 2012 Kee Safety Ltd. All rights reserved.
AF010
Issue 01
PLEASE BE ADVISED: Before assembling the Anchor-Fix for the first time, it is highly recommended
that Installers familiarise themselves with the component parts and carry out a test assembly and
disassembly in a safe area away from the point of final installation. All component parts detailed in the
operating instructions must be used in the assembly of the system. Should a piece be missing or
appear defective do not continue to assemble and contact Easi-Dec Immediately.
Step1 Step 2
Lay out the components ready for assembly.
Tie the strap around the footing Ladder stile and the third rung of the
Ladder.
Step 3 Step 4
Repeat STEP 2 for the second strap; tie the strap around the third
rung and the footing Ladder stile.
Slacken the bolts on the Anchor fixing housing.
Step 5 Step 6
Position the Footing Ladder into the anchor fixing housing.
Tighten the bolts from the anchor fixing housing with the wing nuts
provided; make sure the Ladder feet are firmly seated.
AF010
Issue 01
Step 7 Step 8
Feed the tied footing Ladder strap through the ratchet buckle.
Feed the second tied footing Ladder strap through the second
ratchet buckle and then tension both straps making sure the
Ladder is vertical when under tension.
Step 9
Foot the Ladder or use a suitable Ladder safety device, such as
Easi-Dec Ladder spurs before using.
Remember
Always check the equipment for damage before use.
Work carefully –Never rush.
Do not use in adverse weather conditions.
Always Tie the Ladder to the building.
Always erect using the 4:1 rule.
Dismantle: Reverse the above procedure.
Table des matières
Autres manuels Kee safety Capteur de sécurité
