Kaufmann PRO2000 Manuel du système

OWNER’S MANUAL & OPERATING INSTRUCTIONS

PRO2000

LED RECHARGEABLE SPOTLIGHT

READ AND FOLLOW ALL

WARNINGS AND INSTRUCTIONS IN

THIS MANUAL TO AVOID PERSONAL

INJURY OR PROPERTY DAMAGE.

WARNING

TO PREVENT DAMAGE TO EYESIGHT,

NEVER LOOK INTO LIGHT WHEN

LIGHT IS ON. DO NOT SHINE LIGHT

INTO THE FACE OF SOMEONE ELSE.

WARNING

V0700102

IMPORTANT SAFETY WARNINGS

READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL

BEFORE OPERATING SPOTLIGHT.

WARNING

tNever place spotlight face down when light is on or is still hot from recent use. Doing so could burn/

ignite surfaces such as seats, carpeting, etc. and cause major property damage. Always turn spotlight

off when not in use.

tAlways unplug charger from light and power source when not in use.

tTo prevent serious damage to eyesight, never look into light when light is on. DO NOT shine light into

the face of someone else.

tDO NOT touch lens of spotlight when light is on or if it was recently on. The lens will be hot and could

cause serious burns.

tDO NOT allow children to handle or operate this spotlight.

tDO NOT use this product for other than its intended use.

tDO NOT charge or operate in close proximity of combustible or ﬂammable materials.

tDO NOT charge battery in gas tight enclosures.

tDO NOT attempt to charge battery pack using both AC and DC chargers at the same time.

tDO NOT attempt to charge or operate this spotlight if cord, plug, battery, bulb or any part of the

spotlight is damaged or corroded.

tDO NOT use an outdoor AC outlet to recharge battery.

tTo prevent accidental electrical shock we recommend this product always be charged on a GFCI

(Ground FaultCircuit Interrupter) outlet.

tOnly use charging devices that are provided with the Rechargeable LED Spotlight or its

replacements.

tDO NOT disassemble or tamper with the battery.

tDO NOT dispose of battery in ﬁre as this may result in explosion.

USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR RECHARGEABLE LIGHT.

FAILURE TO ADHERE TO THE SAFETY WARNINGS AND GUIDELINES IN THIS MANUAL

COULD RESULT IN BODILY INJURY OR PROPERTY DAMAGE.

SAVE THIS MANUAL FOR FUTURE REFERENCE.

OPERATING INSTRUCTIONS

READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL

BEFORE OPERATING SPOTLIGHT.

Part List:

To Operate

IMPORTANT: Turn spotlight OFF before charging from

AC outlet. Leaving spotlight ON during charging may cause

damage to battery

12~24-volt DC charger/adapter operates from a DC receptacle

Step 1:

Step 2: Press trigger switch in handle once to turn spotlight ON.

Press switch again to cycle through High, Low and S.O.S.

modes. Press trigger switch again to turn spotlight OFF.

WARNING: Never place spotlight face down when light is on or

is still hot from recent use. Doing so could burn/ignite

surfaces such as seats, carpeting, etc. and cause

major property damage. Always turn spotlight off

when not in use.

and AC charger.

PRO2000 Rainproof Rechargeable Spotlight

◆The main body is made of Aluminium,rubber,TPR,

PC and ABS materials.

◆Shatterproof aluminium head helps cooling fast.

◆PC reﬂector provides well-distributed beam.

◆1pc USA Cree XHP50.2 super bright LED.

◆Powered by 2pcs 18650 rechargeable

Lithium batteries(7.4V 2600mAh).

◆Waterproof (Floats on Water) and Dustproof

protection:IP66

Detachable Red & Green Filter Lenses

12~24-Volt DC Charger/Adapter(Output:DC 9V 1.5A)

100~240-Volt AC USB Charger(Output:DC 5V 1A)

Owner’s Manual

Draw-string Carrying / Storage Bag

120cm Micro USB cord

Follow charging instructions on next page of this manual and

allow battery to fully charge.

◆Detachable Filter Lens

◆Trigger Switch

◆Adjustable Bracket for

Hand Held or as a Stable Stand

Designed with a hanging nail hole

◆Charging Panel

◆A M8 nut for Mounting/Tripod

Inspect contents of the box to ensure all parts are included and undamaged

To Charge

Dual function LED indicators

-Charging indication

-Battery Status in 4 levels

Transparent tail cap -

Glows in the dark

Design with IC Chip Controlling the Battery

Saver and Safe Mode:Automatically/Intelligently

Reduces Brightness/Temperature after 5 Minutes/56 ℃

to Extend Run Time and Ensure Safety.

Step 1:

Step 2:

Step 3:

Plug the AC USB charger(Micro USB cord) or the designated DC charger/

adapter into corresponding charging port.

Make sure spotlight is off while charging with AC USB charger

(Micro USB cord).

Spotlight can operate while charging with the designated

DC charger/adapter.

Always allow battery to fully charge.

in use.

For best results leave Spotlight on trickle charge for an extra 1 hour after all

3 indicators have turned on.

Note:

Intellective Dual function LED indicators:

WARNING:

Recharge battery fully before ﬁrst use.

DO NOT leave battery uncharged for extended period (recharge the battery

every 6 months).

The normal charging time is about 5Hrs by AC USB home adapter

or about 4Hrs by DC 12~24V car charger (never charge longer than

12Hrs continuously).

same time. This will damage the battery and charger.

For DC Charger/Adapter- Battery charges / continuous working only

while vehicle engine is running.

When the spotlight is fully charged,lock the cap in place for rainproof purpose.

Never dismantle the battery parts.

AC USB Charger

(Micro USB cord)

DC Charger/Adapter

To Prevent Damage to Spotlight and Battery:

• Do not attempt to use spotlight while charging directly from AC

outlet. Doing so may cause damage to battery and AC charger.

• DO NOT attempt to charge battery using both AC and DC chargers at

the same time. This will damage the battery

Only use charging devices that are provided with the Rechargeable

LED Spotlight or its replacements.

• Do not allow battery to completely discharge. A dim light indicates a

low battery. Recharge battery as soon as possible after each use.

• Always keep the battery fully charged when not in use.

• For best results, fully charge battery after each use. This will prolong

•

the overall life of the battery.

WARNING:

A damaged battery can leak acid. Avoid contact with eyes

and skin. If contact occurs, ﬂush immediately with large

amounts of water. DO NOT ingest. If contact with eyes or

ingestion occurs, consult physician immediately.

To Replace DC Plug Fuse

Step 1: Disconnect spotlight from power source.

Step 2: Unscrew cap of DC plug and pull out of fuse.

Step 3: Pull fuse holder and fuse out of DC plug. Observe to see if

fuse is burned out.

Note:

Replace with new 5A fuse if fuse element is

missing or broken.

Step 4: Pull fuse out of fuse holder. Insert new fuse into holder.

Step 5: Insert fuse holder and fuse into DC plug.

Step 6: Screw cap onto DC plug.

DC Plug

DC Cap

DC Plug

DC Cap

Fuse

DC Cap

DC Plug Fuse Holder

V1.1

and chargers.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Kaufmann Mettre en lumière

Kaufmann

Kaufmann PRO4000 Manuel du système

Manuels Mettre en lumière populaires d'autres marques

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Manuel utilisateur

LIVARNO home

LIVARNO home 375304 2101 Instructions originales

Cameo

Cameo CLQS40WW Manuel utilisateur

Leviton

Leviton Ellipsoid 5/50 Manuel utilisateur

Monacor

Monacor img Stage Line PARL-56PDX/CR Manuel utilisateur

Vector

Vector SL3AKV Manuel utilisateur

Quantum

Quantum Q262 Manuel d'exploitation

Philips

Philips Vari-lite VL3015LT Manuel utilisateur

EUROSPOT

EUROSPOT C51 Manuel utilisateur

DTS

DTS MINI BRICK ARC Manuel utilisateur

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Manuel

ACME

ACME LED-MS350B Manuel utilisateur

EuroLite

EuroLite Akku flat light 1 Manuel utilisateur

Commercial Electric

Commercial Electric SPTM-1401 Manuel utilisateur

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Manuel utilisateur

Teknik

Teknik FLEXI Manuel utilisateur

Craftsman

Craftsman CMXLSB10 Manuel utilisateur

EuroLite

EuroLite LED SLS-144 UV Floor Spot Manuel utilisateur