Kasco C10 Manuel utilisateur
C-10 CONTROL PANEL INSTALLATION MANUAL 1
MOVING WATER FORWARD, SINCE 1968
Document version 2021.1.1
C-10
CONTROL
PANEL
Document number 824408
NEC 547
Approved
65RA E201720
Installation &
Operation
Manual
C-10 CONTROL PANEL INSTALLATION MANUAL 1
TABLE OF CONTENTS
Safety First�������������������������������������������������������������������������������������������������������������������������������1
Installation Instructions���������������������������������������������������������������������������������������������������������1
Operation & Maintenance �����������������������������������������������������������������������������������������������������2
Warranty ����������������������������������������������������������������������������������������������������������������������������������2
SAFETY FIRST
To ensure the safe operation and long life of your Kasco equipment, always take the following precautions:
• Always keep people and objects clear of the de-icer propeller when operating.
• Always disconnect the power before servicing or removing your de-icer.
• Always operate your Kasco de-icer in the water.Operating your de-icer dry (on shore or dock) can cause
damage to the seals or injure operator.
• Always mount your C-10 on a vertical surface and operate only with the cover closed.
• Never lift your Kasco de-icer or C-10 control by the power cable. This could damage the power cable and
make your de-icer or control unsafe to operate.
• Take all possible precautions around open water de-icing areas to ensure the safety of the public, such
as “Thin Ice” and/or “Open Water” signs, appropriate lighting, fencing or other safety measures as re-
quired in your area.
• There are certain conditions under which no circulator can prevent ice damage, such as ice that moves
due to wind or current, extremely cold weather where ice forms all the way to the bottom, and in some
cases, where the bottom water temperature is the same as ice (very shallow water).
• Eective operation can be somewhat restricted by too little bottom clearance.
INSTALLATION INSTRUCTIONS
This unit must be mounted on a vertical surface close enough to your power supply to allow at least a slight
slack in the power cord from the C-10. An 8-foot connected power cord is included.
Select the screw(s) with which to mount your C-10. You will need two for the mounting holes at the top of
the box and one for the mounting hole located at bottom of the C-10 box.
Important: Your C-10 is designed to operate only one Kasco de-icer. For the most accurate operation, avoid
placing your C-10 in direct sunlight and during the winter months, make sure it’s mounted above the snow
line. Allow enough slack to prevent strain on the plug while ensuring that it is fully connected.
Note: The C-10 control must acclimate to the outdoor ambient temperature for proper operation.
Allow at least 1 hour for the C-10 to adjust to ambient temperature.
C-10 CONTROL PANEL INSTALLATION MANUAL 2
OPERATION & MAINTENANCE
1. Plug the C-10 Power Cord into a properly grounded 120V outlet.
2. Set the temperature at which the de-icer will start running by rotating the thermostat dial to the arrow.
We recommend setting the activation temperature to 30°F. The C-10 works on temperature fall. When
the ambient air temperature reaches the set point on the thermostat, the de-icer will turn on. There is
a 2.5°F dierential, so when the temperature rises to 2.5°F above the set thermostat temperature, the
de-icer will power o.
3. Plug the INSTALLED Kasco De-Icer into the piggyback plug of the C-10.
Use the following guidelines and hints to assist in customizing your setting for local conditions.
• De-Icers create small localized currents the longer they run. Fewer and longer operation cycles will prove
to be more eective than more frequent and shorter operation cycles.
• Fresh water freezes at 32°F, salt water at 28°F, and brackish water will freeze somewhere in between,
depending on the salinity level.
• Once activated, the thermostat stays activated until the temperature rises the 2.5°F dierential, putting
the temperature above the freezing point. This minimizes ice formation when the temperature is hover-
ing near the freezing point.
• Daily observation of all de-icing installations increases the likelihood of catching any issues early. A
number of factors can increase freeze rates and cause de-icing results to vary, including wind, snow, and
colder temperatures.
WARRANTY
Kasco Marine, Inc. warrants the C-10 thermostat control to be free from defects in material and work-
manship under normal use and service. The Kasco Marine, Inc. obligation under this warranty is limited to
replacing free of charge any defective part within two (2) years from date of purchase.
Customer shall pay all shipping charges.
THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTIES EXPRESS OR IMPLIED, AND ANY OTHER OBLIGA-
TION OR LIABILITY WHATEVER ON THE PART OF KASCO MARINE, INC. AND IN NO EVENT SHALL KASCO
MARINE, INC. BE LIABLE FOR ANY SPECIAL OR CONSEQUENTIAL DAMAGES.
No warranty registration is required, only original purchase receipt is needed for limited warranty coverage.
Warranty is void: If thermostat is damaged by unauthorized tampering or improper use. For Kasco Parts or
accessories, contact your local dealer or call Kasco at (715) 262-4488.
715�262�4488
kascomarine�com | sales@kascomarine�com
QUESTIONS?
Back to Contents
Table des matières
Autres manuels Kasco Panneau de contrôle
