K-Tech ET98A Manuel utilisateur
-+
K-Tech ET98A Line Loss Indicator
ELEVATOR
COMMUNICATIONS
FAILURE
Machine Room
To Phone Company
(Twisted Shielded Wire)
Supplied by Contractor/
Phone Company
2 conductor wire
Min 18 ga.
Supplied by
Contractor
ET901A-OEMU-AM-3 ET901A-OEMU-AM-3
Elevator #1
Traveling
cable
Elevator #2—8
Traveling
cable
115V AC Power
converter
Output 12V DC,
UL Listed
FIRE PANEL—Elevators 1—8
OnOff
Audible Alarm—shutoff—optional
LED = 12VDC
Piezo = 12 VDC—
80DB minimum
Wire to display (12VDC output)
Min 18 ga.
Supplied by Contractor
-+
The ET98A Line Loss Indicator is an interface between the elevator phones and the lobby panel.
Wiring:
1. Bring signal wires from elevator phone to left-hand side of ET98A. Wires must be 16 - 20 gauge and are not polarity specific.
(Remove and save jumpers as needed.)
2. Only one Line Loss signal wire pair from a single phone can be connected to each Line terminal. To enable line loss detection for
each LINE# terminal used, remove the corresponding jumper. Note: the jumper for LINE#1 is intentionally missing since by
default at least one LINE is used. For single phone applications, please only use LINE#1.
3. Bring wires from ET98A output to Lobby panel. These are polarity sensitive. Positive (+), negative (-).
4. Mount the ET98-DB in the lobby panel.
5. Wire as shown in diagram (Observe polarity for Power, LED, and Buzzer.)
6. Plug in power cube to board and 110v outlet. Plug in battery backup.
Testing The ET98A:
1. With all phones hooked up and good phone lines, all LEDs should be green.
2. Remove the line loss connector from one phone, and the corresponding red light should begin flashing.
3. The buzzer should start sounding at 30 second intervals.
4. Flip the Buzzer switch (if equipped) in order to silence the buzzer; the LED should continue to flash.
5. Hook the line loss connector back to the phone, and the LED will stop flashing.
6. Repeat as necessary for the other phones.
Testing the phone:
1. Remove the phone line, AC power, and battery power.
2. Reconnect the AC power and battery. (It will say “Sure Phone power installed.”)
3. This starts a timer and will cause a fault at five minutes with no phone line connected.
4. To reset the unit, reconnect the phone line and do a test call.
Note: A quick test can be performed by disconnecting the phone line and attempting to make a call. The LED and Buzzer will activate momentarily.
K-Tech International 56 Ella Grasso Ave Torrington CT 06790
Tech Support: 1-800-993-9399 Fax: 860-489-4399
www.KTechOnline.com
BOK093 100517
ET98A Line Loss Indicator
Complete warranty and
repair information at:
www.KTechOnline.com
Table des matières
Autres manuels K-Tech Équipement d'enregistrement
Manuels Équipement d'enregistrement populaires d'autres marques
Strymon
Strymon NIGHTSKY Manuel utilisateur
Mitsubishi Electric
Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manuel utilisateur
Tews Technologies
Tews Technologies TPMC465 Manuel utilisateur
Honeywell
Honeywell Excel 50 Manuel utilisateur
SeaLevel
SeaLevel COMM+8.LPCI Manuel utilisateur
Arturia
Arturia AUDIOFUSE STUDIO Manuel utilisateur
