JVC NX-PN7 Manuel utilisateur

COMPACT COMPONENT SYSTEM

NX-PN7

INSTRUCTIONS

LVT1864-010A

[A]

English

cover_NX-PN7[A].fm Page 1 Wednesday, July 2, 2008 9:01 PM

G-1

Warnings, Cautions and Others

CAUTION

The button in any position does not

disconnect the mains line.

Disconnect the mains plug to shut the power off

completely (the STANDBY lamp goes off).

The MAINS plug or an appliance coupler is used

as the disconnect device, the disconnect device

shall remain readily operable.

• When the system is on standby, the STANDBY

lamp lights red.

• When the system is turned on, the STANDBY

lamp goes off.

The power can be remote controlled.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1. Do not remove screws, covers or cabinet.

2. Do not expose this appliance to rain or

moisture.

CAUTION

Battery shall not be exposed to excessive heat

such as sunshine, fire or the like.

CAUTION:

Excessive sound pressure from earphones or

headphones can cause hearing loss.

CAUTION

• Do not block the ventilation openings or

holes.

(If the ventilation openings or holes are

blocked by a newspaper or cloth, etc., the

heat may not be able to get out.)

• Do not place any naked flame sources, such

as lighted candles, on the apparatus.

• When discarding batteries, environmental

problems must be considered and local rules

or laws governing the disposal of these

batteries must be followed strictly.

• Do not expose this apparatus to rain,

moisture, dripping or splashing and that no

objects filled with liquids, such as vases, shall

be placed on the apparatus.

Caution: Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:

1. Front: No obstructions and open spacing.

2. Sides/Top/Back: No obstructions should be placed in the areas shown by the dimensions below.

3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a

stand with a height of 10 cm or more.

Side viewFront view

safety_NX-PN7[A].fm Page 1 Wednesday, July 2, 2008 9:02 PM

Contents

Introduction................................................. 2

Precautions .................................................................2

Getting Started............................................3

Connections................................................................4

Canceling the Display Demonstration .......................5

Basic Operations ......................................... 6

Main Unit ................................................................... 6

Remote Control ..........................................................8

Playing Back from iPod............................11

Connecting iPod Devices ......................................... 12

Operations ................................................................13

Listening to FM Broadcast.......................15

Playing Back from Other Equipment .....17

Connecting Other Equipment................................... 17

Operations ................................................................17

Setting the Clock and Timer....................18

Setting the Clock ...................................................... 18

Setting the Timer...................................................... 19

Troubleshooting ........................................21

Specifications.............................................22

NX-PN7[A].BOOK Page 1 Friday, July 4, 2008 4:11 PM

Introduction

Thank you for purchasing a JVC product.

Please read all instructions carefully before operation, to ensure your complete understanding and

to obtain the best possible performance from the unit.

Precautions

Installation

• Install in a place which is level, dry and neither too hot nor too cold—between 5°C and 35°C.

• Install the unit in a location with adequate ventilation to prevent internal heat buildup inside the

unit.

• Leave sufficient distance between the unit and the TV.

• Keep the unit away from the TV to avoid interference with TV.

Power Sources

• When unplugging the unit from the wall outlet, always pull on the plug, not the AC power cord.

Internal Heat

Others

• Should any metallic object or liquid fall into the unit, unplug the AC power cord and consult your

dealer before operating any further.

• If you are not going to operate the unit for an extended period of time, unplug the AC power cord

from the wall outlet.

If anything goes wrong, unplug the AC power cord and consult your dealer.

DO NOT install the unit in a location near heat sources, or in a place subject to direct

sunlight, excessive dust or vibration.

DO NOT handle the AC power cord with wet hands.

For safety, observe the following carefully:

• Make sure there is good ventilation around the unit. Poor ventilation could overheat

and damage the unit.

• DO NOT block the ventilation openings or holes. If they are blocked by a newspaper

or cloth, etc., the heat may not be able to get out.

DO NOT disassemble the unit since there are no user serviceable parts inside.

NX-PN7[A].BOOK Page 2 Friday, July 4, 2008 4:11 PM

Getting Started

Supplied Accessories

After unpacking, check to be sure that you have

all the following items. The number in

parentheses indicates the quantity of each piece

supplied.

• Remote control (1)

• Lithium coin battery CR2025 (1) (The battery

has been installed when shipped from the

factory.)

• AC power cord (1)

• AC adaptor (AA-R1001) (1)

• FM antenna (1)

If anything is missing, consult your dealer

immediately.

CAUTION:

To avoid risk of fire, and to prevent damage.

• Do not use AC adaptors except the supplied

AC adaptor.

• Do not use the supplied AC adaptor for other

equipment.

Prepare the Remote Control

When you use the remote control for the first

time, pull out the insulation sheet.

Replacing the battery in the remote control

Insert the battery into the remote control by

matching the polarity (+ and –) correctly.

• If the range or effectiveness of the remote

control decreases, replace the battery.

WARNINGS:

• Store the battery in a place where children

cannot reach. If a child accidentally swallows

the battery, consult a doctor immediately.

• Do not recharge, short, disassemble or heat

the battery or dispose of it in a fire. Doing any

of these things may cause the battery to give

off heat, crack, or start a fire.

• Do not leave the battery with other metallic

materials. Doing this may cause the battery to

give off heat, crack, or start a fire.

• When throwing away or saving the battery,

wrap it in tape and insulate; otherwise, the

battery may start to give off heat, crack, or

start a fire.

• Do not poke the battery with tweezers or

similar tools. Doing this may cause the battery

to give off heat, crack, or start a fire.

• Dispose of battery in the proper manner,

according to federal, state, and local

regulations.

In this manual, operations using the remote

control are mainly explained; however, you

can use the buttons and controls on the unit if

they have the same (or similar) name and

marks.

Insulation sheet

Front side

CAUTION:

Danger of explosion if battery is incorrectly

replaced.

Replace only with the same or equivalent

type.

Lithium coin battery

(product number:

CR2025)

Rear side

NX-PN7[A].BOOK Page 3 Friday, July 4, 2008 4:11 PM

Connections

Connecting the Antenna

NOTE:

Make sure the FM antenna does not touch any other terminals, connecting cords or the AC power

cord. Also, keep the antenna away from metallic parts of the unit, connecting cords, and the AC

power cord. This could cause poor reception.

Do not connect the AC power cord until all other connections have been made.

For better FM reception

Disconnect the supplied FM antenna, and

connect to an outdoor FM antenna using a 75 Ω

wire with coaxial type connector.

Left side

FM antenna (supplied):

Extend it so that you can obtain the best

reception.

Outdoor FM antenna

(not supplied)

FM 75 ΩCOAXIAL

terminal

(on the rear panel)

NX-PN7[A].BOOK Page 4 Friday, July 4, 2008 4:11 PM

Connecting the Video Cord to View a Video/Picture from iPod

When viewing a video/picture from your iPod on your TV, use a composite video cord (not

supplied) to connect the VIDEO OUT jack on the unit and the composite video input on your TV.

Connecting the Power Cord

Canceling the Display Demonstration

When you connect the AC power cord for the first time, the display demonstration starts

automatically.

• When you operate the unit, the display demonstration stops temporarily. If no operation is done

for 2 minutes, the unit starts the display demonstration again.

• To activate again, hold down DEMO until “DEMO ON” appears on the display.

• When the ECO mode is activated (P.9), the display demonstration does not function.

Buttons Function

On the Unit On the remote

Hold down until “DEMO OFF” appears on the display.

Video cord (not supplied)

Right side

DC IN

10.7 V 3A

Right side

To a wall outlet

Plug in the AC power cord

only after all connections are

complete.

AC adaptor

(supplied)

AC power cord

(supplied)

NX-PN7[A].BOOK Page 5 Friday, July 4, 2008 4:11 PM

Basic Operations

Main Unit

Operating on the Main Unit

Buttons Functions

Turns on or off (standby) the power.

Changes the color of the illumination bars. (P.10)

• For DEMO button, see page 5.

Activates Sound Turbo. (P.10)

Changes the source to FM or AUDIO IN

(P.17).

Display (P.7)

STANDBY lamp Remote control sensor

Dock A (P.12) Dock B (P.12)

Illumination bars (P.10)

FM AUDIO IN

NX-PN7[A].BOOK Page 6 Friday, July 4, 2008 4:11 PM

Display Information

• Changes the source to iPod /iPod . (P.13)

• Starts playback and pauses for iPod. (P.13)

• iPod (P.13):

Press: Reverse skip/forward skip

Hold down: Reverse search/forward search

• FM (P.15): Tunes in to a station.

Adjusts the volume level (VOL MIN/VOL 1 to VOL 29/VOL MAX).

Symbols Description

iPod Lights up when an iPod is connected to dock A.

iPod Lights up when an iPod is connected to dock B.

S.TURBO Lights up when Sound Turbo is activated. (P.10)

FM Lights up when FM is selected as the source.

TUNED Lights up when a station of sufficient signal strength is tuned in.

ST Lights up when FM stereo broadcast is received.

MONO Lights up when FM monaural reception mode is activated.

A.STBY • Lights up when Auto Standby is activated. (P.10)

• Flashes for about 3 minutes before Auto Standby turns off the unit. (P.10)

1/2/3 • Lights up when the Timer is set. (P.20)

• 1/2/3 icon flashes while the Timer is working.

SLEEP Lights up when the Sleep Timer is activated. (P.10)

Buttons Functions

NX-PN7[A].BOOK Page 7 Friday, July 4, 2008 4:11 PM

Using Headphones

Be sure to turn down the volume before connecting headphones.

• Connecting headphones will deactivate the speakers.

Remote Control

Operating on the Remote Control

Basic operations

Buttons Main functions

Turns on or off (standby) the power.

Right side

Stereo mini plug

Headphones (not supplied)

P.9

P.10

P.14

P.14, P.15

P.10

P.13, P.18, P.20

P.13, P.15, P.16

P.14, P.16, P.17 – 20

P.13, P.15, P.16,

P.18 – 20

P.10

P.18 – 20

NX-PN7[A].BOOK Page 8 Friday, July 4, 2008 4:11 PM

Autres manuels pour NX-PN7

Table des matières

Autres manuels JVC Système de haut-parleurs

Manuels Système de haut-parleurs populaires d'autres marques

LG NB4532B Manuel utilisateur

5Core

5Core Pro Series Manuel utilisateur

EAW

EAW MQV1394e Manuel utilisateur

Lynx

Lynx GXR-LA10A Manuel utilisateur

iLive

iLive ITB066B Manuel utilisateur

RDX

RDX QuickStation 4 Manuel utilisateur

Electro-Voice

Electro-Voice S-122 Manuel utilisateur

Sven

Sven SPS-619 GOLD Manuel utilisateur

Pioneer

Pioneer CS-7070 Manuel utilisateur

EAW

EAW UB82e Manuel utilisateur

Sondpex

Sondpex Active Speaker System and Digital Music... Manuel utilisateur

Marshall Amplification

Marshall Amplification AR-DM61-BT Manuel utilisateur

Yamaha

Yamaha NX-A01 - Speaker Sys Manuel utilisateur

SE Audiotechnik

SE Audiotechnik I-LINE Manuel utilisateur

Gemini

Gemini WRX-843 Series Manuel utilisateur

TCL

TCL 6100 Series Manuel utilisateur

JBL

JBL gto6506c Manuel utilisateur

Legacy

Legacy FOCUS SE Manuel utilisateur