10
Chapter 3: Wiring Diagram
3
Chapter 1: CUSTOMER INFORMATION
General Information on Safety
•Persons under the inuence of drugs and/or alcohol and/or other medicine that impairs their
reaction may not assemble, disassemble, install, put into operation, repair or operate the product.
•All conversions and modications of an installation/system must conform to the relevant safety
requirements. Work on the electrical equipment must be performed only by qualied, authorized
personnel and in accordance with the relevant safety requirements.
•In the event of malfunctioning and visible defects or irregularities, the product must be stopped,
switched o and the relevant master switches must be switched o.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionne-
ment.
FCC Part 15
* This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation
* You are cautioned that changes or modications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
European Union Regulatory Notice
This device bearing the CE marking is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC. This device complies with the following harmonized
European standards.
Safety: EN 60950-1:2006+A11:2009+A1:2010+A12:2011
EMC: ETSI EN30 1489-1 V1.9.2 2011-09; ETSI EN 301 489-3 V1.4.1 2002-08
Radio: ETSI EN 300 220-1 v2.4.1: 2012; ETSI EN 300 220-2 v2.4.1: 2012
The following CE marking is valid for EU harmonized telecommunications products.
Thank you for purchasing a JUUKO product.
READ ALL INSTRUCTIONS CAREFULLY BEFORE MOUNTING, INSTALLING AND CONFIGURATING
THE PRODUCT.
This manual includes general information concerning the operation of the radio remote control
transmitter.
Warning against electrical voltage
Warning against hazardous situation
Do not use in high humidity and heavy dust environment.
Protective pouch is highly suggested to use in high humidity and heavy dust environment.
Avoid using in acid and alkali environment.
Used Symbols and Denitions for Warnings
K1000
A
DC-
DC+
DC+
E.STOP
UP
DOWN
EAST
WEST
SOUTH
NORTH
1
2
3
4
HORN
N/A
N/A
N/A
Master output
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Power enable (DC-)
Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8
Y9
Y10
Y11
Y12
Y13
A
K808
DC-
DC+
DC+
E.STOP
Master Output
UP
DOWN
EAST
WEST
SOUTH
NORTH
1
2
1/2
HORN
N/A
-2S
-2S
-2S
-2S
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Power enable (DC-)
Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8
Y9
Y10
Y11
Y12
Y13
Y14
Y15
A
A
