Jura S8 Manuel utilisateur

S8 – Quick Reference Guide

These short instructions do not replace the ‘S8 Instructions for Use’.

Make sure you read and observe the safety information and war-

nings first in order to avoid hazards.

You can initiate the rinse operation manually at any time.

Precondition: The start screen is displayed.

TPlace one receptacle under the coffee spout and another

under the fine foam frother.

TTouch ‘ P ’.

‘Machine settings’

TMove your finger across the display until ‘Maintenance sta-

tus’ is displayed in the centre.

TTouch ‘Maintenance status’.

‘Clean’

TMove your finger across the display until ‘Rinse’ is displayed

in the centre.

TTouch ‘Rinse’ to start the rinse operation.

‘Machine is rinsing’

‘Milk system is being rinsed’

The rinse stops automatically. The start screen is displayed.

15 minutes after milk preparation, the milk system is automatically

rinsed. Therefore always place a receptacle under the milk system

after preparing milk.

Rinsing the machine

Automatic milk system

rinsing

S8 – Quick Reference Guide

To ensure that the milk system always works properly, you must

clean it daily when you have been preparing milk.

If the wrong cleaning agent is used, the machine could be damaged

and/or traces could be left behind in the water.

TUse only original JURA maintenance products.

EJURA milk system cleaner is available from specialised dealers.

ETo clean the milk system, use the container supplied.

Precondition: The start screen is displayed. ‘Clean the milk system’

is displayed.

TTouch ‘Clean the milk system’.

TTouch ‘Clean the milk system’ again.

TTouch ‘Start’.

TTouch ‘Start’ again.

‘Milk system cleaner’ / ‘Connect the milk tube’ / ‘Fresh water’

TRemove the milk pipe from the milk container or milk cooler.

TAdd milk system cleaner to the front part of the container

up to the bottom mark (indicated by 6).

TThen fill with water up to the upper mark.

TPlace the container under the fine foam frother.

TConnect the milk pipe to the container.

ETo connect the milk pipe to the container correctly, the pipe

must be fitted with a connector.

TTouch ‘Next’.

‘Milk system is being cleaned’

The operation is interrupted, ‘Fresh water’.

TRinse the container thoroughly and fill the front part with

fresh water up to the upper mark.

TPlace this under the fine foam frother and reconnect the

milk pipe to the container.

TTouch ‘Next’.

‘Milk system is being cleaned’

The operation stops automatically.

Cleaning the milk system

CAUTION

S8 – Quick Reference Guide

To make sure the professional fine foam frother works properly, and

in the interests of hygiene, it must be dismantled and rinsed daily if

you have been preparing milk.

TRemove the milk pipe and rinse it thoroughly under running

water.

TRemove the professional fine foam frother.

TDismantle the fine foam frother into its individual parts.

TRinse all the parts under running water. If there are severely

dried-on milk residues, firstly immerse the individual parts

in a solution of 250 ml cold water and 1 capful of JURA milk

system cleaner. Then rinse the parts thoroughly.

TRe-assemble the professional fine foam frother.

EEnsure that all individual parts are correctly and firmly con-

nected to ensure optimum operation of the professional fine

foam frother.

TRe-fit the fine foam frother on the milk system.

Dismantling and rinsing

the professional fine

foam frother

S8 – Quick Reference Guide

Your S8 no longer has to be descaled if you are using the CLARIS

Smart filter cartridge.

Precondition: The start screen is displayed.

TRemove and empty the water tank.

TFit the filter cartridge extension supplied on top of a CLARIS

Smart filter cartridge.

TInsert the filter cartridge with its extension into the water

tank.

TTurn the filter cartridge clockwise until it audibly clicks into

place.

TFill the water tank with fresh, cold water and reinsert the

tank.

EThe machine automatically detects that you have just inserted

the filter cartridge.

‘Saved’ appears briefly on the display.

‘Filter is being rinsed’, water flows directly into the drip tray.

Rinsing of the filter stops automatically.

‘Empty drip tray’

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

The start screen is displayed.

EIf the filter is active, this is indicated by a blue filter symbol at

the top of the display.

EOnce the filter cartridge stops working (depending on the

water hardness setting), the S8 will prompt you to change the

filter.

ECLARIS Smart filter cartridges are available from specialised

dealers.

Precondition: The start screen is displayed. ‘Change the filter’ is dis-

played.

TTouch ‘Change the filter’.

TTouch ‘Change the filter’ again.

‘Change filter’

TRemove and empty the water tank.

Inserting the filter

Changing the filter

S8 – Quick Reference Guide

TTurn the filter cartridge anticlockwise and remove it along

with the extension from the water tank.

TFit the filter cartridge extension on top of a new CLARIS

Smart filter cartridge.

TInsert the filter cartridge with its extension into the water

tank.

TTurn the filter cartridge clockwise until it audibly clicks into

place.

TFill the water tank with fresh, cold water and reinsert the

tank.

‘Saved’ appears briefly on the display. The machine has

automatically detected that you have just changed the filter

cartridge.

‘Filter is being rinsed’, water flows directly into the drip tray.

Rinsing of the filter stops automatically.

‘Empty drip tray’

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

The start screen is displayed.

EIf the filter is active, this is indicated by a blue filter symbol at

the top of the display.

After 180 preparations or 80 switch-on rinses, the S8 will prompt you

to clean it.

If the wrong cleaning agent is used, the machine could be damaged

and/or traces could be left behind in the water.

TUse only original JURA maintenance products.

EThe cleaning programme lasts approximately 20 minutes.

EDo not interrupt the cleaning programme. The quality of

cleaning will be impaired if you do so.

EJURA cleaning tablets are available from specialised dealers.

Precondition: The start screen is displayed. ‘Clean machine’ is dis-

played.

TTouch ‘Clean machine’.

‘Clean’

TTouch ‘Clean’.

Cleaning the machine

CAUTION

S8 – Quick Reference Guide

TTouch ‘Start’.

TTouch ‘Start’ again.

‘Empty coffee grounds container’

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

TPlace one receptacle under the coffee spout and another

under the fine foam frother.

TTouch ‘Next’.

‘Machine is being cleaned’ appears and water flows out of

the coffee spout and the fine foam frother.

The operation is interrupted, ‘Add cleaning tablet’.

TOpen the cover of the filler funnel for ground coffee.

TInsert a JURA cleaning tablet into the filler funnel.

TClose the cover of the filler funnel.

TTouch ‘Next’.

‘Machine is being cleaned’, water flows repeatedly out of the

coffee spout and the fine foam frother.

The operation stops automatically.

‘Empty coffee grounds container’

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

Cleaning is now complete. The start screen is displayed.

The S8 builds up deposits of limescale over time and automatically

prompts you to descale it when necessary. The degree of calcifica-

tion depends on the hardness of your water.

EIf you are using a CLARIS Smart filter cartridge, you will not be

prompted to descale.

If the descaling agent comes into contact with the skin or eyes, this

can cause irritation.

TAvoid contact with the skin or eyes.

TRinse off the descaling agent with clean water. Should you get

any descaling agent in your eye, see a doctor.

If the wrong descaling agent is used, the machine could be dama-

ged and/or traces could be left behind in the water.

TUse only original JURA maintenance products.

Descaling the machine

JCAUTION

CAUTION

S8 – Quick Reference Guide

If the descaling operation is interrupted, there may be damage to

the machine.

TAllow the descaling programme to run to the end.

If the descaling agent comes into contact with sensitive surfaces

(e.g. marble), damage cannot be ruled out.

TClean up any splashes immediately.

EThe descaling programme lasts approximately 45 minutes.

EJURA descaling tablets are available from specialised dealers.

Precondition: The start screen is displayed. ‘Decalcify machine’ is

displayed.

TTouch ‘Decalcify machine’.

‘Descale’

TTouch ‘Descale’.

TTouch ‘Start’.

TTouch ‘Start’ again.

‘Empty drip tray’

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

‘Pour descaling agent into water tank’

TRemove and empty the water tank.

TCompletely dissolve 3 JURA descaling tablets in a receptacle

holding 500 ml of water. This may take several minutes.

TPour the solution into the empty water tank and insert it

into the machine.

TPlace one receptacle under the coffee spout and another

under the fine foam frother.

TTouch ‘Next’.

‘Machine is being descaled’ appears and water flows out of

the fine foam frother repeatedly.

The operation is interrupted, ‘Empty drip tray’.

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

‘Fill water tank’

CAUTION

S8 – Quick Reference Guide

TRemove the water tank and rinse it thoroughly.

TFill the water tank with fresh, cold water and reinsert the

tank.

TPlace one receptacle under the coffee spout and another

under the fine foam frother.

TTouch ‘Next’.

‘Machine is being descaled’, the descaling operation is con-

tinued.

The operation is interrupted, ‘Empty drip tray’.

TEmpty the drip tray and coffee grounds container and put

them back into the machine.

Descaling is now complete. The start screen is displayed.

EIf the descaling operation stops unexpectedly, rinse the water

tank thoroughly.

Coffee beans may be covered with a slight oil film which remains on

the walls of the bean container. These traces may negatively affect

the coffee result. For this reason clean the bean container from time

to time.

Precondition: ‘Fill bean container’ is displayed.

TSwitch the machine off with the On/Off button Q.

TRemove the aroma preservation cover.

TClean the bean container with a soft, dry cloth.

TFill the bean container with coffee beans and close the

aroma preservation cover.

Limescale deposits may form in the water tank. To ensure correct

function of the machine, descale the water tank from time to time.

TRemove the water tank.

TIf you use a CLARIS Smart filter cartridge, remove this.

TCompletely fill the water tank and dissolve 3 JURA descaling

tablets in it.

TLeave the water tank with the descaling solution for several

hours (e.g. overnight).

TEmpty the water tank and rinse it thoroughly.

TIf you use a CLARIS Smart filter cartridge, insert this again.

TFill the water tank with fresh, cold water and reinsert the

tank.

Cleaning the bean

container

Descaling the water tank

S8_Kurz/en/201711

Autres manuels pour S8

Table des matières

Autres manuels Jura Cafetière

Jura

Jura IMPRESSA C5 Manuel utilisateur

Jura

Jura ENA 5 Manuel utilisateur

Jura

Jura Z6 Manuel utilisateur

Jura

Jura IMPRESSA XF50 Classic Guide de configuration

Jura

Jura GIGA 6 Manuel utilisateur

Jura

Jura IMPRESSA XS Manuel utilisateur

Jura

Jura IMPRESSA XJ9 Professional Manuel utilisateur

Jura

Jura IMPRESSA Z7 Manuel utilisateur

Jura

Jura Impressa TB-96 Mode d’emploi

Jura

Jura IMPRESSA E80 Manuel utilisateur

Jura

Jura IMPRESSA J9.3 One Touch TFT Manuel utilisateur

Jura

Jura IMPRESSA C5 Guide d'installation

Jura

Jura Impressa J6 Manuel utilisateur

Jura

Jura ENA 7 Manuel utilisateur

Jura

Jura Giga X3 Professional Manuel utilisateur

Jura

Jura ONO Manuel utilisateur

Jura

Jura SUBITO Manuel utilisateur

Jura

Jura IMPRESSA J9.3 One Touch TFT Manuel utilisateur

Jura

Jura E8 Manuel utilisateur

Jura

Jura IMPRESSA XF50 Classic Guide de configuration

Jura

Jura ENA 3 Manuel de l'opérateur

Jura

Jura Z6 One Touch TFT Manuel

Jura

Jura GIGA X3C Guide de configuration

Jura

Jura WE6 Professional Manuel

Manuels Cafetière populaires d'autres marques

Taurus

Taurus Livorno 6 Manuel utilisateur

Delta-q

Delta-q QUICK Manuel utilisateur

Bunn

Bunn LCA-1 Guide de dépannage

Black & Decker

Black & Decker BLACK DECKER HOME DE790 Instructions d'installation

Saeco

Saeco Vienna Plus Sup 018M Manuel utilisateur

DeLonghi

DeLonghi DC300 Manuel utilisateur

INCAPTO

INCAPTO BXCO1470E Manuel utilisateur

Bosch

Bosch TASSIMO finesse TAS16B Series Manuel utilisateur

Exido

Exido 245-072 Manuel utilisateur

Animo

Animo OptiVend Choco Manuel utilisateur

Siemens

Siemens TQ505DF Series Manuel utilisateur

DeLonghi

DeLonghi ECI341 Manuel utilisateur

Krups

Krups KT406511 Manuel utilisateur

Cimbali

Cimbali M32 Classic Manuel utilisateur

Philips

Philips HL3844N Manuel utilisateur

Bosch

Bosch TES 515 SERIES Manuel utilisateur

Tekmatix

Tekmatix TMFM - 65 Manuel utilisateur

Scarlett

Scarlett SC-CM33005 Manuel utilisateur