7
LINEAR or pH ANTILOG is selected) or less than 1.0 % (if DO
LINEAR is selected and RELAY/mA is set at %) or 0.10 ppm (if
DO LINEAR is selected and RELAY/mA is set at ppm) and that
the current output is disabled.
d.
H,L: ‐ One or both of these annunciators will be displayed if the
left side reading (LARGE FONT DISPLAY) triggered the
respective relay settings. The rightmost character will indicate
RELAY 1 if the display is pH or RELAY 3 if the display is DO The
leftmost character will indicate RELAY2 if the display is pH or
RELAY 4 If the display is DO If the display is DO the
annunciators will only indicate the unit selected at the
RELAY/mA option in the DO CALIBRATION page.
H:
High action relay and the relay is energized.
L:
Low action control and the relay is energized.
e.
LARGE FONT DISPLAY ‐ This reading uses the biggest font and
the reading here is the onl
one that will a
ec
the analo
out
ut. You can only select the DO or pH reading to be shown
here by changing the Transmitter Out
ut option.
f.
H,L: ‐ One or both of these annunciators will be displayed if the
left side reading (MEDIUM FONT DISPLAY) triggered the
respective relay settings. The rightmost character will indicate
RELAY 1 if the display is pH or RELAY 3 if the display is DO.
The leftmost character will indicate RELAY2 if the display is pH
or RELAY 4 If the display is DO. If the display is ORP the
annunciators will only indicate the unit selected at the
RELAY/mA option in the DO CALIBRATION page.
H:
High action relay and the relay is energized.
L:
Low action control and the relay is energized.
g.
MEDIUM FONT DISPLAY‐this is the secondary reading and
