USER MANUAL
JEFSUBPDW266-95
1100W SUBMERSIBLE WATER PUMP 230V
www.jeffersontools.com
4
SAFETY GUIDELINES
• Check that all equipment cables are secure, correctly insulated, free from damage, and protected against short circuit and overload before
connecting to the power supply. Do not use worn or damaged cables, plugs, sockets or other ttings.
• Ensure that the power supply matches voltage requirements specied on the equipment and that the plug is wired correctly and tted with
the correct fuse.
• If the electrical fuse blows, ensure it is replaced by an identical type of fuse with the same rating.
• Never pull or manoeuvre this equipment into position using the power cable (move using the handle).
• Ensure the power cable is kept away from heat, oil and sharp edges.
• We recommend that the equipment is connected directly to the power supply without the use of extension leads as the resulting voltage drop
can reduce motor and pump performance.
• Always disconnect the from the power source and remove any water from the pump before servicing, inspecting, maintaining, cleaning,
replacing or checking any parts.
• Do not carry the pump while it is connected to its power source.
• Do not use this appliance in potentially explosive environments or in the vicinity of ammable liquids or gases.
• Do not try to connect or disconnect to the power supply or operate the equipment with wet hands.
• Ensure the connection is made to earthed sockets which have been properly installed and tested according to local standards and regula-
tions.
• Ensure mains voltage and fuse meet the ratings stated in the technical data. Do not use extension cables with this equipment.
• Do not use the equipment to pump water from bodies of water where people or animals are present (eg. swimming pools, sh ponds etc.)
• When not in use, the pump should be stored in dry place. Keep out of reach of children. Keep children and animals away from the work area.
• Watch what you are doing and remove any potential distractions before use. Use common sense at all times.
• Do not operate this equipment when you are tired or if you are under the inuence of alcohol, drugs or medication that makes you drowsy.
• Keep all screws, bolts, and plates tightly mounted. Check regularly.
• If the equipment appears to be operating unusually, making strange noises, or otherwise appears defective, stop using it immediately and
arrange for repairs by a authorized service centre.
• Only use Jefferson approved replacement parts. Non-approved parts will void your warranty and can lead to malfunction and resulting
injuries. Genuine parts are available from Jefferson your dealer.
• Do not modify the equipment for any use other than which it was designed for by the manufacturer. Do not tamper with or attempt to adjust
the tank, pressure switch or safety valve. Never strap anything to the tank. Do not subject the tank to impact, vibration, heat, abrasion or
corrosive materials.
• Always contact an authorized service centre for advice on any repairs. Unauthorized modication may not only impair the equipment
performance but may also result in accident or injury to repair personnel who do not have the required knowledge and technical expertise to
perform the repair operations correctly.
• When the pump is not in use ensure that it is switched off, disconnected from the power supply and the air and all residual moisture drained
before putting into storage.
• This pump must be used in accordance with Health & safety, government, local authority, and water authority rules and regulations.
• Disconnect the pump from the mains power before changing accessories, servicing or performing any maintenance.
• Ensure that the pump is kept in good condition
• Only use for pumping water not exceeding 35ºc. Do not use in freezing temperatures.
• If the pump is used to pump water from a well, drain or deep receptacle, take adequate precautions to stop persons and animals falling in.
• Use the built-in handle to lower or raise the pump. it may be necessary to attach a suitable rope or pulley to the handle to assist when
operating at maximum depths.
• If the bed of the water container contains sludge, sand, gravel or mud etc, suspend the pump or place it on a raised base to operate above
the solid matter. Abrasive substances will reduce the working life of the pump, and invalidate your warranty if equipment damage is caused.
• In ood situations the user is responsible for ensuring that the appropriate risk assessments, back-up procedures, alarms etc are correctly
installed in case of pump failure.
• This pump is not designed for continuous use in a sh pond or similar water feature or display.
• Do not operate the pump if any parts are damaged or missing as this may cause failure and/or possible personal injury.
• Do not operate the pump out of water. the pump pick up area must be completely submerged during operation.
• Do not exceed the maximum submersible depth or any other rated specications (see equipment specications).
• Do not allow uncontrolled discharge of contaminated water which would pollute the environment.
