Jeckson Electric 47-1010-R Manuel utilisateur
1
Owner's Manual
WIRELESS REMOTE SWITCH
MODEL: 47-1010-R
FCC ID: ELY547-47-1010R IC 1492A-471010R
The WIRELESS REMOTE SWITCH for use with all electric appliances from your easy chair or
bedside. Safe and convenient with simple plug-in installation.
Instructions:
1. Connect the AC Input wires to an AC 120V Power Source. (During connecting, make sure
there is no AC power.)
2. Connect the Output Wires to the Input wires of the controlled device.
3. Install a 12 volt. battery into the transmitter.
4. Turn appliance ON, then control the appliance by simply pressing the ON or OFF button of
the transmitter.
Note:
1. Main switch of the electric appliance must be in the ON position prior to using the Remote
Control.
2. Wireless Remote Switch works up to 50’’(15.4m) away.
3. Wireless Remote Switch may be used to control most other electrical devices including
T.V.s, stereos and lamps.
CAUTION
1. For indoor use in dry areas only.
2. For use on electrical devices with 15amp resistive load or max Power 1000W inductive
load.
3. 120 volt AC supply.
2
WARNING
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Specifications
Input Rating…….……………………………………………………………………………………..AC 120V, 60Hz
Output Rating……………………………………………………..………………………………..…AC 120V, 60Hz
Resistive Load……………………………………………………………..………………………………….15A
Motor Load………………………………………………………………………………………………….1/3HP
Incandescent Lamp………………………………………………………………………………………….500W
T.V…………………………………………………………………………………………………………..400W
Operation Temperature…………………………………………………………………..………………….... 0 - 40℃
Storage Temperature ………………………………………………………………….…………………….-25 - 60℃
Safety Standard ………………………………………………..………….…………..…..………………...ETL/cETL
Dimensions ……………………………………..…………………………….…….………………99 x 67 x 53 (mm)
Weight …………………………………………………………………………….…………………….…….. .125 (g)
Table des matières
Autres manuels Jeckson Electric Télécommande
Manuels Télécommande populaires d'autres marques
Panasonic
Panasonic EUR7622KB0 Manuel utilisateur
Bang & Olufsen
Bang & Olufsen Beo4 Manuel utilisateur
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Manuel utilisateur
Multiplex
Multiplex PROFI TX 9 Manuel utilisateur
One Remote
One Remote RMB4 Manuel utilisateur
FUTABA
FUTABA 9ZAP - PART2 Manuel utilisateur
