MODELS
FUNCTIONAL FEATURES AND IDENTIFICATION OF THE EQUIPMENT
The operation of the motor with the gun (water outlet) in closed position is the
only difference among these models.
Models 6500 / 6800 - With the gun in closed position, the motor continues to
run normally, causing the water circulate in the pump interior. On these models,
the motor cannot run more than 3 minutes with the gun in closed position under
any circunstances. If this occurs, the seals will be damaged.
Models 6500 Stop Total / 6800 Stop Total - With the gun in closed position,
the motor switchs off automatically, but starts to operate normally once the trigger
is pulled. Anyway, on these models, it is not recommended to open and close the
gun at short intervals in order to avoid excessive motor overheat and high power
consumption (There is the identification "STOP TOTAL" on the front hood).
04
MODELS:
6800
6800 STOP TOTAL
STATEMENT OF LIMTED WARRANTY
MÁQUINAS AGRÍCOLAS JACTO S.A. - JACTO CLEANING warrants this
machine and agrees to repair and replace parts and components which, under
normal operation and wear, following the technical recommendations, show
DEFECTS IN MATERIAL OR WORKMANSHIP:
WARRANTY PERIOD:
- One (1) year from the sale date to the dealer's customers.
WARRANTY APPLICATION:
Jacto or its authorized representative shall honor this warranty, if any part
or component shows confirmed defect in workmanship.
IT SHALL BE UNDERSTOOD THAT THE REPLACEMENT OF COMPLETE
COMPONENTS, SUCH AS THE EQUIPMENT ITSELF OR THE GUN, SHALL ONLY
BE EXECUTED IN CASE THE DEFECT CANNOT BE REPAIRED BY REPLACING
PARTS OF SUCH COMPONENTS.
THIS WARRANTY SHALL BE NULL AND VOID IF:
- Installation is not made in accordance with the instructions of the operator's manual;
- Equipment is not used in accordance with the technical recommendations in the
OPERATOR'SMANUAL and IDENTIFICATION PLATE;
- The equipment has signs indicating use of wrenches orforce inthe pressure adjustment.
- Accessories not recommended by the manufacturer are used;
- Repairsare performed by unauthorized people;
- Unoriginal parts parts are used;
- Defects have resulted from lack of lubrication, cleaning or filter at the water or additive
suction inlet;
- Identification Plate is changed, damaged or lost;
- Misuse or failure to follow the manufacturer's recommendations;
- Damagesresulted from actionof regionalnatural agents. (For instance, breakof the head
due to water freezing in its inside, caused by low temperatures.);
- Use of products with neutral pH flowing inside the machine.
29
Important: In the case of the Stop Total machines, when finishing the use or
when the interval is long, the switch must be off to prevent other people from
pulling the trigger, thus running the machine again. This can cause accidents,
mainly with children.
MODELS:
6500
6500 STOP TOTAL
